Experimental Investigation of Temperature-Dependent Gilbert Damping in Permalloy Thin Films.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhao Y
PROVIDER: S-EPMC4785429 | biostudies-other | 2016 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:A magnetic material combining low losses and large perpendicular magnetic anisotropy (PMA) is still a missing brick in the magnonic and spintronic fields. We report here on the growth of ultrathin Bismuth doped Y3Fe5O12 (BiYIG) films on Gd3Ga5O12 (GGG) and substituted GGG (sGGG) (111) oriented substrates. A fine tuning of the PMA is obtained using both epitaxial strain and growth-induced anisotropies. Both spontaneously in-plane and out-of-plane magnetized thin films can be elaborated. Ferromagnetic Resonance (FMR) measurements demonstrate the high-dynamic quality of these BiYIG ultrathin films; PMA films with Gilbert damping values as low as 3?×?10-4 and FMR linewidth of 0.3?mT at 8?GHz are achieved even for films that do not exceed 30?nm in thickness. Moreover, we measure inverse spin hall effect (ISHE) on Pt/BiYIG stacks showing that the magnetic insulator's surface is transparent to spin current, making it appealing for spintronic applications.
| S-EPMC6105659 | biostudies-literature
Project description:The role of damping in the spin Seebeck effect (SSE) was studied experimentally for the first time. The experiments used Y3Fe5O12 (YIG)/Pt bilayered structures where the YIG films exhibit very similar structural and static magnetic properties but very different damping. The data show that a decrease in the damping gives rise to an increase in the SSE coefficient, which is qualitatively consistent with some of the theoretical models. This response also shows quasi-linear behavior, which was not predicted explicitly by previous studies. The data also indicate that the SSE coefficient shows no notable correlations with the enhanced damping due to spin pumping, which can be understood in the frame of two existing models.
| S-EPMC5384803 | biostudies-literature
Project description:PtSe2 has received substantial research attention because of its intriguing physical properties and potential practical applications. In this paper, we investigated the optical properties of bilayer and multilayer PtSe2 thin films through spectroscopic ellipsometry over a spectral range of 0.73-6.42 eV and at temperatures between 4.5 and 500 K. At room temperature, the spectra of refractive index exhibited several anomalous dispersion features below 1000 nm and approached a constant value in the near-infrared frequency range. The thermo-optic coefficients of bilayer and multilayer PtSe2 thin films were (4.31 ± 0.04) × 10-4/K and (-9.20 ± 0.03) × 10-4/K at a wavelength of 1200 nm. Analysis of the optical absorption spectrum at room temperature confirmed that bilayer PtSe2 thin films had an indirect band gap of approximately 0.75 ± 0.01 eV, whereas multilayer PtSe2 thin films exhibited semimetal behavior. The band gap of bilayer PtSe2 thin films increased to 0.83 ± 0.01 eV at 4.5 K because of the suppression of electron-phonon interactions. Furthermore, the frequency shifts of Raman-active Eg and A1g phonon modes of both thin films in the temperature range between 10 and 500 K accorded with the predictions of the anharmonic model. These results provide basic information for the technological development of PtSe2-based optoelectronic and photonic devices at various temperatures.
| S-EPMC7643157 | biostudies-literature
Project description:The NaMnF3 fluoride-perovskite has been found, theoretically, to be ferroelectric under epitaxial strain becoming a promising alternative to conventional oxides for multiferroic applications. Nevertheless, this fluoroperovskite has not been experimentally verified to be ferroelectric so far. Here we report signatures of room temperature ferroelectricity observed in perovskite NaMnF3 thin films grown on SrTiO3. Using piezoresponse force microscopy, we studied the evolution of ferroelectric polarization in response to external and built-in electric fields. Density functional theory calculations were also performed to help understand the strong competition between ferroelectric and paraelectric phases as well as the profound influences of strain. These results, together with the magnetic order previously reported in the same material, pave the way to future multiferroic and magnetoelectric investigations in fluoroperovskites.
| S-EPMC5543180 | biostudies-literature
Project description:Chiral magnets are promising materials for the realisation of high-density and low-power spintronic memory devices. For these future applications, a key requirement is the synthesis of appropriate materials in the form of thin films ordering well above room temperature. Driven by the Dzyaloshinskii-Moriya interaction, the cubic compound FeGe exhibits helimagnetism with a relatively high transition temperature of 278 K in bulk crystals. We demonstrate that this temperature can be enhanced significantly in thin films. Using x-ray scattering and ferromagnetic resonance techniques, we provide unambiguous experimental evidence for long-wavelength helimagnetic order at room temperature and magnetic properties similar to the bulk material. We obtain α intr = 0.0036 ± 0.0003 at 310 K for the intrinsic damping parameter. We probe the dynamics of the system by means of muon-spin rotation, indicating that the ground state is reached via a freezing out of slow dynamics. Our work paves the way towards the fabrication of thin films of chiral magnets that host certain spin whirls, so-called skyrmions, at room temperature and potentially offer integrability into modern electronics.
| S-EPMC5427977 | biostudies-literature
Project description:Ultra-thin films of low damping ferromagnetic insulators with perpendicular magnetic anisotropy have been identified as critical to advancing spin-based electronics by significantly reducing the threshold for current-induced magnetization switching while enabling new types of hybrid structures or devices. Here, we have developed a new class of ultra-thin spinel structure Li0.5Al1.0Fe1.5O4 (LAFO) films on MgGa2O4 (MGO) substrates with: 1) perpendicular magnetic anisotropy; 2) low magnetic damping and 3) the absence of degraded or magnetic dead layers. These films have been integrated with epitaxial Pt spin source layers to demonstrate record low magnetization switching currents and high spin-orbit torque efficiencies. These LAFO films on MGO thus combine all of the desirable properties of ferromagnetic insulators with perpendicular magnetic anisotropy, opening new possibilities for spin based electronics.
| S-EPMC10427713 | biostudies-literature
Project description:Understanding the crystallization process for chemical solution deposition (CSD) processed thin films is key in designing the fabrication strategy for obtaining high-quality devices. Here, an in situ sample environment is presented for studying the crystallization of CSD processed thin films under typical processing parameters using near-grazing-incidence synchrotron X-ray diffraction. Typically, the pyrolysis is performed in a rapid thermal processing (RTP) unit, where high heating rates, high temperatures and atmosphere control are the main control parameters. The presented in situ setup can reach heating rates of 20°C s-1 and sample surface temperatures of 1000°C, comparable with commercial RTP units. Three examples for lead-free ferroelectric thin films are presented to show the potential of the new experimental set-up: high temperature, for crystallization of highly textured Sr0.4Ba0.6Nb2O6 on a SrTiO3 (001) substrate, high heating rate, revealing polycrystalline BaTiO3, and atmosphere control with 25% CO2, for crystallization of BaTiO3. The signal is sufficient to study a single deposited layer (≥10 nm for the crystallized film) which then defines the interface between the substrate and thin film for the following layers. A protocol for processing the data is developed to account for a thermal shift of the entire setup, including the sample, to allow extraction of maximum information from the refinement, e.g. texture. The simplicity of the sample environment allows for the future development of even more advanced measurements during thin-film processing under non-ambient conditions.
| S-EPMC7467347 | biostudies-literature
Project description:Nanostructured WO3 represents a promising material for electrochromic and sensing devices. In this scenario, electrodeposition is a promising low-cost approach for careful production. The electrodeposition of tungsten oxide film from a peroxo-tungstic-acid (PTA) solution is investigated. WO3 is synthetized onto Indium doped Tin Oxide (ITO) substrates, in a variety of shapes, from a fragmentary, thin layer up to a thick continuous film. Samples were investigated by scanning electron (SEM) and atomic force microscopy (AFM), Rutherford backscattering spectrometry (RBS), X-ray Diffraction analysis (XRD), energy gap measurement. Electrodeposition current curves are compared with characterization results to model the growth process. Early stages of electrodeposition are characterized by a transient cathodic current revealing an instantaneous nucleation followed by a diffusion limited process. A quantitative analysis of W deposition rate and current at working electrode validates a microscopic model for WO3 electrodeposition driving the process towards nanostructured versus continuous WO3 film.
| S-EPMC7466470 | biostudies-literature
Project description:Amorphous chalcogenide thin films are widely studied due to their enhanced properties and extensive applications. Here, we have studied amorphous Ga-Sb-Se chalcogenide thin films prepared by magnetron co-sputtering, via laser ablation quadrupole ion trap time-of-flight mass spectrometry. Furthermore, the stoichiometry of the generated clusters was determined which gives information about individual species present in the plasma plume originating from the interaction of amorphous chalcogenides with high energy laser pulses. Seven different compositions of thin films (Ga content 7.6-31.7 at. %, Sb content 5.2-31.2 at. %, Se content 61.2-63.3 at. %) were studied and in each case about ~50 different clusters were identified in positive and ~20-30 clusters in negative ion mode. Assuming that polymers can influence the laser desorption (laser ablation) process, we have used parafilm as a material to reduce the destruction of the amorphous network structure and/or promote the laser ablation synthesis of heavier species from those of lower mass. In this case, many new and higher mass clusters were identified. The maximum number of (40) new clusters was detected for the Ga-Sb-Se thin film containing the highest amount of antimony (31.2 at. %). This approach opens new possibilities for laser desorption ionization/laser ablation study of other materials. Finally, for selected binary and ternary clusters, their structure was calculated by using density functional theory optimization procedure.
| S-EPMC6629872 | biostudies-literature
Project description:Solvent vapor annealing is as an effective and versatile alternative to thermal annealing to equilibrate and control the assembly of polymer chains in thin films. Here, we present scientific and practical aspects of the solvent vapor annealing method, including the discussion of such factors as non-equilibrium conformational states and chain dynamics in thin films in the presence of solvent. Homopolymer and block copolymer films have been used in model studies to evaluate the robustness and the reproducibility of the solvent vapor processing, as well as to assess polymer-solvent interactions under confinement. Advantages of utilizing a well-controlled solvent vapor environment, including practically interesting regimes of weakly saturated vapor leading to poorly swollen states, are discussed. Special focus is given to dual temperature control over the set-up instrumentation and to the potential of solvo-thermal annealing. The evaluated insights into annealing dynamics derived from the studies on block copolymer films can be applied to improve the processing of thin films of crystalline and conjugated polymers as well as polymer composite in confined geometries.
| S-EPMC6722758 | biostudies-literature