The electronic and optical properties of Eu/Si-codoped anatase TiO(2) photocatalyst.
Ontology highlight
ABSTRACT:
SUBMITTER: Lin Y
PROVIDER: S-EPMC3311668 | biostudies-other | 2012 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Pure TiO₂, Y-N single-doped and codoped TiO₂ powders and thin films deposited on glass beads were successfully prepared using dip-coating and sol-gel methods. The samples were analyzed using grazing angle X-ray diffraction (GXRD), Raman spectroscopy, time resolved luminescence, ground state diffuse reflectance absorption and scanning electron microscopy (SEM). According to the GXRD patterns and micro-Raman spectra, only the anatase form of TiO₂ was made evident. Ground state diffuse reflectance absorption studies showed that doping with N or codoping with N and Y led to an increase of the band gap. Laser induced luminescence analysis revealed a decrease in the recombination rate of the photogenerated holes and electrons. The photocatalytic activity of supported catalysts, toward the degradation of toluidine, revealed a meaningful enhancement upon codoping samples at a level of 2% (atomic ratio). The photocatalytic activity of the material and its reactivity can be attributed to a reduced, but significant, direct photoexcitation of the semiconductor by the halogen lamp, together with a charge-transfer-complex mechanism, or with the formation of surface oxygen vacancies by the N dopant atoms.
| S-EPMC5553417 | biostudies-other
Project description:Nanoprobes with multimodal functionality have attracted significant interest recently because of their potential applications in nanomedicine. This paper reports the successful development of lanthanide-doped Y₂O₃ nanoprobes for potential applications in optical and magnetic resonance (MR) imaging. The morphology, structural, and optical properties of these nanoprobes were characterized by transmission electron microscope (TEM), field emission scanning electron microscope (FESEM), X-ray diffraction (XRD), energy-dispersive X-ray (EDX), and photoluminescence (PL). The cytotoxicity test showed that the prepared lanthanide-doped Y₂O₃ nanoprobes have good biocompatibility. The obvious contrast enhancement in the T₁-weighted MR images suggested that these nanoprobes can be used as a positive contrast agent in MRI. In addition, the clear fluorescence images of the L-929 cells incubated with the nanoprobes highlight their potential for optical imaging. Overall, these results suggest that prepared lanthanide-doped Y₂O₃ nanoprobes can be used for simultaneous optical and MR imaging.
| S-EPMC5333020 | biostudies-literature
Project description:Octahedral anatase particles (OAPs) were modified with silver nanoparticles (NPs) by photodeposition method. The properties of OAPs influenced the properties of silver deposits, and thus the photocatalytic activity of the obtained silver-modified OAPs. Photocatalytic activities were tested under UV and vis irradiation for oxidative decomposition of acetic acid and oxidation of 2-propanol, respectively. The properties of silver-modified OAPs were investigated by XRD, STEM, DRS, XPS and time-resolved microwave conductivity (TRMC) method. It was found that electron traps (ETs) worked as nucleation sites for silver, resulting in formation of smaller silver NPs on smaller OAPs with larger content of ETs. The modification with silver resulted in enhanced photocatalytic activity under both UV and vis irradiation. It was found that larger crystallite size of silver NPs, and thus larger polydispersity of silver deposits resulted in broad and intense plasmon resonance peak causing enhanced visible activity. The correlation between photocatalytic activity and TRMC data, e.g., slower decay of TRMC signal for more active samples, allowed discussion on property-governed photocatalytic activities of silver-modified titania.
| S-EPMC5946688 | biostudies-other
Project description:Alkaline-earth metallic dopant can improve the performance of anatase TiO2 in photocatalysis and solar cells. Aiming to understand doping mechanisms, the dopant formation energies, electronic structures, and optical properties for Be, Mg, Ca, Sr, and Ba doped anatase TiO2 are investigated by using density functional theory calculations with the HSE06 and PBE functionals. By combining our results with those of previous studies, the HSE06 functional provides a better description of electronic structures. The calculated formation energies indicate that the substitution of a lattice Ti with an AEM atom is energetically favorable under O-rich growth conditions. The electronic structures suggest that, AEM dopants shift the valence bands (VBs) to higher energy, and the dopant-state energies for the cases of Ca, Sr, and Ba are quite higher than Fermi levels, while the Be and Mg dopants result into the spin polarized gap states near the top of VBs. The components of VBs and dopant-states support that the AEM dopants are active in inter-band transitions with lower energy excitations. As to optical properties, Ca/Sr/Ba are more effective than Be/Mg to enhance absorbance in visible region, but the Be/Mg are superior to Ca/Sr/Ba for the absorbance improvement in near-IR region.
| S-EPMC5455518 | biostudies-literature
Project description:Using density functional theory and the Hubbard U method, we investigated the geometric structure, electronic structure, and optical property of Al/Ga-codoped ZnO. A 3 × 3 × 3 ZnO supercell was used to construct Al- and Ga-monodoped ZnO structures and Al/Ga-codoped ZnO (AGZO) structures. All three structures showed n-type conduction, and the optical band gaps were larger than that of pure ZnO. For a given impurity concentration, Ga impurities contribute more free carriers than Al impurities in AGZO. However, the presence of Al impurities improves the transmittance. These results can theoretically explain the factors that influence the electrical and optical properties.
| S-EPMC5456706 | biostudies-other
Project description:Octahedral anatase particles (OAPs), prepared by ultrasonication-hydrothermal reaction (US-HT), were modified with 2 wt% of gold by photodeposition. Conditions of US-HT process such as durations of US and durations of HT were varied to obtain OAPs products different by physicochemical and morphological properties. Au/OAPs samples were characterized by X-ray diffraction (XRD), scanning transmission electron microscopy (STEM), X-ray photoelectron spectroscopy (XPS) and diffuse reflectance spectroscopy (DRS). The photocatalytic activity was tested under UV irradiation for decomposition of acetic acid (CO2 system) and dehydrogenation of methanol (H2 system) under aerobic and anaerobic conditions, respectively, and for oxidation of 2-propanol under visible light irradiation. Photodeposition of gold was very fast for all OAPs samples (0.5-10 min) under Ar atmosphere, and the clear correlation between the content of electron traps (ETs) and the induction period, during which nanoparticles (NPs) of gold are formed, indicates that ETs in titania samples are a key-factor for rapidity of gold photodeposition on titania surface. It was found that better morphology of titania (larger content of faceted particles) resulted in formation of larger gold NPs, while small gold NPs were deposited on structural defects. Modification of OAPs with gold NPs resulted in significant enhancement of photocatalytic activity, being e.g., 1.5 (CO2 system), 7.7 (H2 system), and even more than 40 under vis irradiation. It was found that both the properties of titania and gold are crucial for resultant photocatalytic activity, but a direct correlation between one structural/physical property and photocatalytic activity could not be obtained since all structural properties changed simultaneously when conditions of photocatalyst preparation (US-HT) were changed. Therefore, gold NPs of controlled sizes were deposited on OAPs product with the best morphology by modified photodeposition method. Clear correlation between photocatalytic activity under visible light and the size of gold NPs indicates that gold properties are decisive for visible light activity rather than titania properties. 3D-FDTD simulations confirm that an increase in the size of gold NPs results in extended surface areas with field enhancement.
| S-EPMC5327951 | biostudies-literature
Project description:In this data article, optical properties and impedance spectroscopy analyses were applied for the 5 μm-height pillar Si solar cells to analyzed the insight of the Si geometric effect (Yadav et al., 2017) [1]. The surface reflectance data measured for all Si pillar samples (Fixed height of 5 μm with varying width and period. Geometric features of Si pillars are summarized in Table 1) are presented. Statistical data after analysis are summarized in the table, to profile the integrated reflectance quantitatively. Impedance spectroscopy analyses of all the samples were performed to demonstrate the bias-dependent space charge region. Mott-Schottky investigation shows the enhancement of built-in potential values due to the pillar structures.
| S-EPMC5522911 | biostudies-literature
Project description:The electronic and optical response of Bernal stacked bilayer graphene with geometry modulation and gate voltage are studied. The broken symmetry in sublattices, one dimensional periodicity perpendicular to the domain wall and out-of-plane axis introduces substantial changes of wavefunctions, such as gapless topological protected states, standing waves with bonding and anti-bonding characteristics, rich structures in density of states and optical spectra. The wavefunctions present well-behaved standing waves in pure system and complicated node structures in geometry-modulated system. The optical absorption spectra show forbidden optical excitation channels, prominent asymmetric absorption peaks, and dramatic variations in absorption structures. These results provide that the geometry-modulated structure with tunable gate voltage could be used for electronic and optical manipulation in future graphene-based devices.
| S-EPMC6351665 | biostudies-literature
Project description:We report a systematic investigation on the electronic and optical properties of the smallest stable clusters of alkaline-earth metal fluorides, namely, MgF2, CaF2, SrF2, and BaF2. For these clusters, we perform density functional theory (DFT) and time-dependent DFT (TDDFT) calculations with a localized Gaussian basis set. For each molecule ((MF2) n , n = 1-3, M = Mg, Ca, Sr, Ba), we determine a series of molecular properties, namely, ground-state energies, fragmentation energies, electron affinities, ionization energies, fundamental energy gaps, optical absorption spectra, and exciton binding energies. We compare electronic and optical properties between clusters of different sizes with the same metal atom and between clusters of the same size with different metal atoms. From this analysis, it turns out that MgF2 clusters have distinguished ground-state and excited-state properties with respect to the other fluoride molecules. Sizeable reductions of the optical onset energies and a consistent increase of excitonic effects are observed for all clusters under study with respect to the corresponding bulk systems. Possible consequences of the present results are discussed with respect to applied and fundamental research.
| S-EPMC7288709 | biostudies-literature
Project description:In this paper, YF₃:Ho3+@TiO₂ core-shell nanomaterials were prepared by hydrolysis of tetra-n-butyl titanate (TBOT) using polyvinylpyrrolidone K-30 (PVP) as the coupling agent. Characterization methods including X-ray diffraction (XRD), transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS) under TEM, X-ray photoelectron spectroscopy (XPS), fluorescence spectrometry, ultraviolet-visible diffuse reflectance spectroscopy, and electron spin resonance (ESR) were used to characterize the properties and working mechanism of the prepared photocatalyst material. They indicated that the core phase YF₃ nanoparticles were successfully coated with a TiO₂ shell and the length of the composite was roughly 100 nm. The Ho3+ single-doped YF₃:Ho3+@TiO₂ displayed strong visible absorption peaks with wavelengths of 450, 537, and 644 nm, respectively. By selecting these three peaks as excitation wavelengths, we could observe 288 nm (⁵D₄→⁵I₈) ultraviolet emission, which confirmed that there was indeed an energy transfer from YF₃:Ho3+ to anatase TiO₂. In addition, this paper investigated the influences of different TBOT dosages on photocatalysis performance of the as-prepared photocatalyst material. Results showed that the YF₃:Ho3+@TiO₂ core-shell nanomaterial was an advanced visible-light-driven catalyst, which decomposed approximately 67% of rhodamine b (RhB) and 34.6% of phenol after 10 h of photocatalysis reaction. Compared with the blank experiment, the photocatalysis efficiency was significantly improved. Finally, the visible-light-responsive photocatalytic mechanism of YF₃:Ho3+@TiO₂ core-shell materials and the influencing factors of photocatalytic degradation were investigated to study the apparent kinetics, which provides a theoretical basis for improving the structural design and functions of this new type of catalytic material.
| S-EPMC5503396 | biostudies-other