The recalescence rate of cooling curve for undercooled solidification.
Ontology highlight
ABSTRACT:
SUBMITTER: Xu J
PROVIDER: S-EPMC6987091 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In AA2618 aluminum alloy, the iron- and nickel-rich intermetallics formed during solidification are of great effect on the mechanical properties of the alloy at both room temperature and elevated temperatures. However, the solidification behavior of the alloy and the formation mechanism of the intermetallics during solidification of the alloy are not clear. This research fills the gap and contributes to understanding the intermetallic of the alloy. The results showed that cooling rate was of great influence on the formation of the intermetallics. Under the condition of slow cooling, the as-cast microstructures of the alloy were complex with many coarse eutectic compounds including Al₉FeNi, Al₇(CuNi)₅, Si, Al₂Cu and Al₂CuMg. The phase Al₉FeNi was the dominant intermetallic compound, which precipitated at the earlier stage of the solidification by eutectic reaction L → α-Al + Al₉FeNi. Increasing the cooling rate would suppress the formation of the coarse eutectic intermetallics. Under the condition of near-rapid cooling, the as-cast microstructures of the alloy consisted of metastable intermetallics Al₉FeNi and Al₂Cu; the equilibrium eutectic compounds were suppressed. This research concluded that intermetallics could be refined to a great extent by near-rapid cooling.
| S-EPMC5456450 | biostudies-other
Project description:This research introduces a cell cryopreservation method, which utilizes thin film evaporation and provides an ultra-high cooling rate. The microstructured surface forming the thin film evaporation was fabricated from copper microparticles with an average diameter of 50 μm. Experimental results showed that a cooling rate of approximately 5[Formula: see text]10(4) °C/min was achieved in a temperature range from 10 °C to -187 °C. The current investigation will give birth to a cell cryopreservation method through vitrification with relatively low concentrations of cryoprotectants.
| S-EPMC3460952 | biostudies-other
Project description:This work aims to achieve deep insight into the phenomenon of phase transformation upon rapid cooling in metal systems and reveal the physical meaning of scatter in the time taken to reach crystallization. The total number of pure metals considered in this work accounts for 14. Taking pure copper as an example, the correlation between phase selection of crystal or glass and cooling rate was investigated using molecular dynamic simulations. The obtained results demonstrate that there exists a cooling rate region of 6.3 × 10(11)-16.6 × 10(11) K/s, in which crystalline fractions largely fluctuate along with cooling rates. Glass transformation in this cooling rate region is determined by atomic structure fluctuation, which is controlled by thermodynamic factors. According to the feature of bond-orientation order at different cooling rates, we propose two mechanisms of glass formation: (i) kinetic retardation of atom rearrangement or structural relaxation at a high cooling rate; and (ii) competition of icosahedral order against crystal order near the critical cooling rate.
| S-EPMC4778031 | biostudies-literature
Project description:Self-assembly of crystalline-coil block copolymers (BCPs) in selective solvents is often carried out by heating the mixture until the sample appears to dissolve and then allowing the solution to cool back to room temperature. In self-seeding experiments, some crystallites persist during sample annealing and nucleate the growth of core-crystalline micelles upon cooling. There is evidence in the literature that the nature of the self-assembled structures formed is independent of the annealing time at a particular temperature. There are, however, no systematic studies of how the rate of cooling affects self-assembly. We examine three systems based upon poly(ferrocenyldimethylsilane) BCPs that generated uniform micelles under typical conditions where cooling took pace on the 1-2 h time scale. For example, several of the systems generated elongated 1D micelles of uniform length under these slow cooling conditions. When subjected to rapid cooling (on the time scale of a few minutes or faster), branched structures were obtained. Variation of the cooling rate led to a variation in the size and degree of branching of some of the structures examined. These changes can be explained in terms of the high degree of supersaturation that occurs when unimer solutions at high temperature are suddenly cooled. Enhanced nucleation, seed aggregation, and selective growth of the species of lowest solubility contribute to branching. Cooling rate becomes another tool for manipulating crystallization-driven self-assembly and controlling micelle morphologies.
| S-EPMC8729813 | biostudies-literature
Project description:Introduction: The Heart Rate Performance Curve (HRPC) is neither linear nor uniform and related to ß1-adrenoceptor sensitivity. As aging and exercise influence ß1-adrenoceptors we suggested age, sex and performance effects on the HRPC. Aim of the study was to examine the effects of aging on the deflection of the HRPC in maximal incremental cycle ergometer exercise (CE) in a large cohort of healthy subjects. Methods: Heart rate (HR) data of 2,980 men (51 ± 15 years) and 1,944 women (52 ± 14 years) were classified into age groups (?20 up to >80 years). We analyzed age and performance (Plow 25%-quartile and Phigh 75%-quartile of age predicted power) effects on HRmax and on the degree (k) and the type (regular downward deflection k > 0.1, linear -0.1 ? k ? 0.1 and atypical upward deflection k < -0.1) of the HRPC. Results: k-values decreased significantly with age in men and women and were significantly higher in women. Atypical HRPC's increased by a linear trend from ?20 to 70 years (m) respectively 80 years (w) from 10 to 43% (m) and 9 to 30% (w). HRmax of all age groups was lower in Plow and overall number of atypical HRPC's was 21% (m) and 16% (w) higher compared to Phigh. Conclusion: Aging increased the number of atypical HRPC's with upward deflection in CE tests, which influences exercise intensity prescription especially when using fixed percentages of HRmax. Changes in HRPC's were affected by sex and performance, where women generally and subjects with higher performance presented less atypical HRPC's even at older age.
| S-EPMC7144539 | biostudies-literature
Project description:Many synthetic or natural fibers are produced via the transformation of a liquid solution into a solid filament, which allows the wet processing of high molecular weight polymers, proteins, or inorganic particles. Synthetic wet-spun fibers are used in our everyday life from clothing to composite reinforcement applications. Spun fibers are also common in nature. Silk solidification results from the coagulation of protein solutions. The chemical phenomena involved in the formation of all these classes of fibers can be quite different but they all share the same fundamental transformation from a liquid to a solid state. The solidification process is critical because it governs the production rate and the strength that fibers can sustain to be drawn and wound. An approach is proposed in this work to investigate the kinetics of fiber solidification. This approach consists in circulating solidifying fibers in the extensional flow of a surrounding liquid. Such as polymers in extensional flows, the fibers break if resultant drag forces exceed the fiber tensile strength. The solidification kinetics of nanotube composite fibers serves as a validation example of this approach. The method could be extended to other systems and advance thereby the science and technology of fiber and textile materials. It is also a way to directly visualize the scission of chain-like systems in extensional flows.
| S-EPMC2972970 | biostudies-literature
Project description:The data presented here is complementary to the publication entitled "High temperature, low neutron cross-section high-entropy alloys in the Nb-Ti-V-Zr system" [1]. A homogenization methodology with slower cooling rate (?2 °C/min) was performed. X-ray diffraction and scanning electron microscopy (backscattered electron and energy dispersive spectroscopy) data pertaining to annealed high-entropy alloy composition NbTiVZr is presented.
| S-EPMC6488565 | biostudies-literature
Project description:A method is described whereby net rate constants can be directly inferred from the progress curves of enzyme intermediates without the need for model specification, numerical analysis, curve fitting, or the steady-state approximation. Specifically, if an enzyme intermediate in an ultimately irreversible serial subsequence is perturbed from and returns back to its equilibrium state as the substrate is consumed, then its net rate constant is given by the ratio of the total substrate consumed and the area under the progress curve for the enzyme intermediate. A rigorous analysis demonstrates this result to hold independent of the complete enzymatic reaction in which the subsequence is embedded, making it broadly applicable to a very wide range of kinetic mechanisms, including those complicated by inhibition. As a theoretical consequence, it is shown that traditionally steady-state parameters such as kcat, kcat/KM, and net rate constants can be expressed as limiting ratios of averages without requiring the steady-state hypothesis. Finally, a mock data set is generated for a system of contemporary interest that can serve as both an example of how the methodology would be used in practice and a proof of concept.
| S-EPMC6910778 | biostudies-literature
Project description:BackgroundRam spermatozoa are sensitive to extreme changes in temperature during the freeze-thaw process. The degree of damage depends on a combined effect of various factors including freezing temperature. The aim of this study was to determine the effects of two cooling method (controlled-rate and uncontrolled-rate) on pre-freezing and post-thaw sperm motility parameters.ResultsEjaculates were collected using the artificial vagina from four Chal rams and three replicates of the ejaculates were diluted with a Tris-based extender and packed in 0.25 ml straws. Then, sample processed according to the two methods. Method 1: straws cooled from 37 to 5°C, at a liner rate of -0.3°C/min in a controlled-rate cooling machine (custom-built) and equilibrated at 5°C for 80 min, then the straws were frozen at rate of -0.3°C/min from 5°C to -10°C and -25°C/min from -10°C to -150°C and plunged into liquid nitrogen for storage. Method 2: straws were transferred to refrigerator and maintained at 5°C for 3 h, then the straws were frozen in liquid nitrogen vapor, 4 cm above the liquid nitrogen for 15 min and plunged into liquid nitrogen. Computer-assisted sperm motility analysis was used to analyze sperm motion characteristics.ConclusionsControlled rate of freezing (Method 1) significantly improve the pre-freezing and post-thaw total and progressive motility compared to uncontrolled rate (Method 2). In specific kinetic parameters, Method 1 gives significantly higher value for VSL and VCL in comparison with Method 2. There are no significant differences between the two methods for VAP and LIN. In conclusion, controlled rate of cooling conferred better cryopreserving ability to ram spermatozoa compared to uncontrolled rate of cooling prior to programmable freezing.
| S-EPMC3349620 | biostudies-literature
Project description:When biological samples are first exposed to electrons in cryo-electron microcopy (cryo-EM), proteins exhibit a rapid 'burst' phase of beam-induced motion that cannot be corrected with software. This lowers the quality of the initial frames, which are the least damaged by the electrons. Hence, they are commonly excluded or down-weighted during data processing, reducing the undamaged signal and the resolution in the reconstruction. By decreasing the cooling rate during sample preparation, either with a cooling-rate gradient or by increasing the freezing temperature, we show that the quality of the initial frames for various protein and virus samples can be recovered. Incorporation of the initial frames in the reconstruction increases the resolution by an amount equivalent to using ~60% more data. Moreover, these frames preserve the high-quality cryo-EM densities of radiation-sensitive residues, which is often damaged or very weak in canonical three-dimensional reconstruction. The improved freezing conditions can be easily achieved using existing devices and enhance the overall quality of cryo-EM structures.
| S-EPMC10392635 | biostudies-literature