Dimensionality Effects in FeGe2 Nanowires: Enhanced Anisotropic Magnetization and Anomalous Electrical Transport.
Ontology highlight
ABSTRACT:
SUBMITTER: Tang S
PROVIDER: S-EPMC5541131 | biostudies-other | 2017 Aug
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Bacterial nanowires are extracellular appendages that have been suggested as pathways for electron transport in phylogenetically diverse microorganisms, including dissimilatory metal-reducing bacteria and photosynthetic cyanobacteria. However, there has been no evidence presented to demonstrate electron transport along the length of bacterial nanowires. Here we report electron transport measurements along individually addressed bacterial nanowires derived from electron-acceptor-limited cultures of the dissimilatory metal-reducing bacterium Shewanella oneidensis MR-1. Transport along the bacterial nanowires was independently evaluated by two techniques: (i) nanofabricated electrodes patterned on top of individual nanowires, and (ii) conducting probe atomic force microscopy at various points along a single nanowire bridging a metallic electrode and the conductive atomic force microscopy tip. The S. oneidensis MR-1 nanowires were found to be electrically conductive along micrometer-length scales with electron transport rates up to 10(9)/s at 100 mV of applied bias and a measured resistivity on the order of 1 ?·cm. Mutants deficient in genes for c-type decaheme cytochromes MtrC and OmcA produce appendages that are morphologically consistent with bacterial nanowires, but were found to be nonconductive. The measurements reported here allow for bacterial nanowires to serve as a viable microbial strategy for extracellular electron transport.
| S-EPMC2964190 | biostudies-literature
Project description:Metal-assisted chemical etching (MACE) has been widely explored for developing silicon (Si)-based energy and optical devices with its benefits for low-cost and large-area fabrication of Si nanostructures of high aspect ratios. Surface structures and properties of Si nanostructures fabricated through MACE are significantly affected by experimental and environmental conditions of etchings. Herein, we showed that surfaces and interfacial energy states of fabricated Si nanowires can be critically affected by oxidants of MACE etching solutions. Surfaces of fabricated Si nanowires are porous and their tips are fully covered with lots of Si nano-sized grains. Strongly increased photoluminescence (PL) intensities, compared to that of the crystalline Si substrate, are observed for MACE-fabricated Si nanowires due to interfacial energy states of Si and SiOx of Si nano-sized grains. These Si grains can be completely removed from the nanowires by an additional etching process of the anisotropic chemical etching (ACE) of Si to taper the nanowires and enhance light trapping of the nanowires. Compared with the MACE-fabricated Si nanowires, ACE-fabricated tapered Si nanowires have similar Raman and PL spectra to those of the crystalline Si substrate, indicating the successful removal of Si grains from the nanowire surfaces by the ACE process.
| S-EPMC6828753 | biostudies-literature
Project description:Although the various effects of strain on silicon are subject of intensive research since the 1950s the physical background of anomalous piezoresistive effects in Si nanowires (NWs) is still under debate. Recent investigations concur in that due to the high surface-to-volume ratio extrinsic surface related effects superimpose the intrinsic piezoresistive properties of nanostructures. To clarify this interplay of piezoresistive effects and stress related surface potential modifications, we explored a particular tensile straining device (TSD) with a monolithic embedded vapor-liquid-solid (VLS) grown Si NW. Integrating the suspended NW in a gate all around (GAA) field effect transistor (FET) configuration with a transparent gate stack enables optical and field modulated electrical characterization under high uniaxial tensile strain applied along the ?111? Si NW growth direction. A model based on stress-induced carrier mobility change and surface charge modulation is proposed to interpret the actual piezoresistive behavior of Si NWs. By controlling the nature and density of surface states via passivation the "true" piezoresistance of the NWs is found to be comparable with that of bulk Si. This demonstrates the indispensability of application-specific NW surface conditioning and the modulation capability of Si NWs properties for sensor applications.
| S-EPMC4358075 | biostudies-literature
Project description:We investigated the transport characteristics of a square shape superconducting Ta thin film under DC electrical current bias along the diagonal direction. The resistance parallel (R∥) and perpendicular (R⊥) to the DC current, IDC, is measured with various magnetic fields. R∥ and R⊥ show contrasting dependence on IDC. First, the critical current of R∥ is smaller than that of R⊥. Second, R⊥ shows an unexpected reduction at current bias where R∥ shows a rapid increase near the transition from a flux flow state to a normal state. The intriguing anisotropic transport characteristics can be understood by the inhomogeneous current density profile over the square sample. Diagonal DC current induces an anisotropic current density profile where the current density is high near the biasing electrode and low at the center of the sample. Accordingly, the electrical transport in the perpendicular direction could remain less affected even near the critical current of R∥, which leads to the higher critical current in R⊥. Complicated conduction profile may also allow the anomalous reduction in the R⊥ before finally shifting to the normal state.
| S-EPMC7546633 | biostudies-literature
Project description:Utilizing micromagnetic modeling, we have explained the unprobed characteristics of 360° full cycle in-plane magnetization rotation and the resulting propagation of a magnetization wave along a ferromagnet nanowire. The magnetization wave, which is generated by setting off spin oscillation at one end of a ferromagnetic strip, propagates till the end of the wire. A perpendicular spin torque oscillator (STO) could generate magnetization rotation at one end of the ferromagnetic strip that is also part of the STO. Our results demonstrate that the oscillation frequency of the spins along the wire maintains excellent fidelity while the spatial wavelength of the magnetic wave increases. The driving mechanism behind the propagation of the wave is found to be exchange-springs, which enables the propagation of the wave without the need for a 'carrier' force, such as spin-transfer torque (STT) or spin Hall effect (SHE). Furthermore, we demonstrate that the gradient of the exchange energy drives the magnetic wave forward, while the in and out of plane anisotropy fields govern the shape of spin oscillation trajectories along the wire. Additionally, we show that stopping the oscillation at the STO end causes the wave to cease propagation after relaxation, and altering the STO rotational chirality leads to merging and annihilating domain walls of opposite winding numbers.
| S-EPMC10439149 | biostudies-literature
Project description:The magnetic proximity effect (MPE) has recently been explored to manipulate interfacial properties of two-dimensional (2D) transition metal dichalcogenide (TMD)/ferromagnet heterostructures for use in spintronics and valleytronics. However, a full understanding of the MPE and its temperature and magnetic field evolution in these systems is lacking. In this study, the MPE has been probed in Pt/WS2/BPIO (biphase iron oxide, Fe3O4 and α-Fe2O3) heterostructures through a comprehensive investigation of their magnetic and transport properties using magnetometry, four-probe resistivity, and anomalous Hall effect (AHE) measurements. Density functional theory (DFT) calculations are performed to complement the experimental findings. We found that the presence of monolayer WS2 flakes reduces the magnetization of BPIO and hence the total magnetization of Pt/WS2/BPIO at T > ~120 K-the Verwey transition temperature of Fe3O4 (TV). However, an enhanced magnetization is achieved at T < TV. In the latter case, a comparative analysis of the transport properties of Pt/WS2/BPIO and Pt/BPIO from AHE measurements reveals ferromagnetic coupling at the WS2/BPIO interface. Our study forms the foundation for understanding MPE-mediated interfacial properties and paves a new pathway for designing 2D TMD/magnet heterostructures for applications in spintronics, opto-spincaloritronics, and valleytronics.
| S-EPMC9967397 | biostudies-literature
Project description:The field of spintronics involves the study of both spin and charge transport in solid-state devices. Ultrafast magnetism involves the use of femtosecond laser pulses to manipulate magnetic order on subpicosecond time scales. We unite these phenomena by using picosecond charge current pulses to rapidly excite conduction electrons in magnetic metals. We observe deterministic, repeatable ultrafast reversal of the magnetization of a GdFeCo thin film with a single sub-10-ps electrical pulse. The magnetization reverses in ~10 ps, which is more than one order of magnitude faster than any other electrically controlled magnetic switching, and demonstrates a fundamentally new electrical switching mechanism that does not require spin-polarized currents or spin-transfer/orbit torques. The energy density required for switching is low, projecting to only 4 fJ needed to switch a (20 nm)3 cell. This discovery introduces a new field of research into ultrafast charge current-driven spintronic phenomena and devices.
| S-EPMC5669611 | biostudies-literature
Project description:The interface effect is one of the most important factors that strongly affect the structural transformations and the properties of nano-/submicro-crystals under pressure. However, characterization of the granular boundary changes in materials is always challenging. Here, using tetrakaidecahedral Zn2SnO4 microcrystals as an example, we employed alternating current impedance, X-ray diffraction methods and transmission electron microscopy to elucidate the effect of the interface on the structure and electrical transport behavior of the Zn2SnO4 material under pressure. We clearly show that grain refinement of the initial microcrystals into nanocrystals (approximately 5 nm) occurs at above 12.5 GPa and is characterized by an anomalous resistance variation without a structural phase transition. A new phase transition pathway from the cubic to hexagonal structure occurs at approximately 29.8 GPa in Zn2SnO4. The unexpected grain refinement may explain the new structural transition in Zn2SnO4, which is different from the previous theoretical prediction. Our results provide new insights into the link between the structural transition, interface changes and electrical transport properties of Zn2SnO4.
| S-EPMC4585851 | biostudies-other
Project description:Magnetic nanowires, conceived as individual building blocks for spintronic devices, constitute a well-suited model to design and study magnetization reversal processes, or to tackle fundamental questions, such as the presence of topologically protected magnetization textures under particular conditions. Recently, a skyrmion-tube mediated magnetization reversal process was theoretically reported in diameter modulated cylindrical nanowires. In these nanowires, a vortex nucleates at the end of the segments with larger diameter and propagates, resulting in a first switching of the nanowire core magnetization at small fields. In this work, we show experimental evidence of the so-called Bloch skyrmion-tubes, using advanced Magnetic Force Microscopy modes to image the magnetization reversal process of FeCoCu diameter modulated nanowires. By monitoring the magnetic state of the nanowire during applied field sweeping, a detected drop of magnetic signal at a given critical field unveils the presence of a skyrmion-tube, due to mutually compensating stray field components. That evidences the presence of a skyrmion-tube as an intermediate stage during the magnetization reversal, whose presence is related to the geometrical dimensions of the cylindrical segments.
| S-EPMC8509997 | biostudies-literature
Project description:When a three-dimensional ferromagnetic topological insulator thin film is magnetized out-of-plane, conduction ideally occurs through dissipationless, one-dimensional (1D) chiral states that are characterized by a quantized, zero-field Hall conductance. The recent realization of this phenomenon, the quantum anomalous Hall effect, provides a conceptually new platform for studies of 1D transport, distinct from the traditionally studied quantum Hall effects that arise from Landau level formation. An important question arises in this context: how do these 1D edge states evolve as the magnetization is changed from out-of-plane to in-plane? We examine this question by studying the field-tilt-driven crossover from predominantly edge-state transport to diffusive transport in Crx(Bi,Sb)(2-x)Te3 thin films. This crossover manifests itself in a giant, electrically tunable anisotropic magnetoresistance that we explain by employing a Landauer-Büttiker formalism. Our methodology provides a powerful means of quantifying dissipative effects in temperature and chemical potential regimes far from perfect quantization.
| S-EPMC4507013 | biostudies-literature