Escherichia coli K-12 CIDETD
Ontology highlight
ABSTRACT:
INSTRUMENT(S): LTQ Orbitrap Velos
ORGANISM(S): Escherichia Coli K-12 (ncbitaxon:83333)
SUBMITTER: 
Xiaowen Liu Si Wu
PROVIDER: MSV000082237 | MassIVE | Wed Apr 04 07:54:00 BST 2018
REPOSITORIES: MassIVE
Similar Datasets
Project description:This is a top-down MS data set with 2 027 CID and 2 027 electron-transfer dissociation (ETD) MS/MS spectra from Escherichia coli (EC) K-12 MG1655. The EC sample was analyzed by a liquid chromatography system coupled with an LTQ Orbitrap Velos mass spectrometer. MS and MS/MS spectra were collected at a 60 000 resolution and the top 4 ions in each MS spectrum were selected for MS/MS analysis.
2018-02-13 | MSV000082064 | MassIVE
Project description:E. coli evolution to alternating substrate conditions
| PRJNA382354 | ENA
Project description:E. coli evolution to alternating substrate conditions
| PRJNA383408 | ENA
Project description:Recent advances in mass spectrometric (MS) instruments resulting in high mass resolution and high duty cycles have allowed of very deep coverage of proteomes. However, even with state of the art, high duty cycle instruments, the number of proteins identified with a conventional single liquid chromatography-tandem MS (LC/MS/MS) analysis is typically limited and fractionating protein samples prior to LC/MS/MS analysis is crucial for increasing both the analytical dynamic range and proteome coverage. In order to achieve near comprehensive identification of proteomes two-dimensional (2D) chromatography has been an invaluable tool. This first dimension is typically performed with µL/min flow and relatively large column inner diameters, which allow efficient pre-fractionation but typically require peptide amounts in the milligram range while the second dimension is typically performed with nL/min flow rates and capillary columns with small inner diameters. Typically, reverse phase liquid chromatography (RPLC) provides high peak resolution of peptides and achieves higher peak capacities than strong cation exchange chromatography (SCX) due to the faster chromatographic partitioning. Another advantage of RPLC is that the mobile phases used generate much cleaner samples for downstream analyses, while the incorporation of a desalting step for SCX in order to eliminated the high salt concentrations that can significantly decrease the analytical sensitivity of the MS analysis due to ionization problems. When operated at widely different pH values (e.g., 1st dimension pH 10 and 2nd dimension pH 3) 2D RPLC-RPLC provides separation orthogonality comparable to that of the combination of SCX-RPLC. The difference of separation selectivity between the low and high pH (HpH) RPLC comes from the changes in the charge distribution within peptide chains upon altering pH of the eluent. Herein we describe a method in which tryptic peptides are separated in the first dimension by HpH-RPLC and fractions are collected every 90 s over an 80 min gradient. For the second dimension, each of these fractions is individually run by the standard low pH RPLC method. The implementation of the HpH pre-fractionation allows for short second dimension gradients for bottom up LC/MS/MS and yields very deep (e.g. thousands of identifications) protein coverage at reasonable measurement time.
2018-04-23 | PXD009021 | Pride
Project description:E. coli proteins (300 ng) extracted from the sample were analyzed using an Orbitrap Fusion Lumos mass spectrometer (Thermo Fisher Scientific) coupled with an Ultimate 3000 (Thermo Fisher Scientific) reversed-phase liquid chromatography (RPLC) separation system with a C2 column (60 cm length, CoAnn Inc.). In the RPLC system, phase A was water with 0.1% formic acid (FA), and phase B was 60% acetonitrile (ACN) and 15% isopropanol (IPA) with 0.1% FA. A 98-min gradient of mobile phase B (0-5 min 5%, 5-7 min for 5% to 35%, 7-10 min for 35% to 50%, 10-97 min for 50% to 80%, 97-98 min from 80% to 99%) was applied with a flow rate of 400 nL/min.
E. coli proteins were analyzed using both DDA and DIA modes. In each mode, six runs were performed separately, with each targeting a specific m/z range within the MS1 scan: 720-800, 800-880, 880-960, 960-1040, 1040-1120, and 1120-1200 m/z. MS1 spectra were collected with a resolution of 240,000 (at 200 m/z), 4 microscans, an automatic gain control (AGC) target value of 1x106, and a maximum injection time of 200 ms. MS/MS spectra were obtained with a scan range of 400-2000 m/z, a resolution of 60,000 (at 200 m/z), 1 microscan, an AGC target value of 1x106, and a maximum injection time of 500 ms. Fragmentation was performed using higher-energy collisional dissociation (HCD) with 30% NCE. In the DDA runs, the top six precursor ions from each MS1 scan were isolated with a 3 m/z window for MS/MS analysis. The dynamic exclusion was set to 60 seconds. In the DIA runs, a 4 m/z isolation window was used, resulting in a total of 20 MS/MS spectra for each cycle. Three technical replicates were obtained for each experiment.
2024-03-26 | MSV000094407 | MassIVE
Project description:E. coli proteins (300 ng) extracted from the sample were analyzed using an Orbitrap Fusion Lumos mass spectrometer (Thermo Fisher Scientific) coupled with an Ultimate 3000 (Thermo Fisher Scientific) reversed-phase liquid chromatography (RPLC) separation system with a C2 column (60 cm length, CoAnn Inc.). In the RPLC system, phase A was water with 0.1% formic acid (FA), and phase B was 60% acetonitrile (ACN) and 15% isopropanol (IPA) with 0.1% FA. A 98-min gradient of mobile phase B (0-5 min 5%, 5-7 min for 5% to 35%, 7-10 min for 35% to 50%, 10-97 min for 50% to 80%, 97-98 min from 80% to 99%) was applied with a flow rate of 400 nL/min.
E. coli proteins were analyzed using both DDA and DIA modes. In each mode, six runs were performed separately, with each targeting a specific m/z range within the MS1 scan: 720-800, 800-880, 880-960, 960-1040, 1040-1120, and 1120-1200 m/z. MS1 spectra were collected with a resolution of 240,000 (at 200 m/z), 4 microscans, an automatic gain control (AGC) target value of 1x106, and a maximum injection time of 200 ms. MS/MS spectra were obtained with a scan range of 400-2000 m/z, a resolution of 60,000 (at 200 m/z), 1 microscan, an AGC target value of 1x106, and a maximum injection time of 500 ms. Fragmentation was performed using higher-energy collisional dissociation (HCD) with 30% NCE. In the DDA runs, the top six precursor ions from each MS1 scan were isolated with a 3 m/z window for MS/MS analysis. The dynamic exclusion was set to 60 seconds. In the DIA runs, a 4 m/z isolation window was used, resulting in a total of 20 MS/MS spectra for each cycle. Three technical replicates were obtained for each experiment.
2024-03-19 | MSV000094362 | MassIVE
Project description:Experimental design For the label-free proteome analysis 17 mice were used composed of 5 individual wildtype mice for each condition before (WTprePHE) and after hepatectomy (WTpostPHE). For the pre-hepatectomy condition four BIRC5-knockout mice (KOprePHE) were analyzed and three individuals after partial hepatectomy (KOpostPHE). For the LC-MS/MS analysis the samples were pre-fractionated by subcellular protein fractionatio. All samples corresponding to a subcellular fraction were analyzed in an individual label-free study. Subcellular protein fractionation The subcellular fractions were generated using the Subcellular Protein Fractionation Kit for Tissue (Thermo Scientific, Bremen, Germany). Sample preparation and tryptic digestion 5ug of protein were loaded on a 18% Tris-glycine acrylamide gel (Anamed Electrophorese, Grosz-Bieberau, Germany). The samples were allowed to run slightly into the gel (15 min, 100 V) and form a single band of approximately 3mm height. The bands were stained with Coomassie, manually cut from the gel and digested with trypsin (Serva Electrophoresis, Heidelberg, Germany) in 10 mM ammonium bicarbonate buffer (pH 7.8) overnight at 37 degrees C. LC-MS/MS Analysis The RPLC-MS/MS analysis was performed using an Ultimate 3000 RSLCnano system (Thermo Scientific, Bremen, Germany) online coupled to an Orbitrap Elite mass spectrometer (Thermo Scientific, Bremen, Germany). The injection volume was 15 ul of the sample, representing an amount of 250 ng peptides.The MS was operated in a data-dependent mode. Full scan MS spectra were acquired at a resolution of 60,000 in the Orbitrap analyzer, while tandem mass spectra of the twenty most abundant peaks were measured in the linear ion trap after peptide fragmentation by collision-induced dissociation (CID).
2014-05-22 | PXD000625 | Pride
Project description:De novo sequencing and expression of recombinant 1D3 antibody (R1D3). To achieve maximum coverage for antibody sequencing, 5 µg of the antibody original 1D3 was digested in parallel with five different proteases: trypsin, elastase, chymotrypsin, and Asp-N. For each digestion mixture, peptides were loaded onto a nanoflow C18 HPLC column, and peptides were resolved using an aqueous to organic gradient over the course of 90 minutes. As they eluted from the column, peptides were directly ionized on a Thermo Fisher Orbitrap orbitrap Velos mass spectrometer. In a data-dependent manner, both high-resolution full mass measurements and multiple different tandem mass fragmentation (MS/MS) modalities were collected to give the greatest likelihood of correct sequence interpretation. These include standard collision-induced dissociation (CID), higher-energy dissociation (HCD), and electron transfer dissociation (ETD).
After acquisition, data were transferred to Abterra Bioscience for analysis using their proprietary Valens platform. Briefly, an analysis of bottom-up mass spectra generated by the Vanderbilt University Proteomics facility using multiple enzymes was conducted. The framework sequence was identified by performing a database search of the spectra against the germline immunoglobulin gene sequences.
2022-09-25 | PXD036958 | JPOST Repository
Project description:High-resolution transcriptional profiling of E. coli across nine timepoints of growth in rich media (LB). Samples collected from lag phase to stationary phase of growth. High-resolution tiling array to detect conditional operon isoforms. Custom Agilent array designed to detect condition-specific transcriptional isoforms. Array designed for E coli K12 MG1655 genome. Tiled using 23bp sliding window. Includes >10,000 probes surrounding predicted operon break sites at 6 bp resolution.
2014-07-22 | GSE55879 | GEO
Project description:The two data sets were generated from SW480 and SW620 colorectal cancer (CRC) cells. Proteoforms extracted from the sample were analyzed using a Thermo Q-Exactive HF mass spectrometer coupled with a 105-minute nanoRPLC separation system. The top 5 precursor ions in each MS1 spectrum were selected from an isolation window of 4 m/z for MS/MS analysis using higher-energy collisional dissociation (HCD). Both MS1 and MS/MS spectra were acquired at a resolution of 120,000 (at 200 m/z). Three technical replicates were obtained.
2022-10-07 | MSV000090488 | MassIVE