Dataset Information

A Microfluidic pH Measurement Device with a Flowing Liquid Junction.

ABSTRACT: The pH values of aqueous solutions are conventionally measured with pH-sensitive electrodes such as glass electrodes or ion-sensitive field-effect transistors (ISFETs) used in conjunction with Ag/AgCl reference electrodes and KCl solutions. The speed of pH measurement with these systems can be deficient, however, as the glass electrode responds slowly during measurements of sample solutions with low buffering capacities. Our group has constructed a new pH measurement system using a microfluidic device and ISFET sensors. The device has a channel with two inlets and one outlet, with a junction connected to a Y-shaped channel on the same plane. Two ISFET sensors and an Ag/AgCl pseudo reference electrode are fitted into the channel to construct a differential measurement device. A sample solution and baseline solution supplied into the inlets by gravity-driven pumps form a flowing liquid junction during measurement. The small size and fast response of the ISFET sensors enable measurement of about 2.0 mL of sample solution over a measurement period of 120 s. The 90% response time is within 2 s. The calibrated sensor signal exhibits a wide range (pH 1.68-10.0) of linearity with a correlation factor of 0.9997. The measurement error for all solutions tested, including diluted solutions, was 0.0343 ± 0.0974 pH (average error ± standard deviation (S.D.), n = 42). The new device developed in this research will serve as an innovative technology in the field of potentiometry.

SUBMITTER: Yamada A

PROVIDER: S-EPMC5539610 | biostudies-other | 2017 Jul

REPOSITORIES: biostudies-other

ACCESS DATA

Similar Datasets

Project description:Air compliance has been used effectively to stabilize fluidic instability resulting from a syringe pump. It has also been employed to measure blood viscosity under constant shearing flows. However, due to a longer time delay, it is difficult to quantify the aggregation of red blood cells (RBCs) or blood viscoelasticity. To quantify the mechanical properties of blood samples (blood viscosity, RBC aggregation, and viscoelasticity) effectively, it is necessary to quantify contributions of air compliance to dynamic blood flows in microfluidic channels. In this study, the effect of air compliance on measurement of blood mechanical properties was experimentally quantified with respect to the air cavity in two driving syringes. Under periodic on-off blood flows, three mechanical properties of blood samples were sequentially obtained by quantifying microscopic image intensity (<I>) and interface (?) in a co-flowing channel. Based on a differential equation derived with a fluid circuit model, the time constant was obtained by analyzing the temporal variations of ? = 1/(1-?). According to experimental results, the time constant significantly decreased by securing the air cavity in a reference fluid syringe (~0.1 mL). However, the time constant increased substantially by securing the air cavity in a blood sample syringe (~0.1 mL). Given that the air cavity in the blood sample syringe significantly contributed to delaying transient behaviors of blood flows, it hindered the quantification of RBC aggregation and blood viscoelasticity. In addition, it was impossible to obtain the viscosity and time constant when the blood flow rate was not available. Thus, to measure the three aforementioned mechanical properties of blood samples effectively, the air cavity in the blood sample syringe must be minimized (Vair, R = 0). Concerning the air cavity in the reference fluid syringe, it must be sufficiently secured about Vair, R = 0.1 mL for regulating fluidic instability because it does not affect dynamic blood flows.

Dataset Information

A Microfluidic pH Measurement Device with a Flowing Liquid Junction.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets