An effective approach to improving low-cost GPS positioning accuracy in real-time navigation.
Ontology highlight
ABSTRACT:
SUBMITTER: Islam MR
PROVIDER: S-EPMC4099514 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The paper describes and presents a new calculation strategy for the determination of the aircraft's resultant position using the GPS (Global Positioning System) SPP (Single Point Positioning) code method. The paper developed a concept of using the weighted average model with the use of measuring weights to improve the quality of determination of the coordinates and accuracy of GPS SPP positioning. In this research, measurement weights were used as a function of the number of GPS satellites being tracked, and geometric PDOP (Position Dilution of Precision) coefficient. The calculations were made using navigation data recorded by two independent GPS receivers: Thales Mobile Mapper and Topcon HiPerPro. On the basis of the obtained results, it was found that the RMS (Root Mean Square) accuracy of positioning for XYZ geocentric coordinates was better than 1.2% to 33.7% for the weighted average method compared to a single GPS SPP solution. The proposed approach is therefore of practical application in air navigation to improve the quality of aircraft positioning.
| S-EPMC7506565 | biostudies-literature
Project description:Multi- system and multi-frequency are two key factors that determine the performance of precise point positioning. Both multi-frequency and multi-system lead to new biases, which are not solved systematically. This paper concentrates on mathematical models of biases, influences of these biases, and positioning performance analysis of different observation models. The biases comprise the inter-frequency clock bias in multi-frequency and the inter-system clock bias in multi-system. The former is the residual differential code biases (DCBs) from receiver clock and satellite clock and usually occurs at the third frequency, the latter is the deviation of the receiver clock errors in different systems. Unified mathematical models of the biases are presented by analyzing the general formula of observation equations. The influences of these biases are validated by experiments with corresponding observation models. Subsequently, the experiments, which are based on the data at five globally distributed stations in Multi-Global Navigation Satellite System (GNSS) Experiment (MGEX) on day of year 100, 2018, assess positioning performance of different observation models with combination of frequencies (dual-frequency or triple- frequency) and systems (BeiDou Navigation Satellite System (BDS) or Global Positioning System (GPS)). The results show that the performances of triple-frequency models are almost as the same level as the dual-frequency models. They provide scientific support for the triple-frequency ambiguity-fixed solution which has a better convergence characteristic than dual-frequency ambiguity-fixed solution. Furthermore, the biases are expressed as an unified form that gives an important and valuable reference for future research on multi-frequency and multi-system precise point positioning.
| S-EPMC6603533 | biostudies-literature
Project description:Although precise point positioning (PPP) is a well-established and promising technique with the use of precise satellite orbit and clock products, it costs a long convergence time to reach a centimeter-level positioning accuracy. The PPP with ambiguity resolution (PPP-AR) technique can improve convergence performance by resolving ambiguities after separating the fractional cycle bias (FCB). Now the FCB estimation is mainly realized by the regional or global operating reference station network. However, it does not work well in the areas where network resources are scarce. The contribution of this paper is to realize an ambiguity residual constraint-based PPP with partial ambiguity resolution (PPP-PARC) under no real-time network corrections to speed up the convergence, especially when the performance of the float solution is poor. More specifically, the update strategy of FCB estimation in a stand-alone receiver is proposed to realize the PPP-PAR. Thereafter, the solving process of FCB in a stand-alone receiver is summarized. Meanwhile, the influencing factors of the ambiguity success rate in the PPP-PAR without network corrections are analyzed. Meanwhile, the ambiguity residual constraint is added to adapt the particularity of the partial ambiguity-fixing without network corrections. Moreover, the positioning experiments with raw observation data at the Global Positioning System (GPS) globally distributed reference stations are conducted to determine the ambiguity residual threshold for post-processing and real-time scenarios. Finally, the positioning performance was verified by 22 GPS reference stations. The results show that convergence time is reduced by 15.8% and 26.4% in post-processing and real-time scenarios, respectively, when the float solution is unstable, compared with PPP using a float solution. However, if the float solution is stable, the PPP-PARC method has performance similar to the float solution. The method shows the significance of the PPP-PARC for future PPP applications in areas where network resource is deficient.
| S-EPMC7309117 | biostudies-literature
Project description:Real-time PCR is a widely used technique for quantification of gene expression. However, commercially available kits for real-time PCR are very expensive. The ongoing coronavirus pandemic has severely hampered the economy in a number of developing countries, resulting in a reduction in available research funding. The fallout of this will result in limiting educational institutes and small enterprises from using cutting edge biological techniques such as real-time PCR. Here, we report a cost-effective approach for preparing and assembling cDNA synthesis and real-time PCR mastermixes with similar efficiencies as commercially available kits. Our results thus demonstrate an alternative to commercially available kits.
| S-EPMC8626763 | biostudies-literature
Project description:Air pollution by various volatile organic compounds (VOC) is a matter of concern for us. So in this regard, designing real-time VOC responsive materials is gaining attention across the scientific community. In this present work, we have developed an inexpensive VOC sensor based on a Meisenheimer complex derived from picric acid and N,N'-dicyclohexylcarbodiimide. The sensor coated TLC plate was used as a sensor of potentially harmful VOCs. The sensor coated TLC plate looks deep red colored and does not show any fluorescence emission under 366 nm UV light. But in the presence of harmful volatile organic compounds like benzene, toluene, xylene, etc the sensor coated TLC plate becomes orange colored and it also shows strong yellow emission under 366 nm UV light. This property was utilized to detect the VOCs by fluorescence spectroscopy. The detection limit for various VOCs was found to be in the range of 0.7-9 ppm. To make the sensor user friendly, we have demonstrated a method where VOCs can be detected using a smartphone in real-time and also the setup is portable.
| S-EPMC7566110 | biostudies-literature
Project description:The world of satellite navigation is undergoing dramatic changes with the rapid development of multi-constellation Global Navigation Satellite Systems (GNSSs). At the moment more than 70 satellites are already in view, and about 120 satellites will be available once all four systems (BeiDou + Galileo + GLONASS + GPS) are fully deployed in the next few years. This will bring great opportunities and challenges for both scientific and engineering applications. In this paper we develop a four-system positioning model to make full use of all available observations from different GNSSs. The significant improvement of satellite visibility, spatial geometry, dilution of precision, convergence, accuracy, continuity and reliability that a combining utilization of multi-GNSS brings to precise positioning are carefully analyzed and evaluated, especially in constrained environments.
| S-EPMC4321187 | biostudies-other
Project description:Air pollution epidemiological studies are increasingly using global positioning system (GPS) to collect time-location data because they offer continuous tracking, high temporal resolution, and minimum reporting burden for participants. However, substantial uncertainties in the processing and classifying of raw GPS data create challenges for reliably characterizing time activity patterns. We developed and evaluated models to classify people's major time activity patterns from continuous GPS tracking data.We developed and evaluated two automated models to classify major time activity patterns (i.e., indoor, outdoor static, outdoor walking, and in-vehicle travel) based on GPS time activity data collected under free living conditions for 47 participants (N = 131 person-days) from the Harbor Communities Time Location Study (HCTLS) in 2008 and supplemental GPS data collected from three UC-Irvine research staff (N = 21 person-days) in 2010. Time activity patterns used for model development were manually classified by research staff using information from participant GPS recordings, activity logs, and follow-up interviews. We evaluated two models: (a) a rule-based model that developed user-defined rules based on time, speed, and spatial location, and (b) a random forest decision tree model.Indoor, outdoor static, outdoor walking and in-vehicle travel activities accounted for 82.7%, 6.1%, 3.2% and 7.2% of manually-classified time activities in the HCTLS dataset, respectively. The rule-based model classified indoor and in-vehicle travel periods reasonably well (Indoor: sensitivity > 91%, specificity > 80%, and precision > 96%; in-vehicle travel: sensitivity > 71%, specificity > 99%, and precision > 88%), but the performance was moderate for outdoor static and outdoor walking predictions. No striking differences in performance were observed between the rule-based and the random forest models. The random forest model was fast and easy to execute, but was likely less robust than the rule-based model under the condition of biased or poor quality training data.Our models can successfully identify indoor and in-vehicle travel points from the raw GPS data, but challenges remain in developing models to distinguish outdoor static points and walking. Accurate training data are essential in developing reliable models in classifying time-activity patterns.
| S-EPMC3256108 | biostudies-literature
Project description:Physical therapy is an important component of gait recovery for individuals with locomotor dysfunction. There is a growing body of evidence that suggests that incorporating a motor learning task through visual feedback of movement trajectory is a useful approach to facilitate therapeutic outcomes. Visual feedback is typically provided by recording the subject's limb movement patterns using a three-dimensional motion capture system and displaying it in real-time using customized software. However, this approach can seldom be used in the clinic because of the technical expertise required to operate this device and the cost involved in procuring a three-dimensional motion capture system. In this paper, we describe a low cost two-dimensional real-time motion tracking approach using a simple webcam and an image processing algorithm in LabVIEW Vision Assistant. We also evaluated the accuracy of this approach using a high precision robotic device (Lokomat) across various walking speeds. Further, the reliability and feasibility of real-time motion-tracking were evaluated in healthy human participants. The results indicated that the measurements from the webcam tracking approach were reliable and accurate. Experiments on human subjects also showed that participants could utilize the real-time kinematic feedback generated from this device to successfully perform a motor learning task while walking on a treadmill. These findings suggest that the webcam motion tracking approach is a feasible low cost solution to perform real-time movement analysis and training.
| S-EPMC4306621 | biostudies-literature
Project description:The accuracy of radiation delivery is increasingly important as radiotherapy technology continues to develop. The goal of this study was to evaluate intrafractional motion during intracranial radiosurgery and the relationship between motion change and treatment time.A total of 50 treatment records with 5988 images, all acquired during treatments with the CyberKnife Radiosurgery System, were retrospectively analyzed in this study. We measured translation and rotation motion including superior-inferior (SI), right-left (RL), anterior-posterior (AP), roll, tilt and yaw. All of the data was obtained during the first 45 minutes of treatment. The records were divided into 3 groups based on 15-min time intervals following the beginning of treatment: group A (0-15 min), group B (16-30 min) and group C (31-45 min). The mean deviations, systematic errors, random errors and margin for planning target volume (PTV) were calculated for each group.The mean deviations were less than 0.1 mm in all three translation directions in the first 15 minutes. Greater motion occurred with longer treatment times, especially in the SI direction. For the 3D vector, a time-dependent change was observed, from 0.34 mm to 0.77 mm (p=0.01). There was no significant correlation between the treatment time and deviations in the AP, LR and rotation axes. Longer treatment times were associated with increases in systematic error, but not in random error. The estimated PTV margin for groups A, B and C were 0.86 / 1.14 / 1.31 mm, 0.75 / 1.12 / 1.20 mm, and 0.43 / 0.54 / 0.81 mm in the SI, RL, and AP directions, respectively.During intracranial radiosurgery, a consistent increase in the positioning deviation over time was observed, especially in the SI direction. If treatment time is greater than 15 minutes, we recommend increasing the PTV margins to ensure treatment precision.
| S-EPMC4404334 | biostudies-other
Project description:A visual-inertial odometer is used to fuse the image information obtained by a vision sensor with the data measured by an inertial sensor and recover the motion track online in a global frame. However, in an indoor environment, geometric transformation, sparse features, illumination changes, blurring, and noise will occur, which will either cause a reduction in or failure of the positioning accuracy. To solve this problem, a map matching algorithm based on an indoor plane structure map is proposed to improve the positioning accuracy of the system; this algorithm was implemented using a conditional random field model. The output of the attitude information from the visual-inertial odometer was used as the input of the conditional random field model. The feature function between the attitude information and the expected value was established, and the maximum probabilistic value of the attitude was estimated. Finally, the closed-loop feedback correction of the visual-inertial system was carried out with the probabilistic attitude value. A number of experiments were designed to verify the feasibility and reliability of the positioning method proposed in this paper.
| S-EPMC7014500 | biostudies-literature