Browse
Submit Data
Databases
API
Help

Dataset Information

29 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

A Novel Method to Measure the Static Coefficient of Friction for Socks.

ABSTRACT: Mechanical testers have commonly been used to measure the frictional properties of socks. However, the friction values may be susceptible to the level of stretchiness of tested fabrics or human variability. Thus, the aim of this study was to propose a novel method that enables friction measurement of socks in a sock-wearing condition with less human variability effects. Five socks with different frictional properties were chosen. Three experimental ramp tests were performed with an artificial structure shaped like the foot-ankle complex (last) and a ramp tester to quantify the static coefficient of friction (COF) at the foot against sock, at the sock against an insole, and the foot wearing socks against the insole, respectively. The angle where the last slipped while the ramp surface was gradually inclined was used to compute the static COF values for each sock. The reliability was 0.99, and COF values ranged from 0.271 to 0.861 at the foot-sock interface, 0.342 to 0.639 at the sock-insole interface, and 0.310 to 0.614 in the third test. Socks with different frictional properties were successfully distinguished each other. Thus, the suggested protocol could be a reliable option for measuring the static COF values in the tension similar with it found in a sock-waring condition with reduced effects of human variability.

SUBMITTER: Eun J

PROVIDER: S-EPMC9329795 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Static friction coefficient depends on the external pressure and block shape due to precursor slip.

Project description:Amontons' law states that the maximum static friction force on a solid object is proportional to the loading force and is independent of the apparent contact area. This law indicates that the static friction coefficient does not depend on the external pressure or object shape. Here, we numerically investigate the sliding motion of a 3D viscoelastic block on a rigid substrate using the finite element method (FEM). The macroscopic static friction coefficient decreases with an increase in the external pressure, length, or width of the object, which contradicts Amontons' law. Precursor slip occurs in the 2D interface between the block and substrate before bulk sliding. The decrease in the macroscopic static friction coefficient is scaled by the critical area of the precursor slip. A theoretical analysis of the simplified models reveals that bulk sliding results from the instability of the quasi-static precursor slip caused by velocity-weakening local friction. We also show that the critical slip area determines the macroscopic static friction coefficient, which explains the results of the FEM simulation.

| S-EPMC9925803 | biostudies-literature

Novel friction law for the static friction force based on local precursor slipping.

Project description:The sliding of a solid object on a solid substrate requires a shear force that is larger than the maximum static friction force. It is commonly believed that the maximum static friction force is proportional to the loading force and does not depend on the apparent contact area. The ratio of the maximum static friction force to the loading force is called the static friction coefficient µM, which is considered to be a constant. Here, we conduct experiments demonstrating that the static friction force of a slider on a substrate follows a novel friction law under certain conditions. The magnitude of µM decreases as the loading force increases or as the apparent contact area decreases. This behavior is caused by the slip of local precursors before the onset of bulk sliding and is consistent with recent theory. The results of this study will develop novel methods for static friction control.

| S-EPMC4159624 | biostudies-literature

Author Correction: Static friction coefficient depends on the external pressure and block shape due to precursor slip.

Project description: Not available

| S-EPMC10915153 | biostudies-literature

Friction coefficient dependence on electrostatic tribocharging.

Project description:Friction between dielectric surfaces produces patterns of fixed, stable electric charges that in turn contribute electrostatic components to surface interactions between the contacting solids. The literature presents a wealth of information on the electronic contributions to friction in metals and semiconductors but the effect of triboelectricity on friction coefficients of dielectrics is as yet poorly defined and understood. In this work, friction coefficients were measured on tribocharged polytetrafluoroethylene (PTFE), using three different techniques. As a result, friction coefficients at the macro- and nanoscales increase many-fold when PTFE surfaces are tribocharged, but this effect is eliminated by silanization of glass spheres rolling on PTFE. In conclusion, tribocharging may supersede all other contributions to macro- and nanoscale friction coefficients in PTFE and probably in other insulating polymers.

| S-EPMC3740278 | biostudies-literature

Data on the coefficient of static friction between surfaces coated with different sizes of rubber granules produced from used tires.

Project description:The data on the static friction coefficient (µ) resulting between a surface and a friction block covered with shredded rubber produced from used commercial tires at varying granule sizes are presented. The tests are done using different types of plates such as, glass, Poly Vinyl Chloride (PVC) plastics, wood, concrete, marble, ceramic and sand paper to represent rough and smooth surfaces in contact with shredded rubber granule of sizes 1.18 mm, 0.6 mm, 0.425 mm, 0.3 mm, and 0.15 mm. The coefficient of static friction is calculated using Coulomb׳s Law of dry friction and the data are compared based on the granule sizes variability. The data are represented in tables and figures. The data are in an almost uniform trend among the surfaces starting with a lower coefficient of friction for 1.18 mm to 0.6 mm, reached the highest at 0.425 mm and drops eventually as soon as the granules are finer.

| S-EPMC6355959 | biostudies-literature

Creasing in microscale, soft static friction.

Project description:Utilizing colloidal probe, lateral force microscopy and simultaneous confocal microscopy, combined with finite element analysis, we investigate how a microparticle starts moving laterally on a soft, adhesive surface. We find that the surface can form a self-contacting crease at the leading front, which results from a buildup of compressive stress. Experimentally, creases are observed on substrates that exhibit either high or low adhesion when measured in the normal direction, motivating the use of simulations to consider the role of adhesion energy and interfacial strength. Our simulations illustrate that the interfacial strength plays a dominating role in the nucleation of a crease. After the crease forms, it progresses through the contact zone in a Schallamach wave-like fashion. Interestingly, our results suggest that this Schallamach wave-like motion is facilitated by free slip at the adhesive, self-contacting interface within the crease.

| S-EPMC10126204 | biostudies-literature

A method to measure the partitioning coefficient of volatile organic compounds in nanoparticles.

Project description:The partitioning behavior of volatile organic compounds (VOCs) into nanoparticles is less studied compared to those of semivolatile organic compounds (SVOCs) because of the lower concentration of the VOCs that is expected to partition into particles. One challenge in measuring the accurate partition coefficient of VOCs is quantifying their low mass fraction that sorbed on nanoparticles and differentiating them from the high VOC concentrations present in the gas-phase. Systematically characterizing the partitioning coefficient at a specific environmental condition is also difficult when sampling in the field. During field sampling, thermal and non-thermal issues such as sampling artifacts and non-equilibrium conditions because of a dynamic environment often result in considerable variability in the measured partition coefficients. In this study, we developed a bench-scale system that can achieve precise control of the experimental condition (e.g., relative humidity, temperature, and particle composition) and allow us to measure the low concentration of 1,2-dichlorobenzene in the particles. A similar set up can be used to study the low mass fraction of other VOCs partitioning in nanoparticles. The detailed but uncomplicated system setup may assist other researchers that investigate the global fate and transport and health effects of VOCs.•A bench-scale system was built in the laboratory to study the gas-to-particle partitioning•Experimental conditions can be controlled and easily varied•The system enables the systematic study of a single environmental factor on the partitioning process.

| S-EPMC7476312 | biostudies-literature

Static and dynamic friction in sliding colloidal monolayers.

Project description:In a pioneer experiment, Bohlein et al. realized the controlled sliding of two-dimensional colloidal crystals over laser-generated periodic or quasi-periodic potentials. Here we present realistic simulations and arguments that besides reproducing the main experimentally observed features give a first theoretical demonstration of the potential impact of colloid sliding in nanotribology. The free motion of solitons and antisolitons in the sliding of hard incommensurate crystals is contrasted with the soliton-antisoliton pair nucleation at the large static friction threshold F(s) when the two lattices are commensurate and pinned. The frictional work directly extracted from particles' velocities can be analyzed as a function of classic tribological parameters, including speed, spacing, and amplitude of the periodic potential (representing, respectively, the mismatch of the sliding interface and the corrugation, or "load"). These and other features suggestive of further experiments and insights promote colloid sliding to a unique friction study instrument.

| S-EPMC3478638 | biostudies-literature

Negative friction coefficient in microscale graphite/mica layered heterojunctions.

Project description:The friction of a solid contact typically shows a positive dependence on normal load according to classic friction laws. A few exceptions were recently observed for nanoscale single-asperity contacts. Here, we report the experimental observation of negative friction coefficient in microscale monocrystalline heterojunctions at different temperatures. The results for the interface between graphite and muscovite mica heterojunction demonstrate a robust negative friction coefficient both in loading and unloading processes. Molecular dynamics simulations reveal that the underlying mechanism is a synergetic and nontrivial redistribution of water molecules at the interface, leading to larger density and more ordered structure of the confined subnanometer-thick water film. Our results are expected to be applicable to other hydrophilic van der Waals heterojunctions.

| S-EPMC7164938 | biostudies-literature

Biotribology of Synovial Cartilage: A New Method for Visualization of Lubricating Film and Simultaneous Measurement of the Friction Coefficient.

Project description:A healthy natural synovial joint is very important for painless active movement of the natural musculoskeletal system. The right functioning of natural synovial joints ensures well lubricated contact surfaces with a very low friction coefficient and wear of cartilage tissue. The present paper deals with a new method for visualization of lubricating film with simultaneous measurements of the friction coefficient. This can contribute to better understanding of lubricating film formation in a natural synovial joint. A newly developed device, a reciprocating tribometer, is used to allow for simultaneous measurement of friction forces with contact visualization by fluorescence microscopy. The software allowing for snaps processing and subsequent evaluation of fluorescence records is developed. The evaluation software and the follow-up evaluation procedure are also described. The experiments with cartilage samples and model synovial fluid are carried out, and the new software is applied to provide their evaluation. The primary results explaining a connection between lubrication and friction are presented. The results show a more significant impact of albumin proteins on the lubrication process, whereas its clusters create a more stable lubrication layer. A decreasing trend of protein cluster count, which corresponds to a decrease in the thickness of the lubrication film, is found in all experiments. The results highlight a deeper connection between the cartilage friction and the lubrication film formation, which allows for better understanding of the cartilage lubrication mechanism.

| S-EPMC7254223 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data