Sulphur Kβ emission spectra reveal protonation states of aqueous sulfuric acid.
Ontology highlight
ABSTRACT:
SUBMITTER: Niskanen J
PROVIDER: S-EPMC4757876 | biostudies-other | 2016
REPOSITORIES: biostudies-other
Similar Datasets
Project description:In a case study on five homologous alpha-amylases we analyzed the properties of unfolded states as obtained from treatments with GndHCl and with elevated temperatures. In particular the wavelength of the tryptophan fluorescence emission peak (lambda(max)) is a valuable parameter to characterize properties of the unfolded state. In all cases with a typical red shift of the emission spectrum occurring during structural unfolding we observed a larger magnitude of this shift for GndHCl-induced unfolding as compared to thermal unfolding. Although a quantitative relation between aggregation and reduction of the unfolding induced red shifts cannot be given, our data indicate that protein aggregation contributes significantly to smaller magnitudes of red shifts as observed during thermal unfolding. In addition, other properties of the unfolded states, most probable structural compactness or simply differences in the conformational scrambling, also affect the magnitude of red shifts. For the irreversible unfolding alpha-amylases studied here, transition temperatures and magnitudes of red shifts are strongly depending on heating rates. Lower protein concentrations and smaller heating rates lead to larger red shifts upon thermal unfolding, indicating that under these conditions the protein aggregation is less pronounced.
| S-EPMC1440751 | biostudies-literature
Project description:PcyA, a ferredoxin-dependent bilin pigment reductase, catalyzes the site-specific reduction of the two vinyl groups of biliverdin (BV), producing phycocyanobilin. Previous neutron crystallography detected both the neutral BV and its protonated form (BVH+) in the wildtype (WT) PcyA-BV complex, and a nearby catalytic residue Asp105 was found to have two conformations (protonated and deprotonated). Semiempirical calculations have suggested that the protonation states of BV are reflected in the absorption spectrum of the WT PcyA-BV complex. In the previously determined absorption spectra of the PcyA D105N and I86D mutants, complexed with BV, a peak at 730 nm, observed in the WT, disappeared and increased, respectively. Here, we performed neutron crystallography and quantum chemical analysis of the D105N-BV and I86D-BV complexes to determine the protonation states of BV and the surrounding residues and study the correlation between the absorption spectra and protonation states around BV. Neutron structures elucidated that BV in the D105N mutant is in a neutral state, whereas that in the I86D mutant is dominantly in a protonated state. Glu76 and His88 showed different hydrogen bonding with surrounding residues compared with WT PcyA, further explaining why D105N and I86D have much lower activities for phycocyanobilin synthesis than the WT PcyA. Our quantum mechanics/molecular mechanics calculations of the absorption spectra showed that the spectral change in D105N arises from Glu76 deprotonation, consistent with the neutron structure. Collectively, our findings reveal more mechanistic details of bilin pigment biosynthesis.
| S-EPMC9800206 | biostudies-literature
Project description:Acid-base molecular clusters are an important stage in atmospheric new particle formation. While such clusters are most likely multicomponent in nature, there are very few reports on clusters consisting of multiple acid molecules and multiple base molecules. By applying state-of-the-art quantum chemical methods, we herein study electrically neutral (SA)1(MSA)1(base)0-2 clusters with base = ammonia (A), methylamine (MA), dimethylamine (DMA), trimethylamine (TMA) and ethylenediamine (EDA). The cluster structures are obtained using a funneling approach employing the ABCluster program, semiempirical PM7 calculations and ωB97X-D/6-31++G(d,p) calculations. The final binding free energies are calculated at the DLPNO-CCSD(T0)/aug-cc-pVTZ//ωB97X-D/6-31++G(d,p) level of theory using the quasi-harmonic approximation. Based on the calculated cluster geometries and thermochemistry (at 298.15 K and 1 atm), we find that the mixed (SA)1(MSA)1(base)1-2 clusters more resemble the (SA)2(base)1-2 clusters compared to the (MSA)2(base)1-2 clusters. Hence, some of the steric hindrance and lack of hydrogen bond capacity previously observed in the (MSA)2(base)1-2 clusters is diminished in the corresponding (SA)1(MSA)1(base)1-2 clusters. Cluster kinetics simulations reveal that the presence of an MSA molecule in the clusters enhances the cluster formation potential by up to a factor of 20. We find that the SA-MSA-DMA clusters have the highest cluster formation potential, and thus, this system should be further extended to larger sizes in future studies.
| S-EPMC9089749 | biostudies-literature
Project description:Sulfuric acid under different concentrations and with the addition of SO3 (fuming sulfuric acid) was studied as a reducing agent for the production of reduced graphene oxide (RGO). Three concentrations of sulfuric acid (1.5, 5, and 12 M), as well as 12 M with 30% SO3, were used. The reduction of graphene oxide increased with H2SO4 concentration as observed by Fourier-transformed infrared spectroscopy and X-ray photoelectron spectroscopy. It was observed that GO lost primarily epoxide functional groups from 40.4 to 9.7% and obtaining 69.8% carbon when using 12 M H2SO4, without leaving sulfur doping. Additionally, the appearance of hexagonal domain structures observed in transmission electron microscopy and analyzed by selected area electron diffraction patterns confirmed the improvement in graphitization. Although the addition of SO3 in H2SO4 improved the GO reduction with 74% carbon, as measured by XPS, the use of SO3 introduced sulfur doping of 1.3%. RGO produced with sulfuric acid was compared with a sample obtained via ultraviolet (UV) irradiation, a very common reduction route, by observing that the RGO produced with sulfuric acid had a higher C/O ratio than the material reduced by UV irradiation. This work showed that sulfuric acid can be used as a single-step reducing agent for RGO without sulfur contamination.
| S-EPMC7795585 | biostudies-literature
Project description:Graphene has shown enormous potential for innovation in various research fields. The current chemical approaches based on exfoliation of graphite via graphite oxide (GO) are potential for large-scale synthesis of graphene but suffer from high cost, great operation difficulties, and serious waste discharge. We report a facile preparation of graphene by rapid reduction and expansion exfoliation of sulfuric acid intercalated graphite oxide (SIGO) at temperature just above 100°C in ambient atmosphere, noting that SIGO is easily available as the immediate oxidation descendent of graphite in sulfuric acid. The oxygenic and hydric groups in SIGO are mainly removed through dehydration as catalyzed by the intercalated sulfuric acid (ISA). The resultant consists of mostly single layer graphene sheets with a mean diameter of 1.07??m after dispersion in DMF. This SIGO process is reductant free, easy operation, low-energy, environmental friendly and generates graphene with low oxygen content, less defect and high conductivity. The provided synthesis route from graphite to graphene via SIGO is compact and readily scalable.
| S-EPMC3853688 | biostudies-literature
Project description:The X-ray photoelectron spectra of the 2p, 3s and 3p levels of iron in oxidized Clostridium pasteurianum ferredoxin indicate that the eight iron atoms in the molecule are indistinguishable. Their magnetic state is indicated both by core polarization splitting of the 3s electrons, and by "shake-up' satellites on the 2p lines. Similar satellites are observed in the 2p lines of reduced Chromatium high-potential iron-sulphur proteins and oxidized spinach ferredoxin, indicating that there too the iron atoms are magnetic. The low observed magnetic susceptibility of these proteins is therefore due to spin-coupling between the iron atoms in the active centre.
| S-EPMC1165640 | biostudies-other
Project description:Several groups, including our own, have found molecular dynamics (MD) calculations to result in the size of the pore of an outer membrane bacterial porin, OmpF, to be reduced relative to its size in the x-ray crystal structure. At the narrowest portion of its pore, loop L3 was found to move toward the opposite face of the pore, resulting in decreasing the cross-section area by a factor of approximately 2. In an earlier work, we computed the protonation states of titratable residues for this system and obtained values different from those that had been used in previous MD simulations. Here, we show that MD simulations carried out with these recently computed protonation states accurately reproduce the cross-sectional area profile of the channel lumen in agreement with the x-ray structure. Our calculations include the investigation of the effect of assigning different protonation states to the one residue, D(127), whose protonation state could not be modeled in our earlier calculation. We found that both assumptions of charge states for D(127) reproduced the lumen size profile of the x-ray structure. We also found that the charged state of D(127) had a higher degree of hydration and it induced greater mobility of polar side chains in its vicinity, indicating that the apparent polarizability of the D(127) microenvironment is a function of the D(127) protonation state.
| S-EPMC1367011 | biostudies-literature
Project description:The corrosion behavior of mild steel in 0.1 M aqueous sulfuric acid medium has been studied using weight loss, potentiodynamic polarization measurements, quantum chemical calculations, and molecular dynamic simulations in the presence and absence of 4-methyl-4H-1,2,4-triazole-3-thiol and 2-mercaptonicotinic acid. Potentiodynamic measurements indicate that these compounds mostly act as mixed inhibitors due to their adsorption on the mild steel surface. The goal of the study was to use theoretical calculations to better understand the inhibition. Monte Carlo simulation was used to calculate the adsorption behavior of the studied molecules onto Fe (1 1 1) and Fe2O3 (1 1 1) surface. The molecules were also studied with the density functional theory (DFT), using the B3LYP functional in order to determine the relationship between the molecular structure and the corrosion inhibition behavior. More accurate adsorption energies between the studied molecules and iron or iron oxide were calculated by using DFT with periodic boundary conditions. The calculated theoretical parameters gave important assistance into the understanding the corrosion inhibition mechanism expressed by the molecules and are in full agreement with the experimental results.
| S-EPMC5609597 | biostudies-literature
Project description:Transformation of C5 furaldehydes to the corresponding C6 furaldehydes over a heterogeneous catalyst is a versatile but demanding reaction process. This report describes our discovery that Amberlyst-15, a conventional sulfuric functionalized resin, affords a 43.1% yield for 5-hydroxymethyl-2-furaldehyde (HMF) production with 57.5% selectivity via direct hydroxymethylation of 2-furaldehyde (furfural) with an aqueous formaldehyde reagent. This report is the first to describe an important achievement on the heterogeneous acid catalyst-assisted HMF production from furfural via direct hydroxymethylation in a batch reactor system. The Amberlyst-15 was also reusable and applicable for C5 furaldehyde upgrading of various types: furfuryl alcohol, furfurylamine, and furoic acid toward the corresponding C6 furaldehydes. Results show that a liquid flow system becomes an advanced tool for the continuous production of upgrading furaldehydes through a fixed Amberlyst-15 catalyst bed. Accordingly, the sulfuric functionalized resin-catalyzed direct hydroxymethylation of furaldehydes with aqueous formaldehyde in both batch and flow reactor systems is worthwhile and opens up new avenues for biomass transformations in particles, an important area of inedible biomass utilization.
| S-EPMC6644732 | biostudies-literature
Project description:Protein-protein interactions depend on a host of environmental factors. Local pH conditions influence the interactions through the protonation states of the ionizable residues that can change upon binding. In this work, we present a pH-sensitive docking approach, pHDock, that can sample side-chain protonation states of five ionizable residues (Asp, Glu, His, Tyr, Lys) on-the-fly during the docking simulation. pHDock produces successful local docking funnels in approximately half (79/161) the protein complexes, including 19 cases where standard RosettaDock fails. pHDock also performs better than the two control cases comprising docking at pH 7.0 or using fixed, predetermined protonation states. On average, the top-ranked pHDock structures have lower interface RMSDs and recover more native interface residue-residue contacts and hydrogen bonds compared to RosettaDock. Addition of backbone flexibility using a computationally-generated conformational ensemble further improves native contact and hydrogen bond recovery in the top-ranked structures. Although pHDock is designed to improve docking, it also successfully predicts a large pH-dependent binding affinity change in the Fc-FcRn complex, suggesting that it can be exploited to improve affinity predictions. The approaches in the study contribute to the goal of structural simulations of whole-cell protein-protein interactions including all the environmental factors, and they can be further expanded for pH-sensitive protein design.
| S-EPMC4263365 | biostudies-literature