Acceleration of cardiac tissue simulation with graphic processing units.
Ontology highlight
ABSTRACT:
SUBMITTER: Sato D
PROVIDER: S-EPMC2734265 | biostudies-other | 2009 Sep
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Scalable units for building cardiac tissue are fabricated from biodegradable elastomeric polymers by pairwise stacking of heart-cell scaffolds with sinusoidal internal pore architectures and dedicated perfusable microvessels with rapidly degrading porous interfaces in a parallel flow configuration. This platform supports viable heart cells in vitro and, if validated in vivo, may aid in the regenerative repair of vascularized tissues.
| S-EPMC4245075 | biostudies-literature
Project description:Large-scale simulation of detailed computational models of neuronal microcircuits plays a prominent role in reproducing and predicting the dynamics of the microcircuits. To reconstruct a microcircuit, one must choose neuron and synapse models, placements, connectivity, and numerical simulation methods according to anatomical and physiological constraints. For reconstruction and refinement, it is useful to be able to replace one module easily while leaving the others as they are. One way to achieve this is via a scaffolding approach, in which a simulation code is built on independent modules for placements, connections, and network simulations. Owing to the modularity of functions, this approach enables researchers to improve the performance of the entire simulation by simply replacing a problematic module with an improved one. Casali et al. (2019) developed a spiking network model of the cerebellar microcircuit using this approach, and while it reproduces electrophysiological properties of cerebellar neurons, it takes too much computational time. Here, we followed this scaffolding approach and replaced the simulation module with an accelerated version on graphics processing units (GPUs). Our cerebellar scaffold model ran roughly 100 times faster than the original version. In fact, our model is able to run faster than real time, with good weak and strong scaling properties. To demonstrate an application of real-time simulation, we implemented synaptic plasticity mechanisms at parallel fiber-Purkinje cell synapses, and carried out simulation of behavioral experiments known as gain adaptation of optokinetic response. We confirmed that the computer simulation reproduced experimental findings while being completed in real time. Actually, a computer simulation for 2 s of the biological time completed within 750 ms. These results suggest that the scaffolding approach is a promising concept for gradual development and refactoring of simulation codes for large-scale elaborate microcircuits. Moreover, a real-time version of the cerebellar scaffold model, which is enabled by parallel computing technology owing to GPUs, may be useful for large-scale simulations and engineering applications that require real-time signal processing and motor control.
| S-EPMC8058369 | biostudies-literature
Project description:BackgroundNatural Orifice Transluminal Endoscopic Surgery (NOTES) provides an emerging surgical technique which usually needs a long learning curve for surgeons. Virtual reality (VR) medical simulators with vision and haptic feedback can usually offer an efficient and cost-effective alternative without risk to the traditional training approaches. Under this motivation, we developed the first virtual reality simulator for transvaginal cholecystectomy in NOTES (VTEST™).MethodsThis VR-based surgical simulator aims to simulate the hybrid NOTES of cholecystectomy. We use a 6DOF haptic device and a tracking sensor to construct the core hardware component of simulator. For software, an innovative approach based on the inner-spheres is presented to deform the organs in real time. To handle the frequent collision between soft tissue and surgical instruments, an adaptive collision detection method based on GPU is designed and implemented. To give a realistic visual performance of gallbladder fat tissue removal by cautery hook, a multi-layer hexahedral model is presented to simulate the electric dissection of fat tissue.ResultsFrom the experimental results, trainees can operate in real time with high degree of stability and fidelity. A preliminary study was also performed to evaluate the realism and the usefulness of this hybrid NOTES simulator.ConclusionsThis prototyped simulation system has been verified by surgeons through a pilot study. Some items of its visual performance and the utility were rated fairly high by the participants during testing. It exhibits the potential to improve the surgical skills of trainee and effectively shorten their learning curve.
| S-EPMC4837073 | biostudies-literature
Project description:The Gillespie Stochastic Simulation Algorithm (GSSA) and its variants are cornerstone techniques to simulate reaction kinetics in situations where the concentration of the reactant is too low to allow deterministic techniques such as differential equations. The inherent limitations of the GSSA include the time required for executing a single run and the need for multiple runs for parameter sweep exercises due to the stochastic nature of the simulation. Even very efficient variants of GSSA are prohibitively expensive to compute and perform parameter sweeps. Here we present a novel variant of the exact GSSA that is amenable to acceleration by using graphics processing units (GPUs). We parallelize the execution of a single realization across threads in a warp (fine-grained parallelism). A warp is a collection of threads that are executed synchronously on a single multi-processor. Warps executing in parallel on different multi-processors (coarse-grained parallelism) simultaneously generate multiple trajectories. Novel data-structures and algorithms reduce memory traffic, which is the bottleneck in computing the GSSA. Our benchmarks show an 8×-120× performance gain over various state-of-the-art serial algorithms when simulating different types of models.
| S-EPMC3494724 | biostudies-literature
Project description:We aim to assess the effectiveness of feedback-controlled resonant drift pacing as a method for low energy defibrillation. Antitachycardia pacing is the only low energy defibrillation approach to have gained clinical significance, but it is still suboptimal. Low energy defibrillation would avoid adverse side effects associated with high voltage shocks and allow the application of implantable cardioverter defibrillator (ICD) therapy, in cases where such therapy is not tolerated today. We present results of computer simulations of a bidomain model of cardiac tissue with human atrial ionic kinetics. Reentry was initiated and low energy shocks were applied with the same period as the reentry, using feedback to maintain resonance. We demonstrate that such stimulation can move the core of reentrant patterns, in the direction that depends on the location of the electrodes and the time delay in the feedback. Termination of reentry is achieved with shock strength one-order-of-magnitude weaker than in conventional single-shock defibrillation. We conclude that resonant drift pacing can terminate reentry at a fraction of the shock strength currently used for defibrillation and can potentially work where antitachycardia pacing fails, due to the feedback mechanisms. Success depends on a number of details that these numerical simulations have uncovered.
| S-EPMC3325128 | biostudies-literature
Project description:Many cardiac diseases coincide with changes in cell size and shape. One example of such a disease is cardiac hypertrophy. It is established that cardiac impulse propagation depends on the cell size, as well as other factors, but interrelations between conduction velocity (CV), cell size, and gap junction (GJ) conductance (g(GJ)) are complex. Furthermore, cardiac diseases are often accompanied by connexin (Cx) lateralization. To analyze the effects of cell size and Cx lateralization in cardiac disease, a two-dimensional computer simulation of ventricular myocytes based on the Luo-Rudy model was used. Control cells (80 μm/20 μm (length/diameter)), long cells (160 μm/20 μm), and wide cells (80 μm/40 μm) were simulated as was a redistribution of lateral GJs (constant lateral g(GJ) and increased lateral g(GJ)). CV in long cells showed high stability, i.e., it declined very slowly when g(GJ) was gradually reduced. Wide cells, however, were more affected by reduced g(GJ), resulting in early transition to discontinuous propagation and low CV. Conduction block occurred earlier in enlarged cells than in control cells due to increased cell capacitance. Increased lateral g(GJ) stabilized longitudinal CV, which was a result of two-dimensional effects during planar wave propagation. Therefore, Cx lateralization may compensate for cardiac inhomogeneities. High lateral g(GJ) and enhanced cell diameter increased the susceptibility to conduction block at tissue expansion, providing a substrate for arrhythmia.
| S-EPMC2965950 | biostudies-literature
Project description:Parabolic flights provide cost-effective, time-limited access to "weightless" or reduced gravity conditions, facilitating research and validation activities that complement infrequent and costly access to space. Although parabolic flights have been conducted for decades, reference acceleration profiles and processing methods are not widely available. Here we present a solution for collecting, analyzing, and classifying the altered gravity environments experienced during parabolic flights, which we validated during a Boeing 727-200F flight with 20 parabolas. All data and analysis code are freely available. Our solution can be integrated with diverse experimental designs, does not depend upon accelerometer orientation, and allows unsupervised classification of all phases of flight, providing a consistent and open-source approach to quantifying gravito-inertial accelerations (GIA), or g levels. As academic, governmental, and commercial use of space advances, data availability and validated processing methods will enable better planning, execution, and analysis of parabolic flight experiments, and thus facilitate future space activities.
| S-EPMC6081456 | biostudies-literature
Project description:During sprint acceleration, step length, step rate, ground contact, and airtime are key variables for coaches to guide the training process and technical development of their athletes. In the field, three of these variables are easily obtained with inertial measurement units (IMUs), but, unfortunately, valid estimates of step length with IMUs currently are limited to low speeds (<50% max). A simple method is proposed here to derive step length during maximal sprint acceleration, using IMUs on both feet and two timing gates only. Mono-exponential velocity-time functions are fitted to the 30-m (split) and 60-m times, which in combination with IMU-derived step durations yield estimates of step length. To validate this approach, sixteen well-trained athletes with IMUs on the insteps of both feet executed two 60-m maximal sprints, starting from a three-point position. As a reference, step lengths were determined from video data. The reference step lengths combined with IMU-derived step durations yielded a time series of step velocity that confirmed the appropriateness of a mono-exponential increase of step velocity (R2 ? 0.96). The comparison of estimated step lengths to reference measurements showed no significant difference (p > 0.05) and acceptable agreement (root mean square error, RMSE = 8.0 cm, bias ± Limits of Agreement = -0.15 ± 16 cm). Step length estimations further improved (RMSE = 5.7 cm, -0.16 ± 11 cm) after smoothing the original estimated step lengths with a third order polynomial function (R2 = 0.94 ± 0.04). In conclusion, during maximal sprint acceleration, acceptable estimates of stride and step length were obtained from IMU-derived step times and 30-m (split) and 60-m sprint times.
| S-EPMC6784208 | biostudies-literature
Project description:The recent availability of new, less expensive high-throughput DNA sequencing technologies has yielded a dramatic increase in the volume of sequence data that must be analyzed. These data are being generated for several purposes, including genotyping, genome resequencing, metagenomics, and de novo genome assembly projects. Sequence alignment programs such as MUMmer have proven essential for analysis of these data, but researchers will need ever faster, high-throughput alignment tools running on inexpensive hardware to keep up with new sequence technologies.This paper describes MUMmerGPU, an open-source high-throughput parallel pairwise local sequence alignment program that runs on commodity Graphics Processing Units (GPUs) in common workstations. MUMmerGPU uses the new Compute Unified Device Architecture (CUDA) from nVidia to align multiple query sequences against a single reference sequence stored as a suffix tree. By processing the queries in parallel on the highly parallel graphics card, MUMmerGPU achieves more than a 10-fold speedup over a serial CPU version of the sequence alignment kernel, and outperforms the exact alignment component of MUMmer on a high end CPU by 3.5-fold in total application time when aligning reads from recent sequencing projects using Solexa/Illumina, 454, and Sanger sequencing technologies.MUMmerGPU is a low cost, ultra-fast sequence alignment program designed to handle the increasing volume of data produced by new, high-throughput sequencing technologies. MUMmerGPU demonstrates that even memory-intensive applications can run significantly faster on the relatively low-cost GPU than on the CPU.
| S-EPMC2222658 | biostudies-literature
Project description:Fluorescent markers are widely used to protect banknotes, passports, and other documents. Verification of such documents relies upon visual assessment of the markers revealed by ultraviolet (UV) radiation. However, such an explicit approach is inappropriate in certain circumstances, e.g., when discretely checking people for marks left by a pepper gel thrower. The UV light and fluorescent light must not be visible in such applications, yet reliable detection of the markers must still be performed. This problem was successfully resolved using TRIZ methodology, which led to a patent application. The main idea of the solution is to use low-intensity time-variable UV light for illuminating an object and process the image of the object acquired by a camera to detect colour changes too small to be noticed with the naked eye. This paper describes how popular graphics editors such as Adobe Photoshop Elements were used to validate the system concept devised. Simulation experiments used images taken in both visible and UV light to assess the effectiveness and perceptibility of the detection process. The advantage of such validation comes from using commodity software and performing the experiments without access to a laboratory and without physical samples, which makes this approach especially suitable in pandemic times.
| S-EPMC8347455 | biostudies-literature