Dataset Information

A high-temperature plugging system for offshore heavy oil thermal recovery.

ABSTRACT: There are many heavy oil reservoirs in offshore oilfields in China. Steam and multiple thermal fluid stimulation technologies are of increasing interest and have been applied to an increasing number of projects. During the stimulation or displacement of heavy oil reservoirs during thermal recovery, several factors, such as reservoir heterogeneity, are prone to cause channeling phenomena and affect the thermal recovery effect of steam stimulation. According to the unique requirements for the stimulation of multiple thermal fluids for offshore heavy oil, this study used transmission, blocking and relieving, heat resistance and a comprehensive evaluation of parallel sand tube experiments to conduct a screening evaluation of plugging systems for the stimulation of multiple thermal fluids, screen out a commonly used plugging agent in the current stage and propose corresponding guidance for the selection basis. The results show that foam, gel, foam gel and temperature-sensitive gel systems have a good transmission performance, whereas the oil sludge exhibits a poorer performance. The phenolic resin system exhibits great plugging properties, followed by oily sludge, temperature-sensitive gel, gel, foam gel and foam. Considering about washing resistance properties, phenolic resin system shows the best quality, followed by oily sludge and temperature-sensitive gel. The oily sludge system brings the best performance in plugging a high-permeability channel than phenolic resin gel and temperature-sensitive gel.

SUBMITTER: Liu Y

PROVIDER: S-EPMC6014645 | biostudies-literature | 2018

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

A high-temperature plugging system for offshore heavy oil thermal recovery.

Liu Yuyang Y Li Zhaoliang Z Pan Mao M

PloS one 20180622 6

There are many heavy oil reservoirs in offshore oilfields in China. Steam and multiple thermal fluid stimulation technologies are of increasing interest and have been applied to an increasing number of projects. During the stimulation or displacement of heavy oil reservoirs during thermal recovery, several factors, such as reservoir heterogeneity, are prone to cause channeling phenomena and affect the thermal recovery effect of steam stimulation. According to the unique requirements for the stim ...[more]

PMID: 29933409

Similar Datasets

Project description:Simple plugging of the high-permeability "thief zones" of oil reservoirs is the most plausible and also the most straightforwardly achievable approach to enhance sweep efficiency and oil recovery. Sporosarcina pasteurii is a representative microorganism with the ability to precipitate calcium carbonate (CaCO3) via enzymatic hydrolysis of urea in the presence of calcium ions. Microbially induced calcium carbonate precipitation (MICP) can cement and seal the granular and fractured media and thus can be used as a potential microbial plugging agent for the high-permeability zones of oil reservoirs. The following investigated the microscopic characteristics of MICP plugging and its efficacy in permeability reduction. The columns of near-spherical silica sand and angular silica sand with three separate granularities (40/60, 60/80, and 80/120 mesh) were used as artificial rock cores representing distinct pore sizes and pore characteristics to investigate the efficacy and microprocess of MICP plugging with different biotreatment periods. The results indicated that permeability is reduced significantly after only short periods of biotreatment. After eight cycles of MICP treatments, the permeability for each type of cores dropped by 54-90% of individual initial permeabilities. The measured CaCO3 content indicated that the decreasing rate in permeability with the increasing CaCO3 content experiences three contrasting stages, namely, slow decline, speedy decline, and plateauing. X-ray diffraction indicated that most of the generated CaCO3 crystals occur as vaterite with only a small amount of calcite. Imaging by scanning electron microscopy further revealed the microprocess of MICP plugging. Microorganisms first concentrate on the pore wall to secrete CaCO3, forming a thin and large uniform layer of CaCO3. Then, some nucleation sites of CaCO3 crystals will experience further preferential growth, resulting in large, dominant crystals that act as a plugging agent within the pore space. Compared to extracellular polymeric substances, which are currently the primary microbial plugging agent used to enhance sweep efficiency of oil reservoirs, bio-CaCO3 appears more effective in plugging in terms of its morphology, size, and growth characteristics.

Dataset Information

A high-temperature plugging system for offshore heavy oil thermal recovery.

Publications

A high-temperature plugging system for offshore heavy oil thermal recovery.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets