Hip, knee, and ankle kinematics during activities of daily living: a cross-sectional study.
Ontology highlight
ABSTRACT:
SUBMITTER: Hyodo K
PROVIDER: S-EPMC5537477 | biostudies-other | 2017 May - Jun
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Knee function is rarely measured objectively during functional tasks following total knee arthroplasty. Inertial measurement units (IMU) can measure knee kinematics and range of motion (ROM) during dynamic activities and offer an easy-to-use system for knee function assessment post total knee arthroplasty. However, IMU must be validated against gold standard three-dimensional optical motion capture systems (OMC) across a range of tasks if they are to see widespread uptake. We computed knee rotations and ROM from commercial IMU sensor measurements during walking, squatting, sit-to-stand, stair ascent, and stair descent in 21 patients one-year post total knee arthroplasty using two methods: direct computation using segment orientations (r_IMU), and an IMU-driven iCloud-based interactive lower limb model (m_IMU). This cross-sectional study compared computed knee angles and ROM to a gold-standard OMC and inverse kinematics method using Pearson's correlation coefficient (R) and root-mean-square-differences (RMSD). The r_IMU and m_IMU methods estimated sagittal plane knee angles with excellent correlation (>0.95) compared to OMC for walking, squatting, sit-to-stand, and stair-ascent, and very good correlation (>0.90) for stair descent. For squatting, sit-to-stand, and walking, the mean RMSD for r_IMU and m_IMU compared to OMC were <4 degrees, < 5 degrees, and <6 degrees, respectively but higher for stair ascent and descent (~12 degrees). Frontal and transverse plane knee kinematics estimated using r_IMU and m_IMU showed poor to moderate correlation compared to OMC. There were no differences in ROM measurements during squatting, sit-to-stand, and walking across the two methods. Thus, IMUs can measure sagittal plane knee angles and ROM with high accuracy for a variety of tasks and may be a useful in-clinic tool for objective assessment of knee function following total knee arthroplasty.
| S-EPMC10868843 | biostudies-literature
Project description:It is critical to distinguish gait compensations from true abnormalities when planning interventions to improve gait in individuals with neuromuscular disorders.The aim of this study was to determine the effect of isolated ankle equinus on knee kinematics during the initial contact phase of gait.Ten healthy subjects (29?+?4.3 years) participated, and testing occurred in a motion analysis laboratory. This cross-sectional study investigated five gait conditions in each subject: shoe alone, shoe with unilateral ankle foot orthosis locked at neutral, 10°, 20°, and 30° of fixed ankle plantar flexion. Gait kinematics were recorded and calculated with 3D motion analysis. The difference between the shoe and each brace condition was analyzed by repeated-measures ANOVA. The primary outcome was knee flexion at initial contact.With greater than 10° simulated ankle equinus, the primary gait compensation pattern was increased knee flexion at initial contact. A significant degree of knee flexion occurred ranging from 7° to 22°.Our data suggests that observed knee flexion at initial contact may be a compensation pattern in individuals with >10° ankle equinus. However, in individuals with ?10° ankle equinus, observed knee flexion may represent a true gait deviation. This has clinical significance in the realm of cerebral palsy for treatment planning to improve gait.
| S-EPMC4733689 | biostudies-literature
Project description:Assistive devices (ADs) are products intended to overcome the difficulties produced by the reduction in mobility and grip strength entailed by ageing and different pathologies. Nevertheless, there is little information about the effect that the use of these devices produces on hand kinematics. Thus, the aim of this work is to quantify this effect through the comparison of kinematic parameters (mean posture, ROM, median velocity and peak velocity) while performing activities of daily living (ADL) using normal products and ADs. Twelve healthy right-handed subjects performed 11 ADL with normal products and with 17 ADs wearing an instrumented glove on their right hand, 16 joint angles being recorded. ADs significantly affected hand kinematics, although the joints affected differed according to the AD. Furthermore, some pattern effects were identified depending on the characteristics of the handle of the ADs, namely, handle thickening, addition of a handle to products that initially did not have one, extension of existing handles or addition of handles to apply higher torques. An overview of the effects of these design characteristics on hand kinematics is presented as a basis for the selection of the most suitable AD depending on the patient's impairments.
| S-EPMC6788441 | biostudies-literature
Project description:Linking hand kinematics and forearm muscle activity is a challenging and crucial problem for several domains, such as prosthetics, 3D modelling or rehabilitation. To advance in this relationship between hand kinematics and muscle activity, synchronised and well-defined data are needed. However, currently available datasets are scarce, and the presented tasks and data are often limited. This paper presents the KIN-MUS UJI Dataset that contains 572 recordings with anatomical angles and forearm muscle activity of 22 subjects while performing 26 representative activities of daily living. This dataset is, to our knowledge, the biggest currently available hand kinematics and muscle activity dataset to focus on goal-oriented actions. Data were recorded using a CyberGlove instrumented glove and surface EMG electrodes, both properly synchronised. Eighteen hand anatomical angles were obtained from the glove sensors by a validated calibration procedure. Surface EMG activity was recorded from seven representative forearm areas. The statistics verified that data were not affected by the experimental procedures and were similar to the data acquired under real-life conditions.
| S-EPMC6848200 | biostudies-literature
Project description:ObjectiveThe aim of the study was to investigate the effect of maximal strength training on postural sway after total hip arthroplasty, performed before and after a battery of physical performance tests that resemble daily living activities.DesignThis study is an exploratory study based on data from a 3-mo randomized controlled trial involving 54 total hip arthroplasty patients performing maximal strength training or conventional rehabilitation. At 3, 6, and 12 mos postoperatively, postural sway was evaluated in two gait tests; ie, one test before and one test after conducting a battery of physical performance tests.ResultsAt 3 mos postoperatively, postural sway in the test after was significantly higher for the conventional rehabilitation group than the maximal strength training group (P = 0.045); however, there was no between-group difference at the test before (P = 0.670). Postural sway was also significantly higher in the test after compared with the test before in the conventional rehabilitation group (P < 0.001). No difference was found between the test before and test after in the maximal strength training group (P = 0.713). At 6 and 12 mos postoperatively, there were no statistically significant within- or between-group differences in postural sway.ConclusionsIncreased muscular strength limits postural sway 3 mos postoperatively in total hip arthroplasty patients after a demanding battery of physical performance tests simulating daily living activities.
| S-EPMC7292493 | biostudies-literature
Project description:Osteoarthritis of the hip can result from mechanical factors, which can be studied using finite element (FE) analysis. FE studies of the hip often assume there is no significant loss of fluid pressurization in the articular cartilage during simulated activities and approximate the material as incompressible and elastic. This study examined the conditions under which interstitial fluid load support remains sustained during physiological motions, as well as the role of the labrum in maintaining fluid load support and the effect of its presence on the solid phase of the surrounding cartilage. We found that dynamic motions of gait and squatting maintained consistent fluid load support between cycles, while static single-leg stance experienced slight fluid depressurization with significant reduction of solid phase stress and strain. Presence of the labrum did not significantly influence fluid load support within the articular cartilage, but prevented deformation at the cartilage edge, leading to lower stress and strain conditions in the cartilage. A morphologically accurate representation of collagen fibril orientation through the thickness of the articular cartilage was not necessary to predict fluid load support. However, comparison with simplified fibril reinforcement underscored the physiological importance. The results of this study demonstrate that an elastic incompressible material approximation is reasonable for modeling a limited number of cyclic motions of gait and squatting without significant loss of accuracy, but is not appropriate for static motions or numerous repeated motions. Additionally, effects seen from removal of the labrum motivate evaluation of labral reattachment strategies in the context of labral repair.
| S-EPMC5815394 | biostudies-literature
Project description:Despite significant advances in scaffold design, manufacture, and development, it remains unclear what forces these scaffolds must withstand when implanted into the heavily loaded environment of the knee joint. The objective of this study was to fully quantify the dynamic contact mechanics across the tibial plateau of the human knee joint during gait and stair climbing. Our model consisted of a modified Stanmore knee simulator (to apply multi-directional dynamic forces), a two-camera motion capture system (to record joint kinematics), an electronic sensor (to record contact stresses on the tibial plateau), and a suite of post-processing algorithms. During gait, peak contact stresses on the medial plateau occurred in areas of cartilage-cartilage contact; while during stair climb, peak contact stresses were located in the posterior aspect of the plateau, under the meniscus. On the lateral plateau, during gait and in early stair-climb, peak contact stresses occurred under the meniscus, while in late stair-climb, peak contact stresses were experienced in the zone of cartilage-cartilage contact. At 45% of the gait cycle, and 20% and 48% of the stair-climb cycle, peak stresses were simultaneously experienced on both the medial and lateral compartment, suggesting that these phases of loading warrant particular consideration in any simulation intended to evaluate scaffold performance. Our study suggests that in order to design a scaffold capable of restoring 'normal' contact mechanics to the injured knees, the mechanics of the intended site of implantation should be taken into account in any pre-clinical testing regime.
| S-EPMC4024103 | biostudies-literature
Project description:Dual mobility hip implants have been widely introduced to overcome dislocation in recent years. However, the potential influence of different gaits on kinematics and contact mechanics for dual mobility hip implants is still unclear. Furthermore, a large range of motion coupling with the implant position, especially high inclination or anteversion angle, may result in poor kinematics and contact mechanics. A previously developed dynamic finite element method was adopted in this study to examine the kinematics and corresponding stability of dual mobility hip implants under different gaits coupling with different inclinations or anteversion angles. The results showed only inner relative sliding under knee-bending for dual mobility hip implants under moderate inclination and anteversion angles, whereas an anteversion angle of 25° induced both impingement and consequent relative sliding of the outer articulation. However, the impingement (between the stem neck and the liner inner rim) indeed happened under stair-climbing and sitting-down/stand-up as well as combined movements when inclination and anteversion angles were set as 45° and 0°, respectively, and this finally led to relative sliding at the outer articulation. A high inclination angle did not worsen both the impingement and related outer sliding compared to modest inclination and anteversion angles of the liner, but a high anteversion angle prolonged the period of both the impingement and the outer relative sliding. The extreme motions and high anteversion angles are hardly inevitable, and they indeed lead to motions at both articulations for dual mobility hip implants.
| S-EPMC7097768 | biostudies-literature
Project description:Essential tremor (ET), characterized primarily by postural and kinetic tremor, is typically measured in the clinic with subjective tremor rating scales. These ratings are often used to adjust medications and assess efficacy in clinical trials. However, tremor ratings require the presence of a clinician and do not necessarily capture tremor fluctuations throughout the day during activities of daily living (ADL).To evaluate the ability of motion sensors to discriminate tremor from voluntary posture and motion, classify tremor as postural or kinetic, and rate tremor severity during standardized tasks and non-standardized activities of daily living.Ten subjects with ET wore motion sensors on the index finger and performed standardized motor tasks from the Washington Heights-Inwood Genetic Study of Essential Tremor (WHIGET) tremor rating scale (wTRS) and non-standardized ADL tasks. Four movement disorder specialists independently rated video segments of the standardized tasks but not the ADL tasks. Quantitative features were extracted from the motion sensors and used to develop mathematical models for predicting rating scores from kinematic data.The quantitative motion features were highly correlated with wTRS ratings for postural (r = 0.90) and kinetic (r = 0.80) tremors. Mathematical models produced tremor ratings that correlated strongly with clinician ratings of the wTRS tasks (mean r = 0.80) and also produced ADL task ratings that correlated well with the most recent clinician wTRS ratings (mean r = 0.72).Recordings from motion sensors can be used to classify tremor as postural or kinetic and quantify tremor severity during both standardized and non-standardized activities.
| S-EPMC3137659 | biostudies-literature
Project description:ContextThe authors hypothesized that in people with hip-related groin pain, less static ankle dorsiflexion could lead to compensatory hip adduction and contralateral pelvic drop during step-down. Ankle dorsiflexion may be a modifiable factor to improve ability in those with hip-related groin pain to decrease hip/pelvic motion during functional tasks and improve function.ObjectiveTo determine whether smaller static ankle dorsiflexion angles were associated with altered ankle, hip, and pelvis kinematics during step-down in people with hip-related groin pain.DesignCross-sectional Setting: Academic medical center.PatientsA total of 30 people with hip-related groin pain (12 males and 18 females; 28.7 [5.3] y) participated.InterventionNone.Main outcome measuresWeight-bearing static ankle dorsiflexion with knee flexed and knee extended were measured via digital inclinometer. Pelvis, hip, and ankle kinematics during forward step-down were measured via 3D motion capture. Static ankle dorsiflexion and kinematics were compared with bivariate correlations.ResultsSmaller static ankle dorsiflexion angles were associated with smaller ankle dorsiflexion angles during the step-down for both the knee flexed and knee extended static measures. Among the total sample, smaller static ankle dorsiflexion angle with knee flexed was associated with greater anterior pelvic tilt and greater contralateral pelvic drop during the step-down. Among only those who did not require a lowered step for safety, smaller static ankle dorsiflexion angles with knee flexed and knee extended were associated with greater anterior pelvic tilt, greater contralateral pelvic drop, and greater hip flexion.ConclusionsAmong those with hip-related groin pain, smaller static ankle dorsiflexion angles are associated with less ankle dorsiflexion motion and altered pelvis and hip kinematics during a step-down. Future research is needed to assess the effect of treating restricted ankle dorsiflexion on quality of motion and symptoms in patients with hip-related groin pain.
| S-EPMC8184886 | biostudies-literature