Dataset Information

A new class of Cu/ZnO catalysts derived from zincian georgeite precursors prepared by co-precipitation.

ABSTRACT: Zincian georgeite, an amorphous copper-zinc hydroxycarbonate, has been prepared by co-precipitation using acetate salts and ammonium carbonate. Incorporation of zinc into the georgeite phase and mild ageing conditions inhibits crystallisation into zincian malachite or aurichalcite. This zincian georgeite precursor was used to prepare a Cu/ZnO catalyst, which exhibits a superior performance to a zincian malachite derived catalyst for methanol synthesis and the low temperature water-gas shift (LTS) reaction. Furthermore, the enhanced LTS activity and stability in comparison to that of a commercial Cu/ZnO/Al₂O₃ catalyst, indicates that the addition of alumina as a stabiliser may not be required for the zincian georgeite derived Cu/ZnO catalyst. The enhanced performance is partly attributed to the exclusion of alkali metals from the synthesis procedure, which are known to act as catalyst poisons. The effect of residual sodium on the microstructural properties of the catalyst precursor was investigated further from preparations using sodium carbonate.

SUBMITTER: Smith PJ

PROVIDER: S-EPMC5369406 | biostudies-literature | 2017 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

A new class of Cu/ZnO catalysts derived from zincian georgeite precursors prepared by co-precipitation.

Smith Paul J PJ Kondrat Simon A SA Chater Philip A PA Yeo Benjamin R BR Shaw Greg M GM Lu Li L Bartley Jonathan K JK Taylor Stuart H SH Spencer Michael S MS Kiely Christopher J CJ Kelly Gordon J GJ Park Colin W CW Hutchings Graham J GJ

Chemical science 20170103 3

Zincian georgeite, an amorphous copper-zinc hydroxycarbonate, has been prepared by co-precipitation using acetate salts and ammonium carbonate. Incorporation of zinc into the georgeite phase and mild ageing conditions inhibits crystallisation into zincian malachite or aurichalcite. This zincian georgeite precursor was used to prepare a Cu/ZnO catalyst, which exhibits a superior performance to a zincian malachite derived catalyst for methanol synthesis and the low temperature water-gas shift (LTS ...[more]

PMID: 28451351

Similar Datasets

Project description:The development of efficient catalysts is one of the main challenges in CO2 conversion to valuable chemicals and fuels. Herein, inspired by the knowledge of the thermocatalytic (TC) processes, Cu/ZnO and bare Cu catalysts enriched with Cu+1 were studied to convert CO2 via the electrocatalytic (EC) pathway. Integrating Cu with ZnO (a CO-generation catalyst) is a strategy explored in the EC CO2 reduction to reduce the kinetic barrier and enhance C-C coupling to obtain C2+ chemicals and energy carriers. Herein, ethanol was produced with the Cu/ZnO catalyst, reaching a productivity of about 5.27 mmol·gcat-1·h-1 in a liquid-phase configuration at ambient conditions. In contrast, bare copper preferentially produced C1 products like formate and methanol. During CO2 hydrogenation, a methanol selectivity close to 100% was achieved with the Cu/ZnO catalysts at 200 °C, a value that decreased at higher temperatures (i.e., 23% at 300 °C) because of thermodynamic limitations. The methanol productivity increased to approximately 1.4 mmol·gcat-1·h-1 at 300 °C. Ex situ characterizations after testing confirmed the potential of adding ZnO in Cu-based materials to stabilize the Cu1+/Cu0 interface at the electrocatalyst surface because of Zn and O enrichment by an amorphous zinc oxide matrix; while in the TC process, Cu0 and crystalline ZnO prevailed under CO2 hydrogenation conditions. It is envisioned that the lower *CO binding energy at the Cu0 catalyst surface in the TC process than in the Cu1+ present in the EC one leads to preferential CO and methanol production in the TC system. Instead, our EC results revealed that an optimum local CO production at the ZnO surface in tandem with a high amount of superficial Cu1+ + Cu0 species induces ethanol formation by ensuring an appropriate local amount of *CO intermediates and their further dimerization to generate C2+ products. Optimizing the ZnO loading on Cu is proposed to tune the catalyst surface properties and the formation of more reduced CO2 conversion products.

Dataset Information

A new class of Cu/ZnO catalysts derived from zincian georgeite precursors prepared by co-precipitation.

Publications

A new class of Cu/ZnO catalysts derived from zincian georgeite precursors prepared by co-precipitation.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets