Dataset Information

A combined three-dimensional in vitro-in silico approach to modelling bubble dynamics in decompression sickness.

ABSTRACT: The growth of bubbles within the body is widely believed to be the cause of decompression sickness (DCS). Dive computer algorithms that aim to prevent DCS by mathematically modelling bubble dynamics and tissue gas kinetics are challenging to validate. This is due to lack of understanding regarding the mechanism(s) leading from bubble formation to DCS. In this work, a biomimetic in vitro tissue phantom and a three-dimensional computational model, comprising a hyperelastic strain-energy density function to model tissue elasticity, were combined to investigate key areas of bubble dynamics. A sensitivity analysis indicated that the diffusion coefficient was the most influential material parameter. Comparison of computational and experimental data revealed the bubble surface's diffusion coefficient to be 30 times smaller than that in the bulk tissue and dependent on the bubble's surface area. The initial size, size distribution and proximity of bubbles within the tissue phantom were also shown to influence their subsequent dynamics highlighting the importance of modelling bubble nucleation and bubble-bubble interactions in order to develop more accurate dive algorithms.

SUBMITTER: Walsh C

PROVIDER: S-EPMC5746571 | biostudies-literature | 2017 Dec

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

A combined three-dimensional <i>in vitro-in silico</i> approach to modelling bubble dynamics in decompression sickness.

Walsh C C Stride E E Cheema U U Ovenden N N

Journal of the Royal Society, Interface 20171201 137

The growth of bubbles within the body is widely believed to be the cause of decompression sickness (DCS). Dive computer algorithms that aim to prevent DCS by mathematically modelling bubble dynamics and tissue gas kinetics are challenging to validate. This is due to lack of understanding regarding the mechanism(s) leading from bubble formation to DCS. In this work, a biomimetic <i>in vitro</i> tissue phantom and a three-dimensional computational model, comprising a hyperelastic strain-energy den ...[more]

PMID: 29263127

Similar Datasets

Project description:IntroductionMost cases of decompression sickness (DCS) occur soon after surfacing, with 98% within 24 hours. Recompression using hyperbaric chamber should be administrated as soon as feasible in order to decrease bubble size and avoid further tissue injury. Unfortunately, there may be a significant time delay from surfacing to recompression. The time beyond which hyperbaric treatment is non effective is unclear. The aims of the study were first to evaluate the effect of delayed hyperbaric treatment, initiated more than 48 h after surfacing for DCS and second, to evaluate the different treatment protocols.MethodsFrom January 2000 to February 2014, 76 divers had delayed hyperbaric treatment (≥48 h) for DCS in the Sagol center for Hyperbaric medicine and Research, Assaf-Harofeh Medical Center, Israel. Data were collected from their medical records and compared to data of 128 patients treated earlier than 48 h after surfacing at the same hyperbaric institute.ResultsThere was no significant difference, as to any of the baseline characteristics, between the delayed and early treatment groups. With respect to treatment results, at the delayed treatment divers, complete recovery was achieved in 76% of the divers, partial recovery in 17.1% and no improvement in 6.6%. Similar results were achieved when treatment started early, where 78% of the divers had complete recovery, 15.6% partial recovery and 6.2% no recovery. Delayed hyperbaric treatment using US Navy Table 6 protocol trended toward a better clinical outcome yet not statistically significant (OR=2.786, CI95%[0.896-8.66], p=0.07) compared to standard hyperbaric oxygen therapy of 90 minutes at 2 ATA, irrespective of the symptoms severity at presentation.ConclusionsLate recompression for DCS, 48 hours or more after surfacing, has clinical value and when applied can achieve complete recovery in 76% of the divers. It seems that the preferred hyperbaric treatment protocol should be based on US Navy Table 6.

Project description:PurposePercutaneous cement discoplasty (PCD) is a minimally invasive surgical option to treat patients who suffer from the consequences of advanced disc degeneration. As the current two-dimensional methods can inappropriately measure the difference in the complex 3D anatomy of the spinal segment, our aim was to develop and apply a volumetric method to measure the geometrical change in the surgically treated segments.MethodsProspective clinical and radiological data of 10 patients who underwent single- or multilevel PCD was collected. Pre- and postoperative CT scan-based 3D reconstructions were performed. The injected PMMA (Polymethylmethacrylate) induced lifting of the cranial vertebra and the following volumetric change was measured by subtraction of the geometry of the spinal canal from a pre- and postoperatively predefined cylinder. The associations of the PMMA geometry and the volumetric change of the spinal canal with clinical outcome were determined.ResultsChange in the spinal canal volume (ΔV) due to the surgery proved to be significant (mean ΔV = 2266.5 ± 1172.2 mm3, n = 16; p = 0.0004). A significant, positive correlation was found between ΔV, the volume and the surface of the injected PMMA. A strong, significant association between pain intensity (low back and leg pain) and the magnitude of the volumetric increase of the spinal canal was shown (ρ = 0.772, p = 0.009 for LBP and ρ = 0.693, p = 0.026 for LP).ConclusionThe developed method is accurate, reproducible and applicable for the analysis of any other spinal surgical method. The volume and surface area of the injected PMMA have a predictive power on the extent of the indirect spinal canal decompression. The larger the ΔV the higher clinical benefit was achieved with the PCD procedure.The translational potential of this articleThe developed method has the potential to be integrated into clinical software's to evaluate the efficacy of different surgical procedures based on indirect decompression effect such as PCD, anterior lumbar interbody fusion (ALIF), lateral lumbar interbody fusion (LLIF), oblique lumbar interbody fusion (OLIF), extreme lateral interbody fusion (XLIF). The intraoperative use of the method will allow the surgeon to respond if the decompression does not reach the desired level.

Dataset Information

A combined three-dimensional in vitro-in silico approach to modelling bubble dynamics in decompression sickness.

Publications

A combined three-dimensional <i>in vitro-in silico</i> approach to modelling bubble dynamics in decompression sickness.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets