Crystal Quality and Light Output Power of GaN-Based LEDs Grown on Concave Patterned Sapphire Substrate.
Ontology highlight
ABSTRACT:
SUBMITTER: Wu YS
PROVIDER: S-EPMC5507034 | biostudies-other | 2015 Apr
REPOSITORIES: biostudies-other
Similar Datasets
Project description:We performed depth-resolved PL and Raman spectral mappings of a GaN-based LED structure grown on a patterned sapphire substrate (PSS). Our results showed that the Raman mapping in the PSS-GaN heterointerface and the PL mapping in the InxGa1-xN/GaN MQWs active layer are spatially correlated. Based on the 3D construction of E2(high) Raman peak intensity and frequency shift, V-shaped pits in the MQWs can be traced down to the dislocations originated in the cone tip area of PSS. Detail analysis of the PL peak distribution further revealed that the indium composition in the MQWs is related to the residual strain propagating from the PSS-GaN heterointerface toward the LED surface. Numerical simulation based on the indium composition distribution also led to a radiative recombination rate distribution that shows agreement with the experimental PL intensity distribution in the InxGa1-xN/GaN MQWs active layer.
| S-EPMC5371985 | biostudies-literature
Project description:Here we demonstrate high-brightness InGaN/GaN green light emitting diodes (LEDs) with in-situ low-temperature GaN (LT-GaN) nucleation layer (NL) and ex-situ sputtered AlN NL on 4-inch patterned sapphire substrate. Compared to green LEDs on LT-GaN (19?nm)/sapphire template, green LEDs on sputtered AlN (19?nm)/template has better crystal quality while larger in-plane compressive strain. As a result, the external quantum efficiency (EQE) of green LEDs on sputtered AlN (19?nm)/sapphire template is lower than that of green LEDs on LT-GaN (19?nm)/sapphire template due to strain-induced quantum-confined Stark effect (QCSE). We show that the in-plane compressive strain of green LEDs on sputtered AlN/sapphire templates can be manipulated by changing thickness of the sputtered AlN NL. As the thickness of sputtered AlN NL changes from 19?nm to 40?nm, the green LED on sputtered AlN (33?nm)/sapphire template exhibits the lowest in-plane compressive stress and the highest EQE. At 20?A/cm2, the EQE of 526?nm green LEDs on sputtered AlN (33?nm)/sapphire template is 36.4%, about 6.1% larger than that of the green LED on LT-GaN (19?nm)/sapphire template. Our experimental data suggest that high-efficiency green LEDs can be realized by growing InGaN/GaN multiple quantum wells (MQWs) on sputtered AlN/sapphire template with reduced in-plane compressive strain and improved crystal quality.
| S-EPMC6401382 | biostudies-literature
Project description:Low Al-composition p-GaN/Mg-doped Al0.25Ga0.75N/n(+)-GaN polarization-induced backward tunneling junction (PIBTJ) was grown by metal-organic chemical vapor deposition on sapphire substrate. A self-consistent solution of Poisson-Schrödinger equations combined with polarization-induced theory was used to model PIBTJ structure, energy band diagrams and free carrier concentrations distribution. The PIBTJ displays reliable and reproducible backward tunneling with a current density of 3?A/cm(2) at the reverse bias of -1?V. The absence of negative differential resistance behavior of PIBTJ at forward bias can mainly be attributed to the hole compensation centers, including C, H and O impurities, accumulated at the p-GaN/Mg-doped AlGaN heterointerface.
| S-EPMC4159626 | biostudies-literature
Project description:Label-free detection of biomolecules using localized surface plasmon resonance (LSPR) substrates is a highly attractive method for point-of-care (POC) testing. One of the remaining challenges to developing LSPR-based POC devices is to fabricate the LSPR substrates with large-scale, reproducible, and high-throughput. Herein, a fabrication strategy for wafer-scale LSPR substrates is demonstrated using reproducible, high-throughput techniques, such as nanoimprint lithography, wet-etching, and thin film deposition. A transparent sapphire wafer, on which SiO2-nanodot hard masks were formed via nanoimprint lithography, was anisotropically etched by a mixed solution of H2SO4 and H3PO4, resulting in a patterned sapphire substrate (PSS). An LSPR substrate was finally fabricated by oblique deposition of Au onto the PSS, which was then applied to label-free detection of the binding events of biomolecules. To the best of our knowledge, this paper is the first report on the application of the PSS used as an LSPR template by obliquely depositing a metal.
| S-EPMC8946711 | biostudies-literature
Project description:Non-polar (11-20) GaN with significantly improved crystal quality has been achieved by means of overgrowth on regularly arrayed micro-rod templates on sapphire in comparison with standard non-polar GaN grown without any patterning processes on sapphire. Our overgrown GaN shows massively reduced linewidth of X-ray rocking curves with typical values of 270?arcsec along the [0001] direction and 380?arcsec along the [1-100] direction, which are among the best reports. Detailed X-ray measurements have been performed in order to investigate strain relaxation and in-plane strain distribution. The study has been compared with the standard non-polar GaN grown without any patterning processes and an extra non-polar GaN sample overgrown on a standard stripe-patterned template. The standard non-polar GaN grown without involving any patterning processes typically exhibits highly anisotropic in-plane strain distribution, while the overgrown GaN on our regularly arrayed micro-rod templates shows a highly isotropic in-plane strain distribution. Between them is the overgrown non-polar GaN on the stripe-patterned template. The results presented demonstrate the major advantages of using our regularly arrayed micro-rod templates for the overgrowth of non-polar GaN, leading to both high crystal quality and isotropic in-plane strain distribution, which is important for the further growth of any device structures.
| S-EPMC6028661 | biostudies-literature
Project description:GaN is one of the most promising materials for high PEC efficiency to produce clean, renewable hydrogen in an ecofriendly manner (Ebaid et al., 2015; Kamimura et al., 2017; Yang et al., 2018; Ohkawa et al., 2013). Trough assays of nanoporous gallium nitride (GaN) photoelectrode, we recently demonstrated an improved PEC efficiency and photocurrent density of nanoporous GaN photoelectrode by 470% times with respect to planar counterpart (Li et al., 2019). Here, we report original data acquired under UV-visible spectrometer, X-ray diffraction (XRD), room temperature PL measurements and PEC measurements, based on the characterization of different sapphire substrate, different GaN samples and different GaN photoelectrodes. The optical properties and photoelectrochemical properties of the corresponding samples and possible mechanisms are presented, which is freely available (Li et al., 2019). The data can be valuable for researchers interested in photoelectrochemical water splitting, as well as to researchers developing fabrication of nanoporous photoelectrode. For more insight please see the research article "A nanoporous GaN photoelectrode on patterned sapphire substrates for high-efficiency photoelectrochemical water splitting", https://doi.org/10.1016/j.jallcom.2019.06.234.
| S-EPMC6737298 | biostudies-literature
Project description:A novel overgrowth approach has been developed in order to create a multiple-facet structure consisting of only non-polar and semi-polar GaN facets without involving any c-plane facets, allowing the major drawbacks of utilising c-plane GaN for the growth of III-nitride optoelectronics to be eliminated. Such a multiple-facet structure can be achieved by means of overgrowth on non-polar GaN micro-rod arrays on r-plane sapphire. InGaN multiple quantum wells (MQWs) are then grown on the multiple-facet templates. Due to the different efficiencies of indium incorporation on non-polar and semi-polar GaN facets, multiple-colour InGaN/GaN MQWs have been obtained. Photoluminescence (PL) measurements have demonstrated that the multiple-colour emissions with a tunable intensity ratio of different wavelength emissions can be achieved simply through controlling the overgrowth conditions. Detailed cathodoluminescence measurements and excitation-power dependent PL measurements have been performed, further validating the approach of employing the multiple facet templates for the growth of multiple colour InGaN/GaN MQWs. It is worth highlighting that the approach potentially paves the way for the growth of monolithic phosphor-free white emitters in the future.
| S-EPMC6353934 | biostudies-literature
Project description:Infrared (IR) reflectance spectroscopy is applied to study Si-doped multilayer n+/n0/n+-GaN structure grown on GaN buffer with GaN-template/sapphire substrate. Analysis of the investigated structure by photo-etching, SEM, and SIMS methods showed the existence of the additional layer with the drastic difference in Si and O doping levels and located between the epitaxial GaN buffer and template. Simulation of the experimental reflectivity spectra was performed in a wide frequency range. It is shown that the modeling of IR reflectance spectrum using 2 × 2 transfer matrix method and including into analysis the additional layer make it possible to obtain the best fitting of the experimental spectrum, which follows in the evaluation of GaN layer thicknesses which are in good agreement with the SEM and SIMS data. Spectral dependence of plasmon-LO-phonon coupled modes for each GaN layer is obtained from the spectral dependence of dielectric of Si doping impurity, which is attributed to compensation effects by the acceptor states.
| S-EPMC5465006 | biostudies-other
Project description:We report on the defect states incorporated in a-plane GaN crystals grown on r-plane sapphire substrates by hydride vapor phase epitaxy (HVPE), using deep level transient spectroscopy (DLTS). Two defect states were observed at 0.2 eV and 0.55 eV below the conduction band minimum with defect densities of 5 × 1012/cm3 and 4.7 × 1013/cm3, respectively. The size of capture cross section, non-linear relation of trap densities from the depth profile, filling pulse width, and PL measurements indicated that the electronic deep trap levels in a-plane GaN on r-plane sapphire by HVPE originated from non-interacting point defects such as NGa, complex defects involving Si, O, or C, and VGa-related centres. Even though the a-plane GaN templates were grown by HVPE with high growth rates, the electronic deep trap characteristics are comparable to those of a-plane GaN layers of high crystal quality grown by MOCVD. This study prove that the growth of a-plane GaN templates on r-plane sapphire by HVPE is a promising method to obtain a-plane GaN layers efficiently and economically without the degradation of electrical characteristics.
| S-EPMC5959929 | biostudies-literature
Project description:In this study, a 3-μm-thick AlGaN film with an Al mole fraction of 10% was grown on a nanoscale-patterned sapphire substrate (NPSS) using hydride vapor phase epitaxy (HVPE). The growth mechanism, crystallization, and surface morphology of the epilayers were examined using X-ray diffraction, transmission electron microscopy (TEM), and scanning electron microscopy at various times in the growth process. The screw threading dislocation (TD) density of AlGaN-on-NPSS can improve to 1-2 × 10⁸ cm-2, which is significantly lower than that of the sample grown on a conventional planar sapphire substrate (7 × 10⁸ cm-2). TEM analysis indicated that these TDs do not subsequently propagate to the surface of the overgrown AlGaN layer, but bend or change directions in the region above the voids within the side faces of the patterned substrates, possibly because of the internal stress-relaxed morphologies of the AlGaN film. Hence, the laterally overgrown AlGaN films were obtained by HVPE, which can serve as a template for the growth of ultraviolet III-nitride optoelectronic devices.
| S-EPMC5553422 | biostudies-other