Supramolecular synergy in the boundary lubrication of synovial joints.
Ontology highlight
ABSTRACT:
SUBMITTER: Seror J
PROVIDER: S-EPMC4366511 | biostudies-other | 2015 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:ObjectiveTo compare equine synovial fluid (SF) from injured and control joints for cartilage boundary lubrication function; concentrations of the putative boundary lubricant molecules hyaluronan (HA), proteoglycan 4 (PRG4), and surface-active phospholipids (SAPLs); relationships between lubrication function and composition; and lubrication restoration by addition of HA.MethodsEquine SF from normal joints, joints with acute injury, and joints with chronic injury were analyzed for boundary lubrication of normal articular cartilage (kinetic friction coefficient [μ(kinetic) ]). Equine SF samples were analyzed for HA, PRG4, and SAPL concentrations and HA molecular weight distribution. The effect of the addition of HA, of different concentrations and molecular weight, on the μ(kinetic) of equine SF samples from normal joints and joints with acute injury was determined.ResultsThe μ(kinetic) of equine SF from joints with acute injury (0.036) was higher (+39%) than that of equine SF from normal joints (0.026). Compared to normal equine SF, SF from joints with acute injury had a lower HA concentration (-30%) of lower molecular weight forms, higher PRG4 concentration (+83%), and higher SAPL concentration (+144%). Equine SF from joints with chronic injury had μ(kinetic) , PRG4, and SAPL characteristics intermediate to those of equine SF from joints with acute injury and normal equine SF. Regression analysis revealed that the μ(kinetic) value decreased with increasing HA concentration in equine SF. The friction-reducing properties of HA alone improved with increasing concentration and molecular weight. The addition of high molecular weight HA (4,000 kd) to equine SF from joints with acute injury reduced the μ(kinetic) to a value near that of normal equine SF.ConclusionIn the acute postinjury stage, equine SF exhibits poor boundary lubrication properties, as indicated by a high μ(kinetic) . HA of diminished concentration and molecular weight may be the basis for this, and adding HA to deficient equine SF restored lubrication function.
| S-EPMC3424370 | biostudies-literature
Project description:Articular cartilage is a highly efficacious water-based tribological system that is optimized to provide low friction and wear protection at both low and high loads (pressures) and sliding velocities that must last over a lifetime. Although many different lubrication mechanisms have been proposed, it is becoming increasingly apparent that the tribological performance of cartilage cannot be attributed to a single mechanism acting alone but on the synergistic action of multiple "modes" of lubrication that are adapted to provide optimum lubrication as the normal loads, shear stresses, and rates change. Hyaluronic acid (HA) is abundant in cartilage and synovial fluid and widely thought to play a principal role in joint lubrication although this role remains unclear. HA is also known to complex readily with the glycoprotein lubricin (LUB) to form a cross-linked network that has also been shown to be critical to the wear prevention mechanism of joints. Friction experiments on porcine cartilage using the surface forces apparatus, and enzymatic digestion, reveal an "adaptive" role for an HA-LUB complex whereby, under compression, nominally free HA diffusing out of the cartilage becomes mechanically, i.e., physically, trapped at the interface by the increasingly constricted collagen pore network. The mechanically trapped HA-LUB complex now acts as an effective (chemically bound) "boundary lubricant"--reducing the friction force slightly but, more importantly, eliminating wear damage to the rubbing/shearing surfaces. This paper focuses on the contribution of HA in cartilage lubrication; however, the system as a whole requires both HA and LUB to function optimally under all conditions.
| S-EPMC3069150 | biostudies-literature
Project description:Using a surface force balance, normal and shear interactions have been measured between two atomically smooth surfaces coated with hyaluronan (HA), and with HA/aggrecan (Agg) complexes stabilized by cartilage link protein (LP). Such HA/Agg/LP complexes are the most abundant mobile macromolecular species permeating articular cartilage in synovial joints and have been conjectured to be present as boundary lubricants at its surface. The aim of the present study is to gain insight into the extremely efficient lubrication when two cartilage surfaces slide past each other in healthy joints, and in particular to elucidate the possible role in this of the HA/Agg/LP complexes. Within the range of our parameters, our results reveal that the HA/Agg/LP macromolecular surface complexes are much better boundary lubricants than HA alone, likely because of the higher level of hydration, due to the higher charge density, of the HA/Agg/LP layers with respect to the HA alone. However, the friction coefficients (?) associated with the mutual interactions and sliding of opposing HA/Agg/LP layers (? ? 0.01 up to pressure P of ca. 12 atm, increasing sharply at higher P) suggest that such complexes by themselves cannot account for the remarkable boundary lubrication observed in mammalian joints (up to P > 50 atm).
| S-EPMC3497856 | biostudies-literature
Project description:Synovial joint morphogenesis occurs through the condensation of mesenchymal cells into a non-cartilaginous region known as the interzone and the specification of progenitor cells that commit to the articular fate. Although several signaling molecules are expressed by the interzone, the mechanism is poorly understood. For treatments of cartilage injuries, it is critical to discover the presence of joint progenitor cells in adult tissues and their expression gene pattern. Potential stem cell niches have been found in different joint regions, such as the surface zone of articular cartilage, synovium, and groove of Ranvier. Inherited joint malformations as well as joint-degenerating conditions are often associated with other skeletal defects and may be seen as the failure of morphogenic factors to establish the correct microenvironment in cartilage and bone. Therefore, exploring how joints form can help us understand how cartilage and bone are damaged and develop drugs to reactivate this developing mechanism.
| S-EPMC4306636 | biostudies-literature
Project description:The fundamental questions of how lubricant molecules organize into a layered structure under nanometers confinement and what is the interplay between layering and friction are still not well answered in the field of nanotribology. While the phase transition of lubricants during a squeeze-out process under compression is a long-standing controversial debate (i.e., liquid-like to solid-like phase transition versus amorphous glass-like transition), recent different interpretations to the stick-slip friction of lubricants in boundary lubrication present new challenges in this field. We carry out molecular dynamics simulations of a model lubricant film (cyclohexane) confined between molecularly smooth surfaces (mica)--a prototypical model system studied in surface force apparatus or surface force balance experiments. Through fully atomistic simulations, we find that repulsive force between two solid surfaces starts at about seven lubricant layers (n = 7) and the lubricant film undergoes a sudden liquid-like to solid-like phase transition at n < 6 monolayers thickness. Shear of solidified lubricant films at three- or four-monolayer thickness results in stick-slip friction. The sliding friction simulation shows that instead of shear melting of the film during the slip of the surface, boundary slips at solid-lubricant interfaces happen, while the solidified structure of the lubricant film is well maintained during repeated stick-slip friction cycles. Moreover, no dilation of the lubricant film during the slip is observed, which is surprisingly consistent with recent surface force balance experimental measurements.
| S-EPMC6042126 | biostudies-literature
Project description:Surfaces can be slippery or sticky depending on surface chemistry and roughness. We demonstrate in atomistic simulations that regular and random slip patterns on a surface lead to pressure excursions within a lubricated contact that increase quadratically with decreasing contact separation. This is captured well by a simple hydrodynamic model including wall slip. We predict with this model that pressure changes for larger length scales and realistic frictional conditions can easily reach cavitation thresholds and significantly change the load-bearing capacity of a contact. Cavitation may therefore be the norm, not the exception, under boundary lubrication conditions.
| S-EPMC4820388 | biostudies-literature
Project description:Osteoarthritic joints contain lower-molecular-weight (MW) hyaluronan (hyaluronic acid, HA) than healthy joints. To understand the relevance of this HA size effect for joint lubrication, the friction and surface structure of cartilage-emulating surfaces with HA of different MWs were studied using a surface force balance (SFB) and atomic force microscopy (AFM). Gelatin (gel)-covered mica surfaces were coated with high-MW HA (HHA), medium-MW HA (MHA), or low-MW HA (LHA), and lipids of hydrogenated soy l-α-phosphatidylcholine (HSPC) in the form of small unilamellar vesicles, using a layer-by-layer assembly method. SFB results indicate that the gel-HHA-HSPC boundary layer provides very efficient lubrication, attributed to hydration lubrication at the phosphocholine headgroups exposed by the HA-attached lipids, with friction coefficients (COF) as low as 10-3-10-4 at contact stresses at least up to P = 120 atm. However, for the gel-MHA-HSPC and gel-LHA-HSPC surfaces, the friction, initially low, increases sharply at much lower pressures (up to 30-60 atm at most). This higher friction with the shorter chains may be due to their weaker total adhesion energy to the gelatin, where the attraction between the negatively charged HA and the weakly positively charged gelatin is attributed largely to counterion-release entropy. Thus, the complexes of LHA and MHA with the lubricating HSPC lipids are more easily removed by shear during sliding, especially at high stresses, than the HHA-HSPC complex, which is strongly adhered to gelatin. This is ultimately the reason for lower-pressure lubrication breakdown with the shorter polysaccharides. Our results provide molecular-level insight into why the decrease in HA molecular weight in osteoarthritic joints may be associated with higher friction at the articular cartilage surface, and may have relevance for treatments of osteoarthritis involving intra-articular HA injections.
| S-EPMC7556541 | biostudies-literature
Project description:PurposeApart from other risk factors, mechanical stress on joints can promote the development of osteoarthritis (OA), which can also affect the temporomandibular joint (TMJ), resulting in cartilage degeneration and synovitis. Synovial fibroblasts (SF) play an important role in upkeeping joint homeostasis and OA pathogenesis, but mechanical stress as a risk factor might act differently depending on the type of joint. We thus investigated the relative impact of mechanical stress on the gene expression pattern of SF from TMJs and knee joints to provide new insights into OA pathogenesis.MethodsPrimary SF isolated from TMJs and knee joints of mice were exposed to mechanical strain of varying magnitudes. Thereafter, the expression of marker genes of the extracellular matrix (ECM), inflammation and bone remodelling were analysed by quantitative real-time polymerase chain reaction (RT-qPCR).ResultsSF from the knee joints showed increased expression of genes associated with ECM remodelling, inflammation and bone remodelling after mechanical loading, whereas TMJ-derived SF showed reduced expression of genes associated with inflammation and bone remodelling. SF from the TMJ differed from knee-derived SF with regard to expression of ECM, inflammatory and osteoclastogenesis-promoting marker genes during mechanical strain.ConclusionsOsteoarthritis-related ECM remodelling markers experience almost no changes in strain-induced gene expression, whereas inflammation and bone remodelling processes seem to differ depending on synovial fibroblast origin. Our data indicate that risk factors for the development and progression of osteoarthritis such as mechanical overuse have a different pathological impact in the TMJ compared to the knee joint.
| S-EPMC9596579 | biostudies-literature
Project description:Directional transportation of objects has important applications from energy transfer and intelligent robots to biomedical devices. Although breakthroughs in liquid migration on 2D surfaces or 3D tubular devices have been achieved, realizing smooth/on-demand transportation of constrained solids within a 3D cavity environment under harsh pressurized environment still remains a daunting challenge, where strong interface friction force becomes the main obstacle restricting the movement of solids. Inspired by typical feeding mechanism in natural esophagus system which synergistically couples a lubricating mucosa surface with the peristaltic contraction deformation of the cavity, herein, this challenge is addressed by constructing an esophagus-inspired layered tubular actuator with a slippery inner surface and responsive hydrogel matrix to realize spherical solid propulsion by photo(thermo)-induced cavity deformation. The as-constructed tubular actuator containing Fe3 O4 nanoparticles exhibits local volumetric shrinkage upon NIR-irradiation, which can generate large hydrodynamic pressure and considerable mechanical extrusion force (Fdriving force ≈ 0.18 N) to overcome low interface friction force (ffriction force ≈ 0.03 N), enabling on-demand transportation of constrained (pressure: 0.103 MPa) spherical solids over a long distance in an arbitrary direction. This actuator is anticipated to be used as bionic medicine transportation devices or artificial in vitro esophagus simulation systems, for example, to help formula eating-related physiotherapy plans for patients and astronauts.
| S-EPMC8693057 | biostudies-literature
Project description:The present paper describes a facile synthesis method for nitrogen-doped reduced graphene oxide (N-rGO) and the application of N-rGO as an effective additive for improving the tribological properties of base oil. N-rGO has been characterized by different characterization techniques such as X-ray diffraction, scanning electron microscopy, transmission electron microscopy, X-ray photoelectron spectroscopy and Raman spectroscopy. N-rGO-based nanolubricants are prepared and their tribological properties are studied using a four-ball tester. The nanolubricants show excellent stability over a period of six months and a significant decrease in coefficient of friction (25%) for small amounts of N-rGO (3 mg/L). The improvement in tribological properties can be attributed to the sliding mechanism of N-rGO accompanied by the high mechanical strength of graphene. Further, the nanolubricant is prepared at large scale (700 liter) and field trials are carried out at one NTPC thermal plant in India. The implementation of the nanolubricant in an induced draft (ID) fan results in the remarkable decrease in the power consumption.
| S-EPMC5530610 | biostudies-literature