Optical Properties of Stanene-like Nanosheets on Al2O3(0001): Implications for Xene Photonics.
Ontology highlight
ABSTRACT:
SUBMITTER: Grazianetti C
PROVIDER: S-EPMC8023281 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In recent years, the transition metal carbonitrides(MXenes) have been widely applied to photoelectric field, and better performance of these applications was achieved via MXene complex structures. In our work, we proposed a MXene core-shell nanosheet composed of a Ti2C (MXene) phase and gold nanoparticles, and applied it to mode-locked and single-frequency fiber laser applications. The optoelectronic results suggested that the performances of these two applications were both improved when MXene core-shell nanosheets were applied. As a result, we obtained a mode-locking operation with 670 fs pulses, and the threshold pump power reached to as low as 20 mW. Besides, a single-frequency laser with the narrowest linewidth of ~1 kHz is also demonstrated experimentally. Our research work proved that MXene core-shell nanosheets could be used as saturable absorbers (SAs) to promote versatile photonic applications.
| S-EPMC8398170 | biostudies-literature
Project description:Metal-free chemical vapor deposition (CVD) of single-layer graphene (SLG) on c-plane sapphire has recently been demonstrated for wafer diameters of up to 300 mm, and the high quality of the SLG layers is generally characterized by integral methods. By applying a comprehensive analysis approach, distinct interactions at the graphene-sapphire interface and local variations caused by the substrate topography are revealed. Regions near the sapphire step edges show tiny wrinkles with a height of about 0.2 nm, framed by delaminated graphene as identified by the typical Dirac cone of free graphene. In contrast, adsorption of CVD SLG on the hydroxyl-terminated α-Al2O3 (0001) terraces results in a superstructure with a periodicity of (2.66 ± 0.03) nm. Weak hydrogen bonds formed between the hydroxylated sapphire surface and the π-electron system of SLG result in a clean interface. The charge injection induces a band gap in the adsorbed graphene layer of about (73 ± 3) meV at the Dirac point. The good agreement with the predictions of a theoretical analysis underlines the potential of this hybrid system for emerging electronic applications.
| S-EPMC9637179 | biostudies-literature
Project description:Stanene (Sn)-based materials have been extensively applied in industrial production and daily life, but their potential biomedical application remains largely unexplored, which is due to the absence of the appropriate and effective methods for fabricating Sn-based biomaterials. Herein, we explored a new approach combining cryogenic exfoliation and liquid-phase exfoliation to successfully manufacture two-dimensional (2D) Sn nanosheets (SnNSs). The obtained SnNSs exhibited a typical sheet-like structure with an average size of ~ 100 nm and a thickness of ~ 5.1 nm. After PEGylation, the resulting PEGylated SnNSs (SnNSs@PEG) exhibited good stability, superior biocompatibility, and excellent photothermal performance, which could serve as robust photothermal agents for multi-modal imaging (fluorescence/photoacoustic/photothermal imaging)-guided photothermal elimination of cancer. Furthermore, we also used first-principles density functional theory calculations to investigate the photothermal mechanism of SnNSs, revealing that the free electrons in upper and lower layers of SnNSs contribute to the conversion of the photo to thermal. This work not only introduces a new approach to fabricate 2D SnNSs but also establishes the SnNSs-based nanomedicines for photonic cancer theranostics. This new type of SnNSs with great potential in the field of nanomedicines may spur a wave of developing Sn-based biological materials to benefit biomedical applications.
| S-EPMC8006518 | biostudies-literature
Project description:Molybdenum disulfide (MoS2) nanosheets, due to having a highly active nature, being low cost and having unique physical and chemical properties, have shown their efficacy in the catalytic reduction of nitroarenes. Doping of transition metal ions in molybdenum disulfide (MoS2) nanosheets is a well-known strategy to enhance their catalytic efficiency for the reduction of nitroarenes, however, finding the optimum dopant amount is still a subject of ongoing research. Herein, we have synthesized few-layered cobalt (Co) doped MoS2 nanosheets with different cobalt content (2%, 4%, 6% and 8%) through the solvothermal approach, taking sodium molybdate dihydrate (Na2MoO4·2H2O), thiourea (CH4N2S) and cobalt acetate tetrahydrate [Co(CH3COO)2·4H2O] as precursors and their catalytic performance has been affirmed by monitoring the reduction of p-nitrophenol by NaBH4 in real time using UV-visible absorption spectroscopy. The 6% Co doped MoS2 nanosheets have exhibited superior catalytic activity with a pseudo-first order rate constant of 3.03 × 10-3 s-1 attributed to the abundant defects in the active edge sites having a dominant metallic 1T phase with Co ion activated defective basal planes, sulphur (S) edges, synergistic structural and electronic modulation between MoS2 and Co ions and enhanced electron transfer assisted through redox cycling in the active sites. An attempt has also been made to study the manipulation of structural and optical properties with cobalt doping in MoS2 nanosheets to establish a correlation between the catalytic efficiency and dopant content. This study demonstrates that proper tuning of Co doping in MoS2 nanosheets paves the way in searching for a potential alternative of a noble metal catalyst for the catalytic reduction of nitroarenes.
| S-EPMC8693518 | biostudies-literature
Project description:Imaging of complex (biological) samples in the near-infrared (NIR) is beneficial due to reduced light scattering, absorption, phototoxicity, and autofluorescence. However, there are few NIR fluorescent materials known and suitable for biomedical applications. Here we exfoliate the layered pigment CaCuSi4O10 (Egyptian Blue, EB) via ball milling and facile tip sonication into NIR fluorescent nanosheets (EB-NS). The size of EB-NS can be tailored to diameters <20 nm and heights down to 1 nm. EB-NS fluoresce at 910 nm and the fluorescence intensity correlates with the number of Cu2+ ions. Furthermore, EB-NS display no bleaching and high brightness compared with other NIR fluorophores. The versatility of EB-NS is demonstrated by in-vivo single-particle tracking and microrheology measurements in Drosophila melanogaster embryos. EB-NS can be uptaken by plants and remotely detected in a low-cost stand-off detection setup. In summary, EB-NS have the potential for a wide range of bioimaging applications.
| S-EPMC7083911 | biostudies-literature
Project description:"Strain engineering" in functional materials has been widely explored to tailor the physical properties of electronic materials and improve their electrical and/or optical properties. Here, we exploit both in plane and out of plane uniaxial tensile strains in MoS2 to modulate its band gap and engineer its optical properties. We utilize X-ray diffraction and cross-sectional transmission electron microscopy to quantify the strains in the as-synthesized MoS2 nanosheets and apply measured shifts of Raman-active modes to confirm lattice strain modification of both the out-of-plane and in-plane phonon vibrations of the MoS2 nanosheets. The induced band gap evolution due to in-plane and out-of-plane tensile stresses is validated by photoluminescence (PL) measurements, promising a potential route for unprecedented manipulation of the physical, electrical and optical properties of MoS2.
| S-EPMC4090623 | biostudies-literature
Project description:Metal oxide based minerals naturally contain transition metal impurities isomorphically substituted into the structure that can alter the structural and electronic properties as well as the reactivity of these metal oxides. Natural ?-Al(2)O(3) (corundum) can contain up to 9.17% (w/w) Fe(2)O(3) and 1.81% (w/w) of Cr(2)O(3.) Here we report on changes in the structural and electronic properties of undoped and doped ?-Al(2)O(3) (0001) surfaces using periodic density functional theory (DFT) methods with spin unrestricted B3LYP functional and a local atomic basis set. Both structural and electronic properties are altered upon doping. Implications for doping effects on photochemical processes are discussed.As metal oxides are major components of the environment, including atmospheric mineral aerosol, DFT was also used to study the effect of transition metal impurities on gas/surface interactions of a model acidic atmospheric gas molecule, carbon monoxide (CO). The theoretical results indicated that the presence of Fe(3+) and Cr(3+) impurities substituted on the outer layer of natural corundum surfaces reduces the propensity toward CO adsorption relative to the undoped surface. However, CO-surface interactions resemble that of bulk ?-Al(2)O(3) when the impurity is substituted below the first surface layer. The presence and location of the mineral dopant was found to significantly alter the structural and electronic properties and gas/surface interactions studied here.
| S-EPMC3568980 | biostudies-literature
Project description:Silk fibers are expected to become a pathway to biocompatible and bioresorbable waveguides, which could be used to deliver localized optical power for various applications, e.g., optical therapy or imaging inside living tissue. Here, for the first time, the linear and nonlinear optical properties of natural silk fibers have been studied. The waveguiding properties of silk fibroin of largely unprocessed Bombyx mori silkworm silk are assessed using two complementary methods, and found to be on the average 2.8 dB mm(-1). The waveguide losses of degummed silk are to a large extent due to scattering from debris on fiber surface and helical twisting of the fiber. Nonlinear optical microscopy reveals both configurational defects such as torsional twisting, and strong symmetry breaking at the center of the fiber, which provides potential for various nonlinear applications. Our results show that nonregenerated B. mori silk can be used for delivering optical power over short distances, when the waveguide needs to be biocompatible and bioresorbable, such as embedding the waveguide inside living tissue.
| S-EPMC4772132 | biostudies-literature
Project description:Defect-activated ultrathin graphitic carbon nitride nanosheets (g-C3N4) show an enhanced visible light absorption, better charge-separation, and facile charge transport properties. These are requisites for the designing of an active photocatalyst. Conventional methods used for layer exfoliation and defect activation require strong acids, reducing agents, or ultrasonic treatment for a sufficiently long duration. Furthermore, single-step approaches for layer exfoliation and defect incorporation have hardly been reported. Herein, we have shown atmospheric plasma enabled fabrication of g-C3N4 nanosheets. This approach is simple, low-cost, less time-consuming, and a green approach to exfoliate layers and activate multiple defects concurrently. The protocol involves plasma discharging at an air-water interface at 5 kV for 30-150 min. Atomic force microscopy (AFM) reveals a layer thickness of 96.27 nm in bulk g-C3N4. The thickness becomes 3.78 nm after 150 min of plasma treatment. The exfoliated layers emerge with nitrogen-vacancy sites and self-incorporated defects as probed by positron annihilation spectroscopy (PAS) and X-ray photoelectron spectroscopy (XPS). The defect activated layers show visible light absorption extended up to 600 nm. It is demonstrated that a non-uniform change in the band gap with the plasma treatment time results from quantum confinement in thin layers and Urbach tailing due to defects acting in opposition. Further, steady-state and time-resolved spectroscopy shows the contribution of multiple defect sites for a prolonged lifetime of photoinduced carriers. These defect-activated ultrathin nanosheets of CN serve as an active photocatalyst in the degradation of rhodamine B (RhB) under white LED illumination.
| S-EPMC9416856 | biostudies-literature
Project description:WO3 nanosheets was prepared by an acidification method and the Rh catalyst was dispersed on the surface of the nanosheets with a wet impregnation method. The morphology of pristine WO3 and Rh modified WO3 nanosheets and their responses to acetone gas were studied. According to oxygen adsorption combined with TPR results, the sensing and sensitization mechanism of acetone were discussed. It was found that no visible changes in nanostructures or morphologies were observed in WO3 nanosheets with Rh, however, the sensor resistance and sensor response were greatly promoted. The basic sensitization mechanism could be caused by the electronic interaction between oxidized Rh and WO3 surface.
| S-EPMC6141622 | biostudies-literature