Dataset Information

Posterior tension band plate osteosynthesis for unstable sacral fractures: A preliminary study.

ABSTRACT: Introduction:Stable reduction and rigid fixation of the sacrum and posterior ring structures are of paramount importance in the management of complex pelvic ring disruptions, Tile B and C. The major concern with the use of conventional methods, like iliosacral screws and iliolumbar fixations is the increased risk for surgical and implant-related morbidity, especially in difficult situations, such as comminuted, bilateral sacral fractures, and fractures in the dysmorphic sacrum. Although various biomechanical studies have reported the posterior trans-iliac plates to provide maximum resistance to distracting forces by the principle of tension band, the literature pertaining to this implication in clinical studies has been limited. The purpose of our study was to assess the efficacy of the trans-iliac plate in the management of unstable sacral fractures and its utility in pelvic disruptions associated with surgical site morbidity. Methodology:The patients with unstable pelvic fractures (Tile B and C) between 2013 and 2017 were retrospectively analyzed at a trauma center. First, the anterior ring disruptions were stabilized, and then, the sacral fractures (Denis Zone 1-3) treated by posterior tension band plate osteosynthesis (3.5?mm reconstruction plate) were included. Demographic and perioperative data were assessed. The outcome variables studied were surgical morbidity, pain, loss of reduction, and union and implant-related complications. The outcomes were graded using Lindhal's (radiological) and Majeed (functional assessment) scores. Results:Thirteen patients (nine male/four female) with a median age of 42 years, had sacral fractures in Denis zones 1/2/3 (four/ten/one, respectively), resulting from Tile pelvic injury B and C were included. The pelvis in five patients was stabilized only with the posterior plate due to the anteriorly-associated surgical site morbidity (Morel-Lavallee lesions and urinary tract injuries). The mean follow-up was 21.5?±?2.8 months. All fractures had a radiological union by 22 weeks; Lindhal's grade A in ten patients and grade B in three patients. Two out of three patients recovered from preoperative neurological involvement. Two had complained of implant prominence (BMI<19?kg/m2) and there were no implant failures. Four had excellent, six had good, and three had fair or poor functional outcomes. Conclusion:The posterior trans-iliac plate is a minimally invasive and safe procedure that can be used in a wide range of unstable sacral fractures with notably less implant failure rate. The rigid posterior construct restores the principle tension between the iliac blades and minimizes the secondary displacement of the anterior disrupted structures, thereby useful in managing ring disruptions with surgical site morbidity.

SUBMITTER: Khaleel VM

PROVIDER: S-EPMC6823733 | biostudies-literature | 2019 Oct

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Posterior tension band plate osteosynthesis for unstable sacral fractures: A preliminary study.

Khaleel Veliyaveettil Muhamed VM Pushpasekaran Narendran N Prabhu Nithin N Pandiyan Alagu A Koshy George Mathew GM

Journal of clinical orthopaedics and trauma 20190524 Suppl 1

<h4>Introduction</h4>Stable reduction and rigid fixation of the sacrum and posterior ring structures are of paramount importance in the management of complex pelvic ring disruptions, Tile B and C. The major concern with the use of conventional methods, like iliosacral screws and iliolumbar fixations is the increased risk for surgical and implant-related morbidity, especially in difficult situations, such as comminuted, bilateral sacral fractures, and fractures in the dysmorphic sacrum. Although ...[more]

PMID: 31695268

Similar Datasets

Project description:BACKGROUND:Treating proximal humerus fractures can be challenging because of large metaphyseal defects that conceal anatomical landmarks. In such cases, medial cortical support with, for example, calcar screws, is mandatory. Nevertheless, varus dislocations and implant failures in patients with impaired bone quality persist. Thus, the need for effective treatment of these patients exists. Hybrid double plate osteosynthesis was introduced as an alternative, yielding similar results as calcar screws. However, a biomechanical comparison of the stability of these two techniques is pending. METHODS:Cadaveric humeral specimens were treated with plate osteosynthesis and calcar screws (group 1, n = 9) or hybrid double plate osteosynthesis (group 2, n = 9) using a proximal humerus fracture model with a two-part fracture. Displacement, stiffness, failure mode, and ultimate load were examined biomechanically in a cyclic compressive-loading scenario. RESULTS:Although the hybrid double plate osteosynthesis (group 2) tended to confer higher stiffnesses than the medial support screws at higher cycles (group 1), this trend was below the level of significance. The displacement revealed non-significantly lower values for group 1 as compared with group 2 for cycles 50 and 2000, but at 5000 cycles, group 2 offered non-significantly lower displacement values than group 1. The ultimate load tended to be non-significantly higher in the hybrid double plate osteosynthesis group (group 2: 1342±369 N, group 1: 855±408 N). Both groups yielded similar failure rates, with the majority of failures in group 2 being gap closures (n = 8), whereas those in group 1 being plate dislocations (n = 4). CONCLUSIONS:The use of an additive plate osteosynthesis in the region of the bicipital groove may be a potential alternative to the previously-established method of using calcar screws. The biomechanical data obtained in this study suggests that hybrid double plate osteosynthesis is as rigid and robust as calcar screws.

Project description:The posterior screw fixation in atlas via posterior arch and lateral mass, also called C1 "pedicle" screw, combined with C2 pedicle screw fixiation has shown better biomechanical stability in unstable atlantoaxial fractures. However, its popularization has to fulfill the limitation imposed by anatomical characteristics. The aim of this study was to explore the manipulation, effect, and safety of the atlantoaxial transpedicular screw fixation under "direct vision" for the treatment of unstable atlantoaxial fracture.All the patients diagnosed with unstable atlantoaxial fracture, who received surgery treatment of C1,C2 internal fixation from January 2012 to December 2014 were reviewed. Only these patients that were diagnosed with atlantoaxial unstability secondary to trauma and were treated with atlantoaxial transpedicular screw fixation under "direct vision" and iliac autograft were included. The safety of transpedicular screw placement, postoperative outcome, atlantoaxial stability, autograft fusion, and complications was observed and analyzed retrospectively. The pain visual analog scale (VAS) and the Japanese Orthopedic Association (JOA) score were used as surgical curative effect evaluation standards.We reviewed a total of 92 patients diagnosed with unstable atlantoaxial fracture, who received surgery treatment of C1,C2 internal fixation from January 2012 to December 2014, and 87 patients were treated with atlantoaxial transpedicular screw fixation under "direct vision" and were included this analysis. A total of 306 transpedicular screws in atlas and axis were placed successfully. All cases were followed-up >12 months. The overall breach rate was 11.36%. None of the breaches resulted in new-onset neurological sequela. The neurological status in cases with bilateral upper extremities numbness and lower extremities weakness had improved after surgery. At the latest follow-up, the neck VAS and JOA scores were significantly improved (P?<?.01) than those preoperatively. No cases demonstrated implantation failure and bone graft absorption on the postoperative x-ray films and CT scans.Atlantoaxial transpedicular screw fixation under "direct vision" and iliac autograft for the treatment of unstable atlantoaxial fracture has shown simple manipulation and efficient performance. Thus, the technique of C1-C2 fixation is feasible in treating unstable atlantoaxial fracture.

Dataset Information

Posterior tension band plate osteosynthesis for unstable sacral fractures: A preliminary study.

Publications

Posterior tension band plate osteosynthesis for unstable sacral fractures: A preliminary study.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets