Affinity of Electrochemically Deposited Sol?Gel Silica Films towards Catecholamine Neurotransmitters.
Ontology highlight
ABSTRACT:
SUBMITTER: Porcel-Valenzuela M
PROVIDER: S-EPMC6412732 | biostudies-literature | 2019 Feb
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Current methods for the protection of metal surfaces utilize harsh chemical processes, such as organic paint or electro-plating, which are not environment-friendly and require extensive waste treatments. In this study, a two-step approach consisting of electrochemical assisted deposition (EAD) of an aqueous silane solution and a dip coating of a low surface energy silane for obtaining a superhydrophobic self-cleaning surface for the enhanced protection of copper substrate is presented. A porous and hierarchical micro-nanostructured silica basecoat (sol-gel) was first formed by EAD of a methyltriethoxysilane (MTES) precursor solution on a copper substrate. Then, a superhydrophobic top-coat (E-MTES/PFOTS) was prepared with 1H,1H,2H,2H-Perfluorooctyltriethoxysilane (PFOTS) for low surface energy. The superhydrophobic coating exhibited anti-stain properties against milk, cola, and oil, with contact angles of 151°, 151.5°, and 129°, respectively. The EAD deposition potential and duration were effective in controlling the microscopic morphology, surface roughness, and coating thickness. The E-MTES/PFOTS coatings exhibited chemical stability against acids, bases, and abrasion resistance by sandpaper. The proposed 2-layer coating system exhibited strong chemical bonding at the two interfaces and provided a brush-like surface morphology with long-lasting superhydrophobicity. The developed method would provide an environment-friendly and expedient process for uniform protective coatings on complex surfaces.
| S-EPMC9968140 | biostudies-literature
Project description:Amine-functionalized thin films are highly desirable technologies for analytical, material, and biochemistry applications. Current functionalization procedures can be costly, environmentally unfriendly, and require many synthetic steps. Here, we present an inexpensive and facile way to functionalize a silica thin film with a 25?000 MW branched polyethylenimine (BPEI), consistent with green chemistry principles. Using UV-vis spectroscopy and scanning electron microscopy, BPEI was determined to be loaded into the film at an approximately 0.5 M concentration, which is a 500× increase from the loading solution used. The films were also tested for copper(II) sequestration to assess their potential for heavy metal sequestration and showed a high loading capacity of 10 ± 6 mmol/g. Films proved to be reusable, using ethylenediaminetetraacetic acid to chelate copper and regenerate the films, with only a 6% reduction in the amount of copper(II) ions sequestered by the third use. The films also proved stable against leaching over the course of 1 week in solution, with less than 1% of the original BPEI lost under various storage conditions (i.e., storage in deionized (DI) water, storage in dilute BPEI solution, storage in DI water after annealing). These films show promise for multiple applications, from heavy metal sequestration to antifouling applications, while being inexpensive, facile, and environmentally friendly to synthesize. To our knowledge, this is the first time that BPEI has been doped into silica thin films.
| S-EPMC6854565 | biostudies-literature
Project description:Conjugated polymers such as poly(3,4-ethylenedioxythiphene) (PEDOT) are of interest for a variety of applications including interfaces between electronic biomedical devices and living tissue. The mechanical properties, strength, and adhesion of these materials to solid substrates are all vital for long-term applications. We have been developing methods to quantify the mechanical properties of conjugated polymer thin films. In this paper, the stiffness, strength and the interfacial shear strength (adhesion) of electrochemically deposited PEDOT and PEDOT-co-1,3,5-tri[2-(3,4-ethylene dioxythienyl)]-benzene (EPh) were studied. The estimated Young's modulus of the PEDOT films was 2.6±1.4GPa, and the strain to failure was around 2%. The tensile strength was measured to be 56±27MPa. The effective interfacial shear strength was estimated with a shear-lag model by measuring the crack spacing as a function of film thickness. For PEDOT on gold/palladium-coated hydrocarbon film substrates an interfacial shear strength of 0.7±0.3MPa was determined. The addition of 5mole% of a tri-functional EDOT crosslinker (EPh) increased the tensile strength of the films to 283±67MPa, while the strain to failure remained about the same (2%). The effective interfacial shear strength was increased to 2.4±0.6MPa.Statement of significanceThis paper describes methods for estimating the ultimate mechanical properties of electrochemically deposited conjugated polymer (here PEDOT and PEDOT copolymers) films. Of particular interest and novelty is our implementation of a cracking test to quantify the shear strength of the PEDOT thin films on these solid substrates. There is considerable interest in these materials as interfaces between biomedical devices and living tissue, however potential mechanisms and modes of failure are areas of continuing concern, and establishing methods to quantify the strengths of these interfaces are therefore of particular current interest. We are confident that these results will be useful to the broader biological materials community and are worthy of broader dissemination.
| S-EPMC4728054 | biostudies-literature
Project description:Ti-doped ZnO thin films were obtained with the aim of tailoring ZnO film bioadhesiveness and making the optoelectronic properties of ZnO materials transferable to biological environments. The films were prepared on silicon substrates by sol-gel spin-coating and subsequent annealing. A Ti-O segregation limits the ZnO crystallite growth and creates a buffer out-layer. Consequently, the Ti-doped ZnO presents slightly increased resistivity, which remains in the order of 10-3 Ω·cm. The strong biochemical interference of Zn2+ ions released from pure ZnO surfaces was evidenced by culturing Staphylococcus epidermidis with and without the Zn2+ coupling agent clioquinol. The Ti-doped ZnO surfaces showed a considerable increase of bacterial viability with respect to pure ZnO. Cell adhesion was assayed with human mesenchymal stem cells (hMSCs). Although hMSCs find difficulties to adhere to the pure ZnO surface, they progressively expand on the surface of ZnO when the Ti doping is increased. A preliminary microdevice has been built on the Si substrate with a ZnO film doped with 5% Ti. A one-dimensional micropattern with a zigzag structure shows the preference of hMSCs for adhesion on Ti-doped ZnO with respect to Si. The induced contrast of surface tension further induces a cell polarization effect on hMSCs. It is suggested that the presence of Ti-O covalent bonding on the doped surfaces provides a much more stable ground for bioadhesion. Such fouling behavior suggests an influence of Ti doping on film bioadhesiveness and sets the starting point for the selection of optimal materials for implantable optoelectronic devices.
| S-EPMC6682115 | biostudies-literature
Project description:In this article experimental data are presented for inorganic gel based smart window fabricated using silica sol-gel process. Parallel beam transmittances were measured as functions of voltages for samples fabricated with different concentrations of nitric acid. Spectroscopic transmittance data at different driving voltages for samples fabricated with different LC concentrations are shown. Transmittance spectra of the Si-Ti based gel-based-liquid-crystal (GDLC) device measured as different driving voltages were compared with those of PDLC. GDLC showed much lower operating voltages, 10-15 V, for on-state. Formation of the LC droplet in gelation process is illustrated. The methyl organic group surrounds LC droplets. Demonstration of GDLC based smart window showed the successful operation with low driving voltages. GDLC window shows clear color, even at off-state, compared with PDLC.
| S-EPMC5094103 | biostudies-literature
Project description:We have developed a method that for the first time allowed us to synthesize silica particles in 20 minutes using a sol-gel preparation. Therefore, it is critically important to understand the synthesis mechanism and kinetic behavior in order to achieve a higher degree of fine tuning ability during the synthesis. In this study, we have employed our ability to modulate the physical nature of the reaction medium from sol-gel to emulsion, which has allowed us to halt the reaction at a particular time; this has allowed us to precisely understand the mechanism and chemistry of the silica polymerization. The synthesis medium is kept quite simple with tetraethyl orthosilicate (TEOS) as a precursor in an equi-volumetric ethanol-water system and with sodium hydroxide as a catalyst. Synthesis is performed under ambient conditions at 20 °C for 20 minutes followed by phasing out of any unreacted TEOS and polysilicic acid chains via their emulsification with supersaturated water. We have also demonstrated that the developed particles with various sizes can be used as seeds for further particle growth and other applications. Luminol, a chemiluminescent molecule, has been entrapped successfully between the layers of silica and was demonstrated for the chemiluminescence of these particles.
| S-EPMC5137187 | biostudies-literature
Project description:Advancements in understanding and engineering of virus-based nanomaterials (VBNs) for biomedical applications motivate a need to explore the interfaces between VBNs and other biomedically-relevant chemistries and materials. While several strategies have been used to investigate some of these interfaces with promising initial results, including VBN-containing slow-release implants and VBN-activated bioceramic bone scaffolds, there remains a need to establish VBN-immobilized three dimensional materials that exhibit improved stability and diffusion characteristics for biosensing and other analyte-capture applications. Silica sol-gel chemistries have been researched for biomedical applications over several decades and are well understood; various cellular organisms and biomolecules (e.g., bacteria, algae, enzymes) have been immobilized in silica sol-gels to improve viability, activity, and form factor (i.e., ease of use). Here we present the immobilization of an antibody-binding VBN in silica sol-gel by pore confinement. We have shown that the resulting system is sufficiently diffuse to allow antibodies to migrate in and out of the matrix. We also show that the immobilized VBN is capable of antibody binding and elution functionality under different buffer conditions for multiple use cycles. The promising results of the VBN and silica sol-gel interface indicate a general applicability for VBN-based bioseparations and biosensing applications.
| S-EPMC8895542 | biostudies-literature
Project description:We describe a new approach to the fabrication of surface-enhanced Raman scattering (SERS) substrates using gold nanorod (GNR) nanopowders to prepare concentrated GNR sols, followed by their deposition on an opal-like photonic crystal (OPC) film formed on a silicon wafer. For comparative experiments, we also prepared GNR assemblies on plain silicon wafers. GNR-OPC substrates combine the increased specific surface, owing to the multilayer silicon nanosphere structure, and various spatial GNR configurations, including those with possible plasmonic hot spots. We demonstrate here the existence of the optimal OPC thickness and GNR deposition density for the maximal SERS effect. All other things being equal, the analytical integral SERS enhancement of the GNR-OPC substrates is higher than that of the thick, randomly oriented GNR assemblies on plain silicon wafers. Several ways to further optimize the strategy suggested are discussed.
| S-EPMC3664605 | biostudies-literature
Project description:A ternary phase-separation investigation of the ethyl silicate 40 (ES40) sol-gel process was conducted using ethanol and water as the solvent and hydrolysing agent, respectively. This oligomeric silica precursor underwent various degrees of phase separation behaviour in solution during the sol-gel reactions as a function of temperature and H2O/Si ratios. The solution composition within the immiscible region of the ES40 phase-separated system shows that the hydrolysis and condensation reactions decreased with decreasing reaction temperature. A mesoporous structure was obtained at low temperature due to weak drying forces from slow solvent evaporation on one hand and formation of unreacted ES40 cages in the other, which reduced network shrinkage and produced larger pores. This was attributed to the concentration of the reactive sites around the phase-separated interface, which enhanced the condensation and crosslinking. Contrary to dense silica structures obtained from sol-gel reactions in the miscible region, higher microporosity was produced via a phase-separated sol-gel system by using high H2O/Si ratios. This tailoring process facilitated further condensation reactions and crosslinking of silica chains, which coupled with stiffening of the network, made it more resistant to compression and densification.
| S-EPMC4585945 | biostudies-literature
Project description:Environmentally friendly protection coatings have obtained increasing attention for their use in wooden materials, which can be destroyed easily when exposed to outdoor environments. A series of silane sol coatings coordinated with Eu3+ was prepared by hydrolyzing silane compounds. The obtained luminescent coating with three-dimensional net structure showed excellent optical, anti-ultraviolet aging, and thermal stability. The hybrid silane-modified compound coating was well-distributed on the wood by Si-O bonds to prevent its removal. The compound coating could stave off the decomposition of wood by converting ultraviolet light into red light and a charring action can endow the wood with thermal stability at high temperature, demonstrating the improvement of fire resistance and radiation residence following prolonged exposure to ultraviolet light, proving its excellent anti-ultraviolet aging properties.
| S-EPMC7795870 | biostudies-literature