Fabrication of UV Photodetector on TiO2/Diamond Film.
Ontology highlight
ABSTRACT:
SUBMITTER: Liu Z
PROVIDER: S-EPMC4585841 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The fabrication of unique taper-ended GaN-Nanotowers structure based highly efficient ultraviolet photodetector is demonstrated. Hexagonally stacked, single crystalline GaN nanocolumnar structure (nanotowers) grown on AlN buffer layer exhibits higher photocurrent generation due to high quality nanotowers morphology and increased surface/volume ratio which significantly enhances its responsivity upon ultraviolet exposure leading to outstanding performance from the developed detection device. The fabricated detector display low dark current (~ 12 nA), high ILight/IDark ratio (> 104), fast time-correlated transient response (~ 433 µs) upon ultraviolet (325 nm) illumination. A high photoresponsivity of 2.47 A/W is achieved in self-powered mode of operation. The reason behind such high performance could be attributed to built-in electric field developed from a difference in Schottky barrier heights will be discussed in detail. While in photoconductive mode, the responsivity is observed to be 35.4 A/W @ - 3 V along with very high external quantum efficiency (~ 104%), lower noise equivalent power (~ 10-13 WHz-1/2) and excellent UV-Vis selectivity. Nanotower structure with lower strain and dislocations as well as reduced trap states cumulatively contributed to augmented performance from the device. The utilization of these GaN-Nanotower structures can potentially be useful towards the fabrication of energy-efficient ultraviolet photodetectors.
| S-EPMC8149650 | biostudies-literature
Project description:The two-dimensional layered semiconducting tungsten disulfide (WS2) film exhibits great promising prospects in the photoelectrical applications because of its unique photoelectrical conversion property. Herein, in this paper, we report the simple and scalable fabrication of homogeneous, large-size and transferable WS2 films with tens-of-nanometers thickness through magnetron sputtering and post annealing process. The produced WS2 films with low resistance (4.2 kΩ) are used to fabricate broadband sensitive photodetectors in the ultraviolet to visible region. The photodetectors exhibit excellent photoresponse properties, with a high responsivity of 53.3 A/W and a high detectivity of 1.22 × 10(11) Jones at 365 nm. The strategy reported paves new way towards the large scale growth of transferable high quality, uniform WS2 films for various important applications including high performance photodetectors, solar cell, photoelectrochemical cell and so on.
| S-EPMC4731746 | biostudies-other
Project description:The development of nano-enabled composite materials has led to a paradigm shift in the manufacture of high-performance nanocomposite membranes with enhanced permeation, thermo-mechanical, and antibacterial properties. The major challenges to the successful incorporation of nanoparticles (NPs) to polymer films are the severe aggregation of the NPs and the weak compatibility of NPs with polymers. These two phenomena lead to the formation of non-selective voids at the interface of the polymer and NPs, which adversely affect the separation performance of the membrane. To overcome these challenges, we have developed a new method for the fabrication of robust TFN reverse osmosis membranes. This approach relies on the simultaneous synthesis and surface functionalization of TiO2 NPs in an organic solvent (heptane) via biphasic solvothermal reaction. The resulting stable suspension of the TiO2 NPs in heptane was then utilized in the interfacial (in-situ) polymerization reaction where the NPs were entrapped within the matrix of the polyamide (PA) membrane. TiO2 NPs of 10?nm were effectively incorporated into the thin PA layer and improved the thermal stability and anti-biofouling properties of the resulting TFN membranes. These features make our synthesized membranes potential candidates for applications where the treatment of high-temperature streams containing biomaterials is desirable.
| S-EPMC5768769 | biostudies-literature
Project description:ZnO nanostructure-based photodetectors have a wide applications in many aspects, however, the response range of which are mainly restricted in the UV region dictated by its bandgap. Herein, UV-vis-NIR sensitive ZnO photodetectors consisting of ZnO nanowires (NW) array/PbS quantum dots (QDs) heterostructures are fabricated through modified electrospining method and an exchanging process. Besides wider response region compared to pure ZnO NWs based photodetectors, the heterostructures based photodetectors have faster response and recovery speed in UV range. Moreover, such photodetectors demonstrate good flexibility as well, which maintain almost constant performances under extreme (up to 180°) and repeat (up to 200 cycles) bending conditions in UV-vis-NIR range. Finally, this strategy is further verified on other kinds of 1D nanowires and 0D QDs, and similar enhancement on the performance of corresponding photodetecetors can be acquired, evidencing the universality of this strategy.
| S-EPMC5357981 | biostudies-literature
Project description:In order to evaluate the identification of genes and pathways, the global gene expression profiles were assessed in response to UV, TiO2 and UV+TiO2 on nematode, Caenorhabditis elegans. We performed whole genome DNA microarray experiments using age synchronized young adult C. elegans population exposed to UV, TiO2 and UV+TiO2 for 24h. We used whole genome microarrays to screen for global changed in C. elegans transcription profiles and with subsequent quantitative analysis conducted on selected genes.
2016-07-16 | GSE84441 | GEO
Project description:In order to evaluate the identification of genes and pathways, the global gene expression profiles were assessed in response to UV, TiO2 and UV+TiO2 on nematode, Caenorhabditis elegans. We performed whole genome DNA microarray experiments using age synchronized young adult C. elegans population exposed to UV, TiO2 and UV+TiO2 for 24h. We used whole genome microarrays to screen for global changed in C. elegans transcription profiles and with subsequent quantitative analysis conducted on selected genes. Young adults C. elegans were selected for RNA extraction and hybridization on Affymetrix microarrays.
2016-07-16 | E-GEOD-84441 | biostudies-arrayexpress
Project description:With the retention of many of the unrivaled properties of bulk diamond but in thin-film form, nanocrystalline diamond (NCD) has applications ranging from micro-/nano-electromechanical systems to tribological coatings. However, with Young's modulus, transparency, and thermal conductivity of films all dependent on the grain size and nondiamond content, compositional and structural analysis of the initial stages of diamond growth is required to optimize growth. Spectroscopic ellipsometry (SE) has therefore been applied to the characterization of 25-75 nm thick NCD samples atop nanodiamond-seeded silicon with a clear distinction between the nucleation and bulk growth regimes discernable. The resulting presence of an interfacial carbide and peak in nondiamond carbon content upon coalescence is correlated with Raman spectroscopy, whereas the surface roughness and microstructure are in accordance with values provided by atomic force microscopy. As such, SE is demonstrated to be a powerful technique for the characterization of the initial stages of growth and hence the optimization of seeding and nucleation within films to yield high-quality NCD.
| S-EPMC6645230 | biostudies-literature
Project description:The electronic properties of layered materials are directly determined based on their thicknesses. Remarkable progress has been carried out on synthesis of wafer-scale atomically molybdenum disulfide (MoS2) layers as a two-dimensional material in the past few years in order to transform them into commercial products. Although chemical/mechanical exfoliation techniques are used to obtain a high-quality monolayer of MoS2, the lack of suitable control in the thickness and the lateral size of the flakes restrict their benefits. As a result, a straightforward, effective, and reliable approach is widely demanded to achieve a large-area MoS2 flake with control in its thickness for optoelectronic applications. In this study, thick MoS2 flakes are obtained by a short-time bath sonication in dimethylformamide solvent, which are thinned with the aid of a sequential plasma etching process using H2, O2, and SF6 plasma. A comprehensive study has been carried out on MoS2 flakes based on scanning electron microscopy, atomic force microscopy, Raman, transmission electron microscopy, and X-ray photoelectron microscopy measurements, which ultimately leads to a two-cycle plasma thinning method. In this approach, H2 is used in the passivation step in the first subcycle, and O2/SF6 plasma acts as an etching step for removing the MoS2 layers in the second subcycle. Finally, we show that this technique can be enthusiastically used to fabricate MoS2-based photodetectors with a considerable photoresponsivity of 1.39 A/W and a response time of 0.45 s under laser excitation of 532 nm.
| S-EPMC6881830 | biostudies-literature
Project description:Recently, the environmental impacts of microplastics have received extensive attention owing to their accumulation in the environment. However, developing efficient technology for the control and purification of microplastics is still a big challenge. Herein, we investigated the photocatalytic degradation of typical microplastics such as polystyrene (PS) microspheres and polyethylene (PE) over TiO2 nanoparticle films under UV light irradiation. TiO2 nanoparticle film made with Triton X-100 showed complete mineralization (98.40%) of 400-nm PS in 12 h, while degradation for varying sizes of PS was also studied. PE degradation experiment presented a high photodegradation rate after 36 h. CO2 was found as the main end product. The degradation mechanism and intermediates were studied by in situ DRIFTS and HPPI-TOFMS, showing the generation of hydroxyl, carbonyl, and carbon-hydrogen groups during the photodegradation of PS. This study provides a green and cost-efficient strategy for the control of microplastics contamination in the environment.
| S-EPMC7358720 | biostudies-literature
Project description:In this research, natural rubber (NR)-TiO2 nanocomposites were developed for triboelectric nanogenerator (TENG) application to harvest mechanical energy into electrical energy. Rutile TiO2 nanoparticles were used as fillers in NR material to improve dielectric properties so as to enhance the energy conversion performance of the NR composite TENG. The effect of filler concentration on TENG performance of the NR-TiO2 composites was investigated. In addition, ball-milling method was employed to reduce the agglomeration of TiO2 nanoparticles in order to improve their dispersion in the NR film. It was found that the TENG performance was significantly enhanced due to the increased dielectric constant of the NR-TiO2 composite films fabricated from the ball-milled TiO2. The TENG, fabricated from the NR-TiO2 composite using 24 h ball-milled TiO2 at 0.5%wt, delivered the highest power density of 237 mW/m2, which was almost four times higher than that of pristine NR TENG. Furthermore, the applications of the fabricated NR-TiO2 TENG as a power source to operate portable electronics devices were also demonstrated.
| S-EPMC8271377 | biostudies-literature