Development of polarization modulator using MXene thin film.
Ontology highlight
ABSTRACT:
SUBMITTER: Tiu ZC
PROVIDER: S-EPMC9042864 | biostudies-literature | 2022 Apr
REPOSITORIES: biostudies-literature
Publications
Development of polarization modulator using MXene thin film.
Tiu Zian Cheak ZC Tan Sin Jin SJ Yusoff N N Ahmad Harith H
Scientific reports 20220426 1
In this work, polarization modulator utilizing MXene material, namely Nb<sub>2</sub>C is demonstrated. S band signal is injected into Nb<sub>2</sub>C thin film and is modulated by 1400 nm laser diode. A total of 39.81° of polarization rotation is attained when the pump power is increased to 223 mW. The rotation of light is due to thermo-optic effect. The efficiency of polarization modulator is calculated at 0.1974°/mW. ...[more]
Similar Datasets
Project description:Utilizing Bragg surface plasmon polaritons (SPPs) on metal nanostructures for the use in optical devices has been intensively investigated in recent years. Here, we demonstrate the integration of nanostructured metal electrodes into an ITO-free thin film bulk heterojunction organic solar cell, by direct fabrication on a nanoimprinted substrate. The nanostructured device shows interesting optical and electrical behavior, depending on angle and polarization of incidence and the side of excitation. Remarkably, for incidence through the top electrode, a dependency on linear polarization and angle of incidence can be observed. We show that these peculiar characteristics can be attributed to the excitation of dispersive and non-dispersive Bragg SPPs on the metal-dielectric interface on the top electrode and compare it with incidence through the bottom electrode. Furthermore, the optical and electrical response can be controlled by the organic photoactive material, the nanostructures, the materials used for the electrodes and the epoxy encapsulation. Our device can be used as a detector, which generates a direct electrical readout and therefore enables the measuring of the angle of incidence of up to 60° or the linear polarization state of light, in a spectral region, which is determined by the active material. Our results could furthermore lead to novel organic Bragg SPP-based sensor for a number of applications.
| S-EPMC7559313 | biostudies-literature
Project description:Ferroelectric thin-films are highly desirable for their applications on energy conversion, data storage and so on. Molecular ferroelectrics had been expected to be a better candidate compared to conventional ferroelectric ceramics, due to its simple and low-cost film-processability. However, most molecular ferroelectrics are mono-polar-axial, and the polar axes of the entire thin-film must be well oriented to a specific direction to realize the macroscopic ferroelectricity. To align the polar axes, an orientation-controlled single-crystalline thin-film growth method must be employed, which is complicated, high-cost and is extremely substrate-dependent. In this work, we discover a new molecular ferroelectric of quinuclidinium periodate, which possesses six-fold rotational polar axes. The multi-axes nature allows the thin-film of quinuclidinium periodate to be simply prepared on various substrates including flexible polymer, transparent glasses and amorphous metal plates, without considering the crystallinity and crystal orientation. With those benefits and excellent ferroelectric properties, quinuclidinium periodate shows great potential in applications like wearable devices, flexible materials, bio-machines and so on.
| S-EPMC5382275 | biostudies-literature
Project description:High-speed polarization management is highly desirable for many applications, such as remote sensing, telecommunication, and medical diagnosis. However, most of the approaches for polarization management rely on bulky optical components that are slow to respond, cumbersome to use, and sometimes with high drive voltages. Here, we overcome these limitations by harnessing photonic integrated circuits based on thin-film lithium niobate platform. We successfully realize a portfolio of thin-film lithium niobate devices for essential polarization management functionalities, including arbitrary polarization generation, fast polarization measurement, polarization scrambling, and automatic polarization control. The present devices feature ultra-fast control speeds, low drive voltages, low optical losses and compact footprints. Using these devices, we achieve high fidelity polarization generation with a polarization extinction ratio up to 41.9 dB and fast polarization scrambling with a scrambling rate up to 65 Mrad s-1, both of which are best results in integrated optics. We also demonstrate the endless polarization state tracking operation in our devices. The demonstrated devices unlock a drastically new level of performance and scales in polarization management devices, leading to a paradigm shift in polarization management.
| S-EPMC9008021 | biostudies-literature
Project description:Ultrafast injection-locked amplification is achieved by sending femtosecond supercontinuum pulses into a polymeric thin film coated on a distributed feedback (DFB) microcavity consisting of chirped gratings. The spatial variation of the grating period led to the resonance of the DFB microcavity at different wavelengths for injection at different locations. This enables convenient and continuous tuning of the amplification spectrum by displacing the grating structures. The large area of the grating structures enabled large tuning range. The amplified spectrum can be continuously tuned from 545 to 580 nm through sliding the grating structures by about 3.5 mm. Sub-1 ps lifetime has been measured for the amplification process with a net amplification factor as large as 33. Injection locking enabled high-quality control of the divergence and transverse mode of the output laser beam.
| S-EPMC6648656 | biostudies-literature
Project description:Here we report on the development of polyimide-based flexible magnetic actuators for actively combating biofouling that occurs in many chronically implanted devices. The thin-film flexible devices are microfabricated and integrated into a single-pore silicone catheter to demonstrate a proof-of-concept for a self-clearing smart catheter. The static and dynamic mechanical responses of the thin-film magnetic microdevices were quantitatively measured and compared to theoretical values. The mechanical fatigue properties of these polyimide-based microdevices were also characterized up to 300 million cycles. Finally, the biofouling removal capabilities of magnetically powered microdevices were demonstrated using bovine serum albumin and bioconjugated microbeads. Our results indicate that these thin-film microdevices are capable of significantly reducing the amount of biofouling. At the same time, we demonstrated that these microdevices are mechanically robust enough to withstand a large number of actuation cycles during its chronic implantation.
| S-EPMC8281922 | biostudies-literature
Project description:Theoretical works suggest the possibility and usefulness of strain engineering of graphene by predicting remarkable properties, such as Dirac cone merging, bandgap opening and pseudo magnetic field generation. However, most of these predictions have not yet been confirmed because it is experimentally difficult to control the magnitude and type (e.g., uniaxial, biaxial, and so forth) of strain in graphene devices. Here we report two novel methods to apply strain without bending the substrate. We employ thin films of evaporated metal and organic insulator deposited on graphene, which shrink after electron beam irradiation or heat application. These methods make it possible to apply both biaxial strain and in-plane isotropic compressive strain in a well-controlled manner. Raman spectroscopy measurements show a clear splitting of the degenerate states of the G-band in the case of biaxial strain, and G-band blue shift without splitting in the case of in-plane isotropic compressive strain. In the case of biaxial strain application, we find out the ratio of the strain component perpendicular to the stretching direction is at least three times larger than what was previously observed, indicating that shrinkage of the metal or organic insulator deposited on graphene induces both tensile and compressive strain in this atomically thin material. Our studies present for the first time a viable way to apply strain to graphene without the need to bend the substrate.
| S-EPMC3962252 | biostudies-other
Project description:In this study, polyamide (PA) thin film composite (TFC) reverse osmosis (RO) membrane filtration was used in edible oil wastewater emulsion treatment. The PA-TFC membrane was characterized using mechanical, thermal, chemical, and physical tests. Surface morphology and cross-sections of TFCs were characterized using SEM. The effects of edible oil concentrations, average droplets size, and contact angle on separation efficiency and flux were studied in detail. Purification performance was enhanced using activated carbon as a pre-treatment unit. The performance of the RO unit was assessed by chemical oxygen demand (COD) removal and permeate flux. Oil concentration in wastewater varied between 3000 mg/L and 6000 mg/L. Oily wastewater showed a higher contact angle (62.9°) than de-ionized water (33°). Experimental results showed that the presence of activated carbon increases the permeation COD removal from 94% to 99%. The RO membrane filtration coupled with an activated carbon unit of oily wastewater is a convenient hybrid technique for removal of high-concentration edible oil wastewater emulsion up to 99%. Using activated carbon as an adsorption pre-treatment unit improved the permeate flux from 34 L/m2hr to 75 L/m2hr.
| S-EPMC7281104 | biostudies-literature
Project description:We report the first demonstration of operational InGaN-based thin-film transistors (TFTs) on glass substrates. The key to our success was coating the glass substrate with a thin amorphous layer of HfO2, which enabled a highly c-axis-oriented growth of InGaN films using pulsed sputtering deposition. The electrical characteristics of the thin films were controlled easily by varying their In content. The optimized InGaN-TFTs exhibited a high on/off ratio of ~10(8), a field-effect mobility of ~22 cm(2) V(-1) s(-1), and a maximum current density of ~30 mA/mm. These results lay the foundation for developing high-performance electronic devices on glass substrates using group III nitride semiconductors.
| S-EPMC4935987 | biostudies-literature
Project description:Water recycling is one of the most sustainable solutions to growing water scarcity challenges. However, wastewaters usually contain organic pollutants and often are at extreme pH, which complicates the treatment of these streams with conventional membranes. In this work, we report the synthesis of a robust membrane material that can withstand prolonged exposure to extreme pH (of 1 or 13 for 2 months). Polyamine thin film composite (TFC) membranes are prepared in situ by interfacial polymerization between 1,3,5-tris(bromomethyl)benzene (tBrMeB) and p-phenylenediamine (PPD). Contrary to conventional polyamide TFC membranes, enhanced pH stability is achieved by eliminating the carbonyl groups from the polymer network. The membranes showed pure water permeance and molecular weight cutoff (MWCO) of 0.28 ± 0.09 L m-2 h-2 bar-1 and 820 ± 132 g mol-1, respectively. The membrane performance is further enhanced by manipulating the monomer structures and replacing p-phenylenediamine with m-phenylenediamine, resulting in a higher permeance of 1.3 ± 0.3 L m-2 h-1 bar-1 and a lower MWCO of 566 ± 43 g mol-1. Given the ease of fabrication and excellent stability, this chemistry represents a step forward in the fabrication of robust membranes for industrial wastewater recycling.
| S-EPMC8593864 | biostudies-literature
Project description:We present a simple configuration incorporating a single polarization-sensitive phase-only liquid crystal spatial light modulator (LC-SLM) to facilitate polarization-insensitive spatial light modulation. The polarization-insensitive configuration is formed by a polarization beam splitter (PBS), a polarization-sensitive phase-only LC-SLM, a half-wave plate (HWP), and a mirror in a loop structure. We experimentally demonstrate polarization-insensitive spatial light modulations for incident linearly polarized beams with different polarization states and polarization-multiplexed beams. Polarization-insensitive spatial light modulations generating orbital angular momentum (OAM) beams are demonstrated in the experiment. The designed polarization-insensitive configuration may find promising applications in spatial light modulations accommodating diverse incident polarizations.
| S-EPMC4491842 | biostudies-other