Browse
Submit Data
Databases
API
Help

Dataset Information

5 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Highly Sensitive Love Mode Acoustic Wave Platform with SiO₂ Wave-Guiding Layer and Gold Nanoparticles for Detection of Carcinoembryonic Antigens.

ABSTRACT: A highly sensitive and precise Love wave mode surface acoustic wave (SAW) immunosensor based on an ST-cut 90°X quartz substrate and an SiO₂ wave-guiding layer was developed to detect cancer-related biomarkers of carcinoembryonic antigens (CEAs). A delay line structure of the SAW device with a resonant frequency of 196 MHz was designed/fabricated, and its surface was functionalized through CEA antibody immobilization. The CEA antibodies were bound with gold nanoparticles and CEA antibodies to form a sandwich structure, which significantly amplified the mass loading effect and enhanced the maximum responses by 30 times. The center frequency of the Love wave immunosensor showed a linear response as a function of the CEA concentration in the range of 0.2-5 ng/mL. It showed a limit of detection of 0.2 ng/mL, and its coefficient of determination was 0.983. The sensor also showed minimal interference from nonspecific adsorptions, thus demonstrating its promise for point-of-care applications for cancer biomarkers.

SUBMITTER: Li C

PROVIDER: S-EPMC9313398 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Hybridized Love Waves in a Guiding Layer Supporting an Array of Plates with Decorative Endings.

Project description:This study follows from Maurel et al., Phys. Rev. B 98, 134311 (2018), where we reported on direct numerical observations of out-of-plane shear surface waves propagating along an array of plates atop a guiding layer, as a model for a forest of trees. We derived closed form dispersion relations using the homogenization procedure and investigated the effect of heterogeneities at the top of the plates (the foliage of trees). Here, we extend the study to the derivation of a homogenized model accounting for heterogeneities at both endings of the plates. The derivation is presented in the time domain, which allows for an energetic analysis of the effective problem. The effect of these heterogeneous endings on the properties of the surface waves is inspected for hard heterogeneities. It is shown that top heterogeneities affect the resonances of the plates, hence modifying the cut-off frequencies of a wave mathematically similar to the so-called Spoof Plasmon Polariton (SPP) wave, while the bottom heterogeneities affect the behavior of the layer, hence modifying the dispersion relation of the Love waves. The complete system simply mixes these two ingredients, resulting in hybrid surface waves accurately described by our model.

| S-EPMC7178394 | biostudies-literature

Li6SiO4Cl2: A Hexagonal Argyrodite Based on Antiperovskite Layer Stacking.

Project description:A hexagonal analogue, Li6SiO4Cl2, of the cubic lithium argyrodite family of solid electrolytes is isolated by a computation-experiment approach. We show that the argyrodite structure is equivalent to the cubic antiperovskite solid electrolyte structure through anion site and vacancy ordering within a cubic stacking of two close-packed layers. Construction of models that assemble these layers with the combination of hexagonal and cubic stacking motifs, both well known in the large family of perovskite structural variants, followed by energy minimization identifies Li6SiO4Cl2 as a stable candidate composition. Synthesis and structure determination demonstrate that the material adopts the predicted lithium site-ordered structure with a low lithium conductivity of ∼10-10 S cm-1 at room temperature and the predicted hexagonal argyrodite structure above an order-disorder transition at 469.3(1) K. This transition establishes dynamic Li site disorder analogous to that of cubic argyrodite solid electrolytes in hexagonal argyrodite Li6SiO4Cl2 and increases Li-ion mobility observed via NMR and AC impedance spectroscopy. The compositional flexibility of both argyrodite and perovskite alongside this newly established structural connection, which enables the use of hexagonal and cubic stacking motifs, identifies a wealth of unexplored chemistry significant to the field of solid electrolytes.

| S-EPMC8029579 | biostudies-literature

Diverse Functionalities of Vertically Stacked Graphene/Single layer n-MoS2/SiO2/p-GaN Heterostructures.

Project description:Integrating different dimentional materials on vertically stacked p-n hetero-junctions have facinated a considerable scrunity and can open up excellent feasibility with various functionalities in opto-electronic devices. Here, we demonstrate that vertically stacked p-GaN/SiO2/n-MoS2/Graphene heterostructures enable to exhibit prominent dual opto-electronic characteristics, including efficient photo-detection and light emission, which represents the emergence of a new class of devices. The photoresponsivity was found to achieve as high as ~10.4 AW-1 and the detectivity and external quantum efficiency were estimated to be 1.1?×?1010 Jones and ~30%, respectively. These values are superier than most reported hererojunction devices. In addition, this device exhibits as a self-powered photodetector, showing a high responsivity and fast response speed. Moreover, the device demonstrates the light emission with low turn-on voltage (~1.0?V) which can be realized by electron injection from graphene electrode and holes from GaN film into monolayer MoS2 layer. These results indicate that with a suitable choice of band alignment, the vertical stacking of materials with different dimentionalities could be significant potential for integration of highly efficient heterostructures and open up feasible pathways towards integrated nanoscale multi-functional optoelectronic devices for a variety of applications.

| S-EPMC5577265 | biostudies-literature

Oxygen Recombination Probability Data for Plasma-Assisted Atomic Layer Deposition of SiO2 and TiO2.

Project description:Atomic layer deposition (ALD) can provide nanometer-thin films with excellent conformality on demanding three-dimensional (3D) substrates. This also holds for plasma-assisted ALD, provided that the loss of reactive radicals through surface recombination is sufficiently low. In this work, we determine the surface recombination probability r of oxygen radicals during plasma ALD of SiO2 and TiO2 for substrate temperatures from 100 to ∼240 °C and plasma pressures from 12 to 130 mTorr (for SiO2). For both processes, the determined values of r are very low, i.e., ∼10-4 or lower, and decrease with temperature and pressure down to ∼10-5 within the studied ranges. Accordingly, deposition on trench structures with aspect ratios (ARs) of <200 is typically not significantly limited by recombination and obtaining excellent film conformality is relatively facile. For higher AR values, e.g., approaching 1000, the plasma time needed to reach saturation increases exponentially and becomes increasingly dependent on the process conditions and the corresponding value of r. Similar dependence on process conditions can be present for plasma ALD of other materials as well, where, in certain cases, film growth is already recombination-limited for AR values of ∼10. Radical recombination data and trends as provided by this work are valuable for optimizing plasma ALD throughput and feasibility for high-AR applications and can also serve as input for modeling of radical recombination mechanisms.

| S-EPMC8162759 | biostudies-literature

Facile synthesis of an aminopropylsilane layer on Si/SiO2 substrates using ethanol as APTES solvent.

Project description:(3-aminopropyl)triethoxysilane (APTES) is a commonly used organosilane on surface functionalization of silicon oxide surfaces. However, its deposition process from solution-phase usually involves the use of toluene, which has often been identified as crucial for the formation of an aminopropylsilane monolayer. Toluene is ranked as a problematic solvent in the guide developed by a group referred to as the solvent sub-team of CHEM21. In this work, we propose a facile synthetic route for functionalizing a silicon substrate with APTES via solution-phase approach using only solvents that are classified as recommended. The influence of the APTES concentration, reaction times and different post-deposition conditions using acetic acid and methanol were studied in order to evaluate the quality and thickness of the organosilane layers.•The method uses ethanol as APTES solvent for functionalizing silicon dioxide surfaces and only uses solvents classified as recommended.•The method uses a solution phase approach, does not require complicated equipment and can be prepared at room temperature.

| S-EPMC7276439 | biostudies-literature

Seebeck-voltage-triggered self-biased photoelectrochemical water splitting using HfOx/SiOx bi-layer protected Si photocathodes.

Project description:The use of a photoelectrochemical device is an efficient method of converting solar energy into hydrogen fuel via water splitting reactions. One of the best photoelectrode materials is Si, which absorbs a broad wavelength range of incident light and produces a high photocurrent level (~44?mA·cm-2). However, the maximum photovoltage that can be generated in single-junction Si devices (~0.75?V) is much lower than the voltage required for a water splitting reaction (>1.6?V). In addition, the Si surface is electrochemically oxidized or reduced when it comes into direct contact with the aqueous electrolyte. Here, we propose the hybridization of the photoelectrochemical device with a thermoelectric device, where the Seebeck voltage generated by the thermal energy triggers the self-biased water splitting reaction without compromising the photocurrent level at 42?mA?cm-2. In this hybrid device p-Si, where the surface is protected by HfOx/SiOx bilayers, is used as a photocathode. The HfOx exhibits high corrosion resistance and protection ability, thereby ensuring stability. On applying the Seebeck voltage, the tunneling barrier of HfOx is placed at a negligible energy level in the electron transfer from Si to the electrolyte, showing charge transfer kinetics independent of the HfOx thickness. These findings serve as a proof-of-concept of the stable and high-efficiency production of hydrogen fuel by the photoelectrochemical-thermoelectric hybrid devices.

| S-EPMC6591395 | biostudies-literature

Optical Optimization of the TiO2 Mesoporous Layer in Perovskite Solar Cells by the Addition of SiO2 Nanoparticles.

Project description:In this work, SiO2 nanoparticles (NPs) were integrated into the mesoporous TiO2 layer of a perovskite solar cell to investigate their effect on cell performance. Different concentrations of SiO2/ethanol have been combined in TiO2/ethanol to prepare pastes for the fabrication of the mesoporous layer with which perovskite solar cells have been fabricated. Addition of SiO2 NPs of 50 and 100 nm sizes produces an enhancement of cell performance mainly because of an improvement of the photocurrent. This increment is in good agreement with the theoretical predictions based on light scattering induced by dielectric SiO2 NPs. The samples using modified scaffolds with NPs also present a significant lower current-potential hysteresis indicating that NP incorporation also affects the ion accumulation at the perovskite interface, providing an additional beneficial effect. The results stress the importance of the appropriated management of the optical properties on further optimization of perovskite solar cell technology.

| S-EPMC6120728 | biostudies-literature

Controlled synthesis and luminescence properties of core-shell-shell structured SiO2@AIPA-S-Si-Eu@SiO2 and SiO2@AIPA-S-Si-Eu-phen@SiO2 nanocomposites.

Project description:Two novel core-shell structured SiO2@AIPA-S-Si-Eu and SiO2@AIPA-S-Si-Eu-phen nanocomposites have been synthesized by a bifunctional organic ligands ((HOOC)2C6H3NHCONH(CH2)3Si(OCH2CH3)3) (defined as AIPA-S-Si) connected with Eu3+ ions and silica via covalent bond. And the corresponding core-shell-shell structured SiO2@AIPA-S-Si-Eu@SiO2 and SiO2@AIPA-S-Si-Eu-phen@SiO2 nanocomposites with enhanced luminescence have been synthesized by tetraethyl orthosilicate (TEOS) hydrolysis co-deposition method. The composition and micromorphology of the nanocomposites were characterized by means of Fourier-transform infrared spectroscopy (FT-IR), thermal gravimetric analysis (TG), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy-dispersive X-ray spectrometry (EDX) and X-ray photoelectron spectroscopy (XPS). The as-synthesized core-shell and core-shell-shell structured nanocomposites have excellent luminescence intensity and long lifetime. The nanocomposites show bright red light under ultraviolet lamp. However, the core-shell-shell structured nanocomposites have stronger luminescence intensity than the corresponding core-shell structured nanocomposites. Meanwhile, the core-shell-shell structured nanocomposites still exhibit good luminescence stability in aqueous solution. In addition, a large number of Si-OH on the surface of the core-shell-shell structured nanocomposites can be attached to many biomacromolecules. Therefore, they have potential applications in the fields of biology and luminescence.

| S-EPMC7044297 | biostudies-literature

Scalable Epitaxial Growth of WSe2 Thin Films on SiO2/Si via a Self-Assembled PtSe2 Buffer Layer.

Project description:The growth of large-area epitaxial transition metal dichalgogenides (TMDCs) are of central importance for scalable integrated device applications. Different methods have been developed to achieve large-sized high quality films. However, reliable approaches for centimeter-sized or even wafer-level epitaxial growth of TMDCs are still lacking. Here we demonstrate a new method to grow inch-sized epitaxial WSe2 films on SiO2/Si substrates at a much lower temperature with high repeatability and scalability. High quality crystalline films are achieved through direct selenization of a tungsten film with platinum as the underlayer. The self-assembled PtSe2 buffer layer, formed during selenization, assists epitaxial growth of WSe2. Using fabricated WSe2 films, excellent performance memory devices are demonstrated. As a member of the TMDC family, our findings based on WSe2 may also be applied to other TMDC materials for large-scale production of high quality TMDC films for various applications.

| S-EPMC6541630 | biostudies-literature

Absence of 3a0 charge density wave order in the infinite-layer nickelate NdNiO2.

Project description:A hallmark of many unconventional superconductors is the presence of many-body interactions that give rise to broken-symmetry states intertwined with superconductivity. Recent resonant soft X-ray scattering experiments report commensurate 3a0 charge density wave order in infinite-layer nickelates, which has important implications regarding the universal interplay between charge order and superconductivity in both cuprates and nickelates. Here we present X-ray scattering and spectroscopy measurements on a series of NdNiO2+x samples, which reveal that the signatures of charge density wave order are absent in fully reduced, single-phase NdNiO2. The 3a0 superlattice peak instead originates from a partially reduced impurity phase where excess apical oxygens form ordered rows with three-unit-cell periodicity. The absence of any observable charge density wave order in NdNiO2 highlights a crucial difference between the phase diagrams of cuprate and nickelate superconductors.

| S-EPMC10990928 | biostudies-literature